Question about 2000 Hyundai Sonata

1 Answer

Serpentin belt keeps slipping off the ac pump

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Hyundai Master
  • 5,370 Answers

Below is the master help link provided to go through belt routing diagram:---Timing belt, drive belt, serpentine belt, accessory belt, fan belt, engine belt routing diagrams for all types of car models?
Click the link below: ----

http://carbeltrouting.blogspot.in/2012/02/timing-beltdrive-beltserpentine.html
----------This will help. Thanks.

Posted on Feb 19, 2012

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What would make the serpentine belt keep slipping off


Failed Water Pump

Crankshaft Damper Worn

Failed Belt Tensioner

Failed bearings in any accy

Aug 16, 2014 | Cars & Trucks

1 Answer

Serpentine belt 1999 chevy malibu is slipping off cranshaft pulley


Make sure that the belt is fully seated in ALL pulleys, if it still slips off, then you have a pully that is bent, or out of alignment.

Dec 04, 2013 | 1999 Chevrolet Malibu

1 Answer

Serpentine belt keeps popping/slipping off


The power steering pump pulley must be flushed with the power steering pump shaft,Or else you will have noise or slips right off.12_11_2012_4_28_42_am.gif

Dec 11, 2012 | 1997 Ford Windstar

1 Answer

The serpentine belt on my 1984 Buick Lesabre keeps breaking when turn on air conditioner or heater why?


Most likely you have a seized AC compressor. When you ask for AC or heat the AC clutch engages with the pulley wheel that normally spins freely when the AC is off. As the pulley wheel is no longer able to turn because of the seized compressor the belt will either slip or snap.

Sep 20, 2011 | 1984 Buick LeSabre

1 Answer

Squalling sound when ac turned on then stops sound after a few min


Sounds like the fan belt or serpentine belt is slipping ,get a spray bottle put a little dish soap in it
and mix with water, spray on fan belt, now start the car and turn on your ac, if the noise goes away
you need to replace your fan belt or serpentine belt, if the noise persists, you may have a bad
tensioner pulley. good luck!

Aug 03, 2011 | Lexus ES 300 Cars & Trucks

1 Answer

How to replace a water pump on a 2004 dodge cummins motor, 3500 4x4 dulley


Replacing the water pump on my 2004 5.9 cummins 1ton Dually was easy,Disconnect neg. batt. cables, drain coolant,released serpentine belt tensioner with 1/2" drive ratchet and while in released position slipped belt from ac compressor,removed two bolts that held alt. to brackets, slipped alt. to one side then removed upper alt. brkt., removed two bolts on water pump, made sure mounting surface of block was clean and took new water pump put a small amt. of rtv sealant all around groove that rubber seals goes in,install rubber seal, "be sure and wipe off excess sealant then re-install water pump tightening carefully,reinstall alt. upper brkt., then alt. put belt back in correct position but be sure and leave it off of ac pulley so you can reinstall it on ac when you are underneath the eng. area while releasing tension on belt tensioner. Fill with proper coolant type till you have rad. full. Reinstall cables, start eng and with cap off you will have to add coolant as eng. warms up till it has air out of system. Once rad. is full install cap then refill coolant recovery bottle to full level, Keep and eye on it for leaks for a couple of days and "Happy Driving" Don't think I left anything out :)

Feb 24, 2011 | Dodge Ram Pickup 3500 Cars & Trucks

2 Answers

The belt sound when start the car


this will be your alternator belt, all you need to do is get a tention bar and undo the holding bolt and put tention on the alternator and then tighten up the belt, this will get rid of the noise

Apr 26, 2010 | 2003 Kia Spectra

1 Answer

Air conditioner pump slips on serpentine belt when activated


see if that vehicle came without A/C. If so ck for the belt availability and see if it can be put od bypassing the compressor. At the least, disconnect the compressor clutch wirin g so the A/C will not function at all. until you can manage a the cost of a pump. Good luck, Ned

Sep 24, 2009 | 2000 Volkswagen GTI

1 Answer

Serpentine belt diagram needed


i got a 1990 dodge daytona shelby with a 2.5 turbo there are 3 belts one is for the alt and water pump one is ps pump one is ac here is a link to some info and a diagram http://www.turbododge.com/forums/f4/f14/176277-alternator-belt-tensioner.html

hope this help keep that daytona runing it a good car o look on the hood there should be one on there

Jun 09, 2009 | 1990 Dodge Daytona

1 Answer

Running hard


You may need a new serpentine belt tensioner. That's the part that keeps the belts tight. If it's weak, it may be allowing the belt to slip. When you say the car runs "hard" what exactly do you mean? That the RPMs dip down when you turn on the AC? If so, that's normal since the AC compressor loads the engine pretty heavily. If you mean something else by it, please repost and clarify what you're seeing/hearing so we can take it from there.

Aug 07, 2008 | 1998 Plymouth Neon

Not finding what you are looking for?
2000 Hyundai Sonata Logo

472 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...