Question about 2003 Hyundai Santa Fe

Open Question

Where is the purge valve located on a 2004 santa fe 3.5 v6

Check engine light on someone told me it was a problem with the evap system. could it be the purge valve or the canister shutoff valve?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 291 Answers

SOURCE: where is the charcoal canister

charcoal canister is under the vehicle near the gas tank, usually on the driver side of the vehicle.
thanks and please do not forget to accept the solution

Posted on Apr 03, 2009

Ad
c_dyer01905
  • 27 Answers

SOURCE: need location of vapor canister and purge valve in

The Canister Is located on the rear drivers side under the car (Big black box with 3 rubber lines). And the purge valve is located on the in the center on the back of the intake manifold (2 rubber lines and 1 plug).

Posted on Nov 15, 2010

  • 1 Answer

SOURCE: Fog Light Replacement Hyundai Santa Fe

The above statement is GREAT!!! The wheel-well piece folds down across the area you need to be in. There are 2 screws to undo this part. Push it back and there is a cap that unscrews which holds the wires and socket he is talking about. Unscrew the cap, unscrew the wire and housing. The bulb comes out. You pull the wire harness off and install the new bulb. It has a triangular push-in and it has to go just right so take note of how it comes out. Also, being a halogen light bulb, do not touch the bulb with your hands - the oils will make it explode.

Posted on Apr 06, 2009

  • 84 Answers

SOURCE: Change serpentine belt 2004 Hyundai Santa Fe

it uses a spring loaded tensioner.use a breaker bar to rotate the tension and it should just come off.if u need a pic or anything else to do it let me know,

Posted on Oct 05, 2009

motor1258
  • 6674 Answers

SOURCE: 2004 Hyundai Santa Fe 3.5L V6 What all do I

Sensor should be on front of engine near timing belt. Remove mounting bolt and connector and replace. Clearance between sensor and sensor wheel, should be between .020-.059 inches when re-installed.

Posted on Oct 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 Hyundai Sante Fe difficulty starting after fill up bulletin boards indicate that it may be a purge valve do you agree and where is this part located on the vehicle.. Thank You


Yes, the PCSV (Purge Control Solenoid Valve) is usually the cause of difficulty in starting the engine after refueling. The 2004 Santa Fe came with three different engines and this valve is located in different places on each engine (2.4 (4 Cylinder), 2.7 V6 and the 3.5 V6). Go to www.hmaservice.com and register your vehicle by VIN #.. you'll then have access to wiring diagrams, shop & owner manuals, service bulletins, campaigns, illustrations and procedures, etc

Sep 11, 2011 | Hyundai Santa Fe Cars & Trucks

1 Answer

I have this same p0441 check engine warning light problem.... plus my car doesnt start when i fill uo until i press the gas peddle and have to drive for a minute... after that... it drives fine...


CODE PO441 - EVAPORATIVE EMISSION EVAP SYSTEM INCORRECT PURGE FLOW. WHAT IS HAPPENING THE PCM DETECTED THE PURGE SOLENOID VALVE REMAIN OPEN DURING THE EVAP MONITOR FLOW TEST.

Aug 20, 2011 | 2004 Hyundai Santa Fe

2 Answers

Check engine light comes on for 2004 Hyundai Sante Fe. O2 sensor was replaced but still has the problem. Does the EGR manifold tend to get clogged up on the Sante Fe? I fixed a Honda Civic check engine...


First of all, why was the O2 snsr replaced?... Check Engine light? What DTC (diagnostic trouble code) did you find stored in the ECU (Engine Control Unit)? The drivability you seem to be describing can have multiple causes -- faulty sensors, malfunctioning computer, clogged catalytic converter, leaky injectors, vacuum leaks, etc.

Ok... this is gonna take some time. The 04 Santa Fe came with 3 (three) different/possible engines -- the 4 Cylinder 2.4 lit, the 2.7 V6, and the 3.5 V6. Only the 2.4 (4 cyl) and the 3.5 V6 are equipped with EGR. The 2.7 does NOT have EGR. To answer part of your question, the EGR system on the 4 Cyl is known to develop restriction(s) in the EGR port (from the # 4 cylinder exhaust port to the EGR valve at the intake manifold). This port travels through the head (front to rear, i.e., Left to Right when viewing the engine from the transmission end). This port cannot be seen at the # 4 cylinder exhaust port unless you remove the exhaust manifold.

It would be very helpful if you could provide more detailed/specific information regarding the drivability issue & what/which codes were found related to the Check Engine light.

Feb 12, 2011 | 2004 Hyundai Santa Fe

1 Answer

I have a hard time starting my 04 Santa Fe after i fill up


it was running then you removed the gas cap to fill ( extremely dangerous practice with car running)
that indicates that there is a problem with the EVAP system.
run the fault codes ( what the dealers should have done first ) and check for the EVAP codes , purge vent or solenoid problems

Apr 02, 2017 | 2004 Hyundai Santa Fe

2 Answers

Cranking issues


Hi
This issue is caused by a fault in the evap. emmision system. In the engine compartment there is a purge valve that takes in engine vaccum and fuel vapours. The valve is malfunctioning. It is located on the right side of the intake planum.

Dec 24, 2009 | 2004 Hyundai Santa Fe

2 Answers

Where is the purge valve located on a 2004 santa fe?


You have not responded CLEARLY!... which ENGINE?

Oct 30, 2009 | 2003 Hyundai Santa Fe

1 Answer

Check Engine Code PO446


purge control valve sticking either open or closed. location depends on what engine you have

Jul 03, 2009 | 2004 Hyundai Santa Fe

1 Answer

'02 Santa Fe V6 awd, Upon start up after a refuel you have to keep the revs up or it will stall,after that it starts fine.Also after running the a/c it doesn't want to shut off,turn the key back on and off...


One problem at a time please. No. 1!. Your description points to a faulty Purge Control Solenoid Valve (related to engine stall after refuel). The second problem could be caused by 'hot spots' in the combustion chamber -- however, the only way for any fuel to enter the combustion chamber after the KEY is turned OFF, is through the Purge Contro Solenoid Valve - it's the only component directly related to the problem you describe (unless you (or someone else) has modified the engine in some way other than original manufacture's design. Solution (provided no modifications have been performed), replace the Purge Control Solenoid Valve.

Jun 11, 2009 | 2002 Hyundai Santa Fe

2 Answers

Check engine light on po441


P0441 = Evap. Emission Ctrl. System Incorrect Purge Flow. Listed Cause - valve stuck in open position.
INSPECTION (4 cylinder engine)
When disconnecting the vacuum hose, make an identification mark on it so that it can be reconnected to its original position.cc59427.jpg 1. Disconnect the vacuum hose (black with red stripe) from the solenoid valve. 2. Detach the harness connector. 3. Connect a vacuum pump to the nipple to which the red-striped vacuum hose was connected. 4. Apply vacuum and check when voltage is applied to the EVAP Canister Purge Solenoid Valve and when the voltage is discontinued.
31f3588.jpg Battery voltage Normal condition
When applied Vacuum is released
When discontinued Vacuum is maintained

V6 Purge Solenoid Valve
bc8d2fa.jpg

Jun 04, 2009 | Hyundai Motor 2002 Sonata

2 Answers

Error code p0442


EVAP Emission Control System - Small Leak Detected (1.0 mm). This code can be set when 1. fuel filler cap is not completely tight, 2. when various hoses get punctured or the canister close valve does not seal completely, 3. there is an actual leak in the charcoal canister, fuel tank, or other EVAP system component, 4. if any one of these components are malfunction (a), fuel tank pressure sensor, (b) purge control solenoid valve, (c) canister close valve, or (d) fuel cap. An engine vacuum leak would not set this code.
Solution: Take the vehicle to a Hyundai Dealership for proper diagnosis/repair.

May 23, 2009 | 2001 Hyundai Santa Fe

Not finding what you are looking for?
2003 Hyundai Santa Fe Logo

Related Topics:

319 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...