Question about 2004 Chrysler Pacifica

Open Question

Chrysler Pacifica check engine light - code P2096

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 109 Answers

SOURCE: my check engine light came on and i pulled the

P0732 trans code, if this is a stand alone code, access someone with a chrysler scanner and monitor the trans speed sensors, preferbably the input one, make sure there is a rpm readings on both when you drive the vehicle, if ok, do a 2nd gear clutch test, if failed, internal clutch failure, if ok, replace the trans soleniod pack, it has internal failure, easy to change on this model with the 41TE trans only, if 62TE, take it to a Chrysler dealer.
GOOD LUCK, RDJRP

Posted on Feb 22, 2010

Ad
  • 1 Answer

SOURCE: check engine light comes on. odb2 code P2096 What does it mean

my 05 town & country check engine light stays on & is idling real bad, how do i idle my van

Posted on May 01, 2010

  • 323 Answers

SOURCE: Check Engine Light

If the light isn't flashing, it is safe to drive. If it is flashing, then catalytic converter damage can result. Have a parts store check the codes for you and come back and post the code.

Posted on May 01, 2009

  • 97 Answers

SOURCE: 2004 chrysler pacifica check engine light code

The codes are both evap system codes. The only good way to find the leaks is to take it to a shop that has a smoke machine. They will pump smoke into the evap system to find the leak.

Posted on Jan 27, 2010

lindsay836
  • 677 Answers

SOURCE: starts to vibrate while driving, check engine

The reason your check engine light comes on is that the system is letting you know there is a problem, and it SHOULD be stored so that a hook up to a OBD II reader will locate the code.
The only way you are going to get a burning oil smell is to have engine oil dripping on to a hot surface like an exhaust manifold or pipe.
Check for oil leaks at manifold, valve cover gaskets ect.
How long does it run again after it stalls ?

Posted on Feb 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Whats the codes p0685 an p0688 on a 2004 chrysler pacifica mean


P0685 CHRYSLER - Auto Shutdown Relay Control Circuit Failure

Short or open in Auto Shutdown (ASD) relay circuit
Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
Possible Causes
- ASD relay circuit is open or shorted
- Failed Auto Shutdown relay
- Failed ECM
Tech Notes
Check all the ECM fuses, if the fuses are OK try replacing the ASD relay.

P0688 CHRYSLER - Auto Shutdown Relay Control Circuit Low

The Front Control Module (FCM) has detected the supply voltage below an acceptable value
Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
Possible Causes
- ASD relay circuit is open or shorted
- Failed Auto Shutdown relay
- Failed ECM
Tech Notes
Check all the ECM fuses, if the fuses are OK try replacing the ASD relay.

Dec 29, 2014 | 2004 Chrysler Pacifica

2 Answers

P0420 p0522 chrysler pacifica CODES


thje po420 need to monitor o2 sensors to verify if you have a bad sensor or bad catalitic converter
the po522 oil presure sending unit

Oct 15, 2014 | 2005 Chrysler Pacifica

1 Answer

I have a 2004 Chrysler Pacifica and need to change the O2 sensors. These are the OBD codes I am getting when my check engine light came on. P2096 P0137. What I am trying to figure out is which is bank 1 on...


bank 1 cyl 1 if 02 sensor fault is present replace both sensors with oe part as sometimes after market sensors may not be compatible.both sensors because 1 will be week and will cause the same failure later provided the cat is ok and does not store a cat efficiency fault.

Sep 27, 2013 | 2004 Chrysler Pacifica

1 Answer

Chrysler pt cruiser code p2096


Trouble Code: P2096

Downstream Fuel System 1/2 Lean

Trouble Code Conditions: Engine running in closed loop mode. Ambient/battery temperature above 20F (-7C). Altitude below 8500 feet. Fuel level is more than 15%. If the PCM adds downstream short-term compensation to long-term adaptive, and a certain percentage is exceeded for 2 trips, a freeze frame is stored, the MIL illuminates and a DTC is set.

Possible Causes:


Exhaust leakEngine mechanical problemO2 Sensor has failedO2 Sensor signal circuit or return circuit problemFuel contamination

Jan 29, 2013 | Chrysler Cars & Trucks

1 Answer

2004 chrysler pacifica struggles to get to 40 mph and engine has loud whistle when over 1500 rpm


Is the check engine light on, and have you checked the computer for trouble codes ?
Is there a large vac leak on the hose between the throttle body and the air cleaner, or the intake?
Is the exhaust system plugged up ?
Is the EGR system working ?

Jan 07, 2013 | 2004 Chrysler Pacifica

1 Answer

What the code for a 2005 pacifica internal control module? My check engine light is staying on also.


internal control module? thats a new one for me. you need to have you obd2 scanned to find out what the trouble code it (thats why your check engine light is on)

Mar 13, 2012 | 2005 Chrysler Pacifica

1 Answer

2007 Chrysler Pacifica having intermittent fuel gauge problems. Goes from normal to dead/ low fuel. Has full tank. Also, check engine light is on.


2007 Chrysler Pacifica having intermittent fuel gauge problems. Goes from normal to dead/ low fuel. Has full tank. Also, check engine light is on

Oct 29, 2010 | 2006 Chrysler Pacifica

2 Answers

Check engine light comes on. odb2 code P2096 What does it mean


WHAT EXACTLY MEANS THE CODE P2096 AND HOW I SHOULD FIX IT CRYSLER 300 2010

Apr 24, 2010 | 2005 Chrysler Town & Country

1 Answer

2004 chrysler pacifica check engine light code p0442,0456 where do I start was in shop for a week still not fixed.


The codes are both evap system codes. The only good way to find the leaks is to take it to a shop that has a smoke machine. They will pump smoke into the evap system to find the leak.

Jan 27, 2010 | 2004 Chrysler Pacifica

2 Answers

Check Engine Light


If the light isn't flashing, it is safe to drive. If it is flashing, then catalytic converter damage can result. Have a parts store check the codes for you and come back and post the code.

May 01, 2009 | 2004 Chrysler Pacifica

Not finding what you are looking for?
2004 Chrysler Pacifica Logo

Related Topics:

693 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8582 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...