Question about 2005 Acura TL

Open Question

Change bulb on side marker light on 2004 Acura TL

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 14 Answers

SOURCE: how to change spark plugs on 2005 acura tl

Hi,

you need a 6 inch extension, short 3/8 ratchet, 5/8 plug socket, 3/8 swivel "u" joint, (sold at sears) 8mm 1/4 drive socket deep well and 1/4 inch ratchet.

find the coil packs (6 total, three in each head.)
remove the two retaining nuts holding each coil pack using 1/4 8mm socket and ratchet.
twist the pack to break the sticking boot below.
pull up (be careful to not rip the boots however it may still happen but rare.)
remove coil packs, the rear is a little more difficult with the intake.
use 6" extension and u joint and ratchet to remove plugs and replace.
reverse order to assemble. Good luck, and hoped this helped.

Posted on Jan 04, 2009

  • 4 Answers

SOURCE: trying to replace a front headlight bulb on 2001 acura 3.2 TL

Look for the end of the wire retainer clip. Unhook it and lift it up. Remember not to touch the bulb. But if you do, just clean it with a bit of alcohol.

btw - Here's a bit of info from a previous post of mine...
The low beams consist of three parts. The bulb, inverter/ballast and the ignitor. The bulbs usually start to loose their color long before they burn out. The inverters/ballasts either go out after a while or take a while to start up.

Before you spend money on a new bulb, try swapping it with the one on the other side. You'll need a security torx screwdriver to get the covers off of the back of the lights. Don't touch the glass bulbs. If you do, just clean them with a bit of alcohol.

If the problem stays on that side, try swapping the ignitors. They're mounted inside the black covers.

If the problem is still on that side you've got a bad inverter. They're mounted on the bottom of the headlight assembly. You'll need to remove the front bumper and remove the headlight assembly to get to it. (I recommend you take pictures as you remove things so can put them back together correctly.)

Posted on Jan 05, 2009

jpstuhr
  • 49 Answers

SOURCE: Replacing HID headlight in 2004 Acura TL

HID Bulb Replacement

A transient high tension (25,000 V ) occurs at the bulb sockets of the high intensity discharge (HID) lamps when the combination light switch is turned ON, it may cause serious electrical shock or electrocution if you do not observe the cautions below.

CAUTION:

  • Never turn on the combination light switch before fitting the HID bulbs to their bulb sockets and completing the reassembly of the headlight assembly.
  • Do not service the headlights assembly in wet conditions, such as rain or snow, near a sprinkler system, or when your hands are wet to prevent electrocution.
  • Do not touch the surface of the HID bulbs with your bare hands and do not stain it with any oils and fats.
  • Do not disassemble the inverter unit and the ignitor unit.
  • Do not turn on the HID bulb by using a power source other than the battery mounted on your vehicle.
  1. Make sure you have the anti-theft codes for the radio and the navigation system, then write down the XM radio channel preset. Make sure the ignition switch is OFF.
  2. Turn the combination light switch OFF.
  3. Disconnect the battery negative cable, then disconnect the positive cable.
  4. Remove the headlight assembly.
37a2a12.jpg
  1. Remove the Torx bolt using a Torx T20 bit.
  2. Turn the cover (A) 45 ° counterclockwise to remove it from the headlight assembly.
71b91a6.jpg
  1. Turn the socket (A) 45 ° counterclockwise to remove it from the bulb (B).
  2. Pull the retaining spring (C) away from the bulb then remove the bulb.
  3. Make sure the bulb harness (D) is routed correctly so it does not contact the reflector (E).
  4. Install the new bulb in the reverse order of removal. Make sure the notches in the bulb align with the tabs in the headlight.
  5. After reconnecting the battery, enter the anti-theft codes for the radio and the navigation system, then enter the customer's XM radio channel presets.

Posted on Feb 13, 2009

  • 1 Answer

SOURCE: How do you reset the check engine light on an Acura TL 1999

i dont know how else to do it other than with a diagnostic tester. i think that may be the only way.

Posted on Mar 30, 2009

sheiden9
  • 87 Answers

SOURCE: HID BULB REPLACEMENT 2003 ACURA TL DRIVER SIDE

heres the procedure I uploaded it for you click [b][i]HERE[/i][/b]

Posted on Apr 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change headlight bulb in 2003 Acura 3.2 CL


Nick, To see how headlight bulb is changed, check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Replacement How to replace install fix change hid head light ballast...
Headlight Change 1999 2003 Acura TL 1999 Acura TL 3 2L V6
Acura TL Headlight Replacement WITHOUT removing the bumper

Aug 06, 2016 | 2003 Acura 3.2CL

1 Answer

Side marker lights keep flashing/car seems to need batt charge


You either have bad terminal connections on your battery or the anti-theft system has a system or sencor problem . I would really recomend that honda/acura check your electrical system and anti-theft system

Jan 15, 2010 | 2005 Acura TL

1 Answer

Reverse lights dont come on. the bulbs and fuse


The switch that lights the bulb is not good ,it must be change,you will find this switch under the gear shift lever

Jan 13, 2010 | 2000 Acura TL

1 Answer

ON A 2004 ACURA TL, THERE'S NO LIGHT ON THE CONSOLE FOR THE GEAR


Remove you shifter knob (unscrew) remove you gear selector cover with flat screw driver, under the cover shut be bulb,

Apr 21, 2009 | 2004 Acura TL

1 Answer

Headlamp bulb


what do you need? bulb size?

Jan 09, 2009 | 2004 Acura TL

2 Answers

I have 2006 Acura TL V6. How do I change the cabin air filter?


To change cabin air filter on Acura TL firs time you need to open the glove box and then remove the arm that holds the glovebox. Press the 2 sides of the glovebox to take this out like in picture bellow.
acura-tl-2004-2010-cabin-air-filter-location.jpgAcura TL 2004-2010 cabin air filter location
After do this you can see and locate the cabin air filter housing cover.
acura-tl-2004-2010-cabin-air-filter-housing-cover.jpgAcura TL 2004-2010 cabin air filter housing cover
Push the 2 tabs from the filter frame to unhooking from the housing cover. Take the frame out and replace the old cabin air filter with the new one with the air flow indicating arrow pointing down.

acura-tl-2004-2010-reinstal-the-air-cabin-filter.jpgAcura TL 2004-2010 reinstal the air cabin filter

Nov 26, 2008 | 2006 Honda Accord

1 Answer

Passanger headlight bulb inop


disconnected the HID ignighter. used a T20 to remove bulb cover. pulled out bulb and installed new bulb. DO NOT TOUCH THE BULB WITH BARE HANDS!!!

Nov 23, 2008 | 2004 Acura TL

Not finding what you are looking for?
2005 Acura TL Logo

Related Topics:

397 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7689 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...