Question about 2007 Mercedes-Benz C230 Sedan

Open Question

2006 c230 check engine light - 2007 Mercedes-Benz C230 Sedan

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 4 Answers

SOURCE: check engine light is on

Hi klapperkiste,
First you will need a generic obd2 reader in order to see what codes are stored in the ecm. If I'm not mistaken autozone will check it for free and give you a code like P0453, P and 4 digits #s with this information you will know what area the trouble is located. Still some testing will need to be done in order to pinpoint the trouble. It is very important that you write down all the DTCs (diagnostic trouble code)s in order to find the solution to your problem.
The "Check Engine" light will turn on when emissions out of the tail pipe exceed 1.5 times the federal limit. Any number of thing can cause the light to come on and not show any driveability symptoms, a common cause is leaving the gas cap loose after a fill up. I hope find this information helpful, More information is needed on your part to go further in finding a solution to your problem.

Posted on Nov 23, 2008

co7196
  • 3433 Answers

SOURCE: check engine light is on..???

Either a dirty air filter or dirty/faulty MMaf sensor.

Posted on Sep 17, 2009

  • 14 Answers

SOURCE: Check engine light stays on. Car idles and shakes

sounds like you have a misfire my friend...take it to autozone to have the codes pulled and post them here

Posted on Apr 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 Mercedes-Benz c230 will not start


At 12.3 volts you are down to about 50 % of battery and if you are going to attempt to start it again the battery should be charged so the engine spins at a nice fast rate. Having said that have you checked for spark? Is there an ignition fuse?

And I would try the code analyzer. Nothing to lose and all to gain.

Sep 01, 2015 | Mercedes-Benz Cars & Trucks

1 Answer

What's the normal rpm while shifting gears on an automatic 2006 c230?


No such figure. Shift points can be near the redline RPM or just above idle, it depends on hard you press the gas pedal.

Mar 25, 2014 | 2007 Mercedes-Benz C230 Sedan

1 Answer

I have a 2007 MB c230 sport. changed the oil, cabin filter, and two air filters. drove it for 300 miles then as i got to my destination the check engine light came on. anyone know of what could be the...


Hello
When the service engine soon light (Also called the check engine light or engine management light) is turned on this is to alert you to the fact that Powertrain Control Module (computer) has detected a failure somewhere in the systems it controls you may not feel any difference in the way the engine runs, this can be the transmission or the engine or emission system, there are fault codes set in the modules memory for these faults. What needs to happen now is to have the powertrain control module scanned with a special tool called an OBD2 electronic engine control scanner or a OBD2 code reader. Once the code(s) are read then you must perform the diagnostics for each code and make the appropriate repairs based on the findings of the diagnosis that was performed, this is called doing "Pinpoint" testing.

Sep 13, 2012 | 2007 Mercedes-Benz C230 Sedan

1 Answer

Where is the MAP sensor located on Mercedes C230 2006?


Map sensor problems are more common on certain models. As far as engine computer sensor reliability this is one of the sensors that appear to be more reliable overall. But on a few models poor mounting location chosen by the factory may reduce its reliability.

You can use BMW scanner to check the problem

Jul 19, 2012 | 2006 Mercedes-Benz C-Class

1 Answer

When does the timing belt on a 2006 c230 mercedes need to be changed


I looked this up and the engine used in this car does not use a timing belt, it has a timing chain, they are only replaced if the engine is torn down to be rebuilt.

May 27, 2010 | 2007 Mercedes-Benz C230 Sedan

1 Answer

How to reset the service light on my 2006 c230 sport


disconnect the battery for 30 sec. then reconnect. this clears all trouble codes and will turn that light off.

May 01, 2010 | 2007 Mercedes-Benz C230 Sedan

1 Answer

Check engine light is on..???


Either a dirty air filter or dirty/faulty MMaf sensor.

Sep 17, 2009 | 2007 Mercedes-Benz C230 Sedan

Not finding what you are looking for?
2007 Mercedes-Benz C230 Sedan Logo

Related Topics:

282 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...