Question about 2004 Hyundai Elantra

1 Answer

I just replaced driver side headlight and now both headlights do not work, is it a burnt fuse, again?

I have replaced the fuse for the headlamps within the past 6 months because both of my headlamps were not working; the same thing is happening again. Is this an electrical issue??

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 41 Answers

Try using led lights because of there lower usage of power.

Posted on Feb 16, 2012

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 53 Answers

SOURCE: changing headlight on driver's side

there is a 3rd bolt at the bottom of the lens assembely it is hidden under that open tube looking thing pull up on the tube and u will c the 10 mm bolt

Posted on Oct 19, 2008

  • 196 Answers

SOURCE: How do I change the headlamp BULB on a 2000 Hyundai Sonata

Open the hood, Look at where a long cable goes into the headlamp. There should be 3 screws holding the bulb in place. Take out the screws. The bottom screw might be hard to find but it is under the cable where the cable attaches to the headlamp. Once the screws are out, the bulb will come out of the headlamp still attached to the cable. The cable has a black covering around it. There is a plastic notch just above the bulb. Press it. It was a little hard to find. While you press the plastic notch, pull the bulb side (don't grab onto the bulb head itself, but just a little past the bulb) and the cable side apart. They are pretty tight, so you will have to pull hard. When the bulb side comes off the cable side, the cable will reveal a three-prong outlet. The bulb side will have three prongs that plug into the cable. At this point, bulb and cable are completely detached. Now, throw the bulb away, and go and buy a new one (10 bucks). PLug it into the cable, and then rescrew the whole thing (only 3 screws here) back into the set. Hope this helps. Only takes a few minutes. you only had to loosen one screw (and that might not even be necessary). This allowed a spring to be released. The other 2 screws were for the reflector and a hold-down tab for the spring. Simply release the spring from under the hold-down tab. An important addition worth adding to this procedure is "DO NOT TO TOUCH THE GLASS" on the new bulb. Wear clean gloves or use clean shop towels. The oil/ sweat etc. from your skin will greatly shorten the life of the bulb.

Posted on Nov 05, 2008

SOURCE: 2001 Hyundai elantra. Headlights, electric

check for any circuit brakers near the fuse box, if theres any of them reset them by introducing a paperclip in the small hole and press, you will hear a click.

Posted on Jul 20, 2009

  • 326 Answers

SOURCE: NO headlights. Could a timing belt issue be the

absolutely not the timing belt has no connection to headlights,first locate and check any headlamp related fuses located in either fuse box underhood or in dash area if no lights on high or low beam may pull headlight bulbs and check unlikely both go bad @ once this may end up being multifunction switch on steering column your turn signal lever is what you pull back on to switch rom high beam to low beam correct? if so this switch can cause your problem

Posted on Mar 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Headlights do not work.


from the diagram I looked at, voltage to headlamp switch is hot all the time. The headlamp switch has an internal circuit breaker. When you turn on headlamps, the voltage goes from headlamp switch to dimmer switch then to the headlamps. You could have problem with dimmer switch?
headlamp switch assembly-snmzcihstaedp1td4dwemzwq-4-0.jpg

Feb 28, 2017 | Cars & Trucks

1 Answer

What can cause a headlamp to be out besides a bad bulb?


Could have a short in the system. The headlight could have blown again I don't think the radio is connect with headlight problem.

Dec 23, 2015 | 1998 Nissan Maxima

2 Answers

Head light have low but when using high does not work just on one side drivers side


HELP! headlight not working even after change - Nissan Forums ...

www.nissanclub.com/...nissan.../302674-help-headlight-not-working-eve...

Apr 1, 2010 - 13 posts - ‎6 authors
My passenger side low beam headlight recently went off on me. ... I've changed the bulb again, and changed the fuse just in case, but .... My driver side headlight wire got loose so when i hit a bump at night if would flicker. ... When you notice one side not working (Low or High beam) it could be the module. Headlight replacement
15 posts
Jan 22, 2009
Low beams don't work but High's do
8 posts
Mar 20, 2005
More results from www.nissanclub.com

Dec 20, 2015 | 2004 Nissan Sentra

1 Answer

Prius headlights work only on highbeam


There should be separate fuses for high and low beams on a Prius. If one of your headlight bulbs is bad, it could have blown the low-beam fuse. Check for blown fuses behind driver's side headlight fuse panel. If new one blows, replace headlight bulbs and try again.

On 2004-2009 Prius, driver's side headlamp bulb can be replaced by removing hold down screws and folding fuse panel upward to access rear of headlight assembly. Large round cover with 3 tabs unscrews about 1/4 turn to remove. It's really tight and held by friction of large O-ring so it'll take some muscle but it will eventually give. Be careful replacing bulbs as metal clips can be easily installed incorrectly resulting in tilted headlight beam. 3-tabs must rest on flat surfaces on mounting area before spring clip can be latched in place. 3-prong plug can be wiggles sideways/up and down to remove from bulb.

Oct 24, 2013 | 2006 Toyota Prius

1 Answer

Both headlights went out. I've replaced the headlamps fuse and one headlight with no luck. Someone suggested perhaps I need to replace headlamp relay but I can't locate it.


Just trace the wires from the headlamps to the firewall where the relays are usually situated. Replace the burnt out relay by unplugging it and mounting it on the firewall.

Jun 19, 2010 | Cars & Trucks

1 Answer

05 altima 3.5 r/f headlight does not work replaced


There should be a main fuse box under the hood. The headlights have a main fuse for each side. There should be one for the left and right headlamp. Check the fuse for the r/f headlamp. If it is blown, then that is the cause for the headlamp not to work. Replace with a new fuse and it should be good to go. If not, check the bulb itself.

Feb 17, 2010 | 2002 Nissan Sentra

2 Answers

Audi A4 2002 Low beams & Right front turn signal stopped working


For Audi A4 the fuse box is located on the left side of dashboard behind a plastic cover (for left hand steering wheel vehicle). On inner face of the plastic cover you will find the fuse diagram.
First fuse on first row from left upper corner is Fuse Nr.20 = F20 (15A) - RH headlamp low beam, headlamp adjustment.
First fuse on second row from left upper corner is Fuse Nr.21 = F21 (15A) - LH headlamp low beam, headlamp adjustment.

Feb 15, 2010 | 2002 Audi A4

1 Answer

96 sunfire headlight problem


have you checked the headlamp fuses for the vehicle each side has its on fuse for high and low beams

Aug 20, 2009 | 1996 Pontiac Sunfire

1 Answer

Drivers side headlight is not working


Check all fuses and replace any that are burnt. If that does not help try replacing the headlamp bulb.

Jul 14, 2009 | 2003 Chevrolet Impala

Not finding what you are looking for?
2004 Hyundai Elantra Logo

249 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...