Question about 2003 Hyundai Accent

Open Question

How do i remove rear seat from 2003 hyundai sonata

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

232K7
  • 26 Answers

SOURCE: Hyundai 2006 Sonata high mount brake light.

the rear seat does NOT have to be removed in order to replace the stoplamp and/or its bulb.
you have to get into the trunk, and there are (2) philips screws holding the stoplamp secured to the package tray. the actual process takes about 15 minutes, because to do it right you have to actually get IN the trunk.

the price they charged you sounds about right if the price of the stoplamp is included, dealerships tend to overcharge for parts.

Posted on Apr 14, 2009

  • 393 Answers

SOURCE: replacing rear wheel bearings on 1999 hyundai sonata

  1. for drum brakes with sealed hub(all one piece) remove lug nuts and wheel.
  2. spray penetrating oil around studs if there is a big phillips head screw visible remove it with impact driver/if not use big ballpeen hammer ,tap on flat of drum near studs(becareful not to hit them) until drum loosens(your creating a shockwave to loosen rust)
  3. once drum is off there are 4-bolts coming in from behind backing plate, remove them then hub should be able to be removed w/a little persuation from hammer.
with out sealed hub ,
  1. remove wheel
  2. remove dust cap,cotterpin,star washer(if equipped) do not re use cotter pin
  3. remove nut then washer, wiggle brake drum and front bearing will come out.
  4. put nut on shaft tighten 2-3 turns grab drum by sides and pull towards you this should remove drum leaving inner bearing/seal on shaft
  5. to replace reverse procedure making sure to pack new bearings w/grease(take drum and use long punch to remove bearing races, use race/seal installer to install new races
with disk brakes

  1. remove wheel
  2. remove caliper/bracket
  3. remove rotor
  4. remove 4-bolts from behind,tap old hub out
  5. reverse procedure



Posted on Nov 15, 2008

  • 73 Answers

SOURCE: adjust serpentine belt tensioner 2003 hyundai

has automatic belt tensioner

Posted on Apr 22, 2009

  • 69 Answers

SOURCE: Removal of Radio in 2004 Hyundai Sonata

Remove the facia plate, and remove the 4 screws that hold the radio in place. It's actually one of the simplest cars you can do.

Posted on May 27, 2009

SOURCE: Hyundai Sonata 2003 Car starts then dies immediately :(

dear friend-it appeares that you have no feul pressure,check pressure,feul filter,feul system,

Posted on Jul 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is the fuel filter on a 2010 sonata


Most companies including Hyundai stopped using replacement fuel filters in 2003.
The only fuel filter your car has is before the pump in the gas tank.

Jan 27, 2013 | Hyundai Sonata Cars & Trucks

1 Answer

WHERE IS THE SERPENTINE BELT LOCATED ON A 2003 HYUNDAI SONATA


Vehicles Covered: Hyundai Sonata 2002-2004 (2.4L & 2.7L Engines)

In 2003, Hyundai produced two types of Sonata:
Available engines:
4 Cylinders 2.4L VIN "S", MFI DOHC - see Figures 1 and 3.
6 Cylinders 2.7L VIN "H", MFI DOHC - see Figures 2 and 3.

To differentiate between these types of 2003 Hyundai Sonatas, the VIN 8th digit (Engine Type) will either be "S" or "H" as in the table above.

To locate the Engine drive belt, jack up the vehicle & place it onto jack stands, then slide under the car (toss a cardboard mat down first), then, once under the car, remove the (plastic) engine splash shield. Once removed, the drive & accessory belts are easily observed.

12_27_2011_5_25_29_am.jpg

Fig. 1 Accessory Drive Belt Routing 2.4L (4 cyl) Engine - Hyundai Sonata
The "COMPRESSOR" refers to the A/C compressor, and "GENERATOR" refers to the Alternator.


12_27_2011_5_27_01_am.jpg

Fig. 2 Accessory Drive Belt Routing 2.7L (6 cyl) Engine - Hyundai Sonata
The Belt Routing on the Left is "With A/C", on the Right is "without A/C"

Inspection - Drivebelt and Accessory Belts

Inspect the drive belt for signs of glazing or cracking. A glazed belt will be perfectly smooth from slippage, while a good belt will have a slight texture of fabric visible. Cracks will usually start at the inner edge of the belt and run outward. Worn or damaged drive belts should be replaced.

Drivebelt Removal & Installation - 2003 Sonata (2.4L and 2.7L engines)

Raise and support the vehicle.
Remove the engine splash shield.
Rotate the drive belt tensioner clockwise to release the drive belt tension.
Remove the drive belt from the alternator.
Slowly release the drive belt tensioner.
Remove the drive belt from the accessory drive pulleys.

To install:

Install the drive belt to the accessory drive pulley.
Rotate the drive belt tensioner clockwise.
Install the drive belt to the alternator.
Ensure the drive belt is properly aligned and seated into the grooves of the accessory drive pulleys.
Slowly release the drive belt tensioner
Install the engine splash shield.
Lower the vehicle.

Here's the best illustration I can find of the Hyundai 2.4L and 2.7L engines - the drivebelt seems to be located on the passenger side of both of these transversely mounted engines.

12_27_2011_6_03_16_am.gif

Fig. 3 Hyundai 2.4L and 2.7L engines - Underhood sensor locations 2002-2004 only

Glossary of Acronyms
---------------------------------
A/C - Air Conditioning
DOHC - Dual Overhead Cam
MFI - Multi-port Fuel Injection

Dec 25, 2011 | Hyundai Motor 2003 Sonata

1 Answer

Hey i have a hyundai sonata 1996 and im having problems with removing the rear seats. I've taken the bottom seat off but the top part there are 2 panes on each side that i can get off. i was wondering if...


Look for two bolts a the bottom of the panel. One for each side. If there are no bolts then they clip on you will have to pop them off start at the bottom.

Apr 30, 2011 | 1996 Hyundai Sonata

1 Answer

Need to know location of gas filter


It is behind the rear seat cushion and the access panel. To do this open the rear doors on the 2005 Hyundai and locate the two main connector bolts that hold each rear seat in place. The two bolts are located under the front part of each rear seat. Remove the four bolts with a 3/8 inch ratchet and a 12mm socket. Turn the bolts counter-clockwise to loosen and remove the bolts. Slide the rear seats out of the seat compartment. Then slide the rear seats out of the car. If you want do some more intricate work like replacing the filter then follow this link.

http://www.ehow.com/how_6208514_replace-filter-2005-hyundai-elantra.html#ixzz14tU8lBdv

Nov 10, 2010 | 2005 Hyundai Sonata

1 Answer

Where can i find the amp on an 03 sonata


They really hide it. It's bolted to the body on the right side between the trunk and the rear seat, near the right rear wheel well. You get to it by removing the trunkliner - trim in that region. Good luck!
P.S. Careful, many Hyundai / Kia audio systems are 2 ohm, not 4 ohm like most modern car audio systems.

Jan 20, 2010 | 2001 Hyundai Sonata

1 Answer

How do I access the top of the rear strut mount on a 2000 Hyundai Sonata?


over the rear strut mount cavity aft of the rear seat shoulder pads.

Oct 26, 2009 | 2000 Hyundai Sonata

2 Answers

97 sonata rear seat removal how do I do it can not find fasteners


the seat bottom has two 12mm bolts on the drivers side and pass side behind the seat between the seat back and bottom, feel between the seats and you can feel them, use a 12mm shallow socket and 12 inch 3/8 drive extention to remove them, them push the relase latches on the front of the seat bottom.

Oct 25, 2009 | 2009 Hyundai Sonata

1 Answer

How to remove interior back dash on 2006 hyundai sonata


The shop manual does not illustrate the procedure for removing the rear package deck (back dash). This will be a lengthy description for removing this deck
1. Remove the rear seat bottom (2 12mm bolts located in between the seams at the seat back and the seat bottom (lower the seat backs and you'll have to feel for them). Remove them
2. Remove the seat bottom (two spring loaded clips at the front of the seat bottom).
3. Remove the 12 mm bolts at the bottom of both LH & RH shoulder cushions. Lift UP and then forward (careful you don't break the should cushion clips at the back of the cushions).
4. Using a small screwdriver, remove the SRS caps at the C-Pillar moldings (behind them are either two phillips head screws or 10mm bolts) - remove them
5. Remove the C-Pillar moldings -- they are 'Clipped' into position (use a flashlight to locate them and a long shaft plane screwdriver to help 'unclip' them).

ff32eaf.jpg lower the seat backs down. Note the trunk accessway side moldings (approximately 8 to 10 phillips head screws) remove them and the accessway moldings (you can'r remove the deck unless you remove these accessway moldings).
6. Find the plastic clips which hold the rear deck in place (usually yellow or blue)


0fbe0c6.jpg Remove the rear package deck.
Now, depending on what you want to do now... it's up to you.
Reassembly is in reverse order.

Jun 19, 2009 | 2006 Hyundai Sonata

2 Answers

Hyundai 2006 Sonata high mount brake light.


the rear seat does NOT have to be removed in order to replace the stoplamp and/or its bulb.
you have to get into the trunk, and there are (2) philips screws holding the stoplamp secured to the package tray. the actual process takes about 15 minutes, because to do it right you have to actually get IN the trunk.

the price they charged you sounds about right if the price of the stoplamp is included, dealerships tend to overcharge for parts.

Apr 11, 2009 | 2006 Hyundai Sonata

Not finding what you are looking for?
2003 Hyundai Accent Logo

Related Topics:

347 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7711 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...