Question about Cars & Trucks

1 Answer

Need diagram for ford connect 2003, brake lights not working.

Posted by on

  • peter Feb 17, 2012

    thanks again, will have a look over the weekend or get my mate who is more qualified than me to do it



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 41 Answers

There are smaller fuses near the tail lights.there for short circuits or over powering.

Posted on Feb 16, 2012

  • 2 more comments 
  • peter Feb 16, 2012

    cheers, will have a look and see if i can find them. would both blow at same time?

  •  dennis williams
    dennis williams Feb 16, 2012

    it does happen yes, i think there on the right side, most cars have them

  •  dennis williams
    dennis williams Feb 17, 2012

    ill get that diagram for you. i also asked someone and the only fuse box will be under the dash.

  •  dennis williams
    dennis williams Feb 17, 2012

    Fuses are listed here

    * = maxi fuse

    1*=50A I/P fuse panel
    2*=40A blower motor relay
    3*= 50A 4 wheel ABS module
    4*=20a Main light switch-Instrument cluster
    5*=50A Ignition switch, starter relay

    6*=20A Transfer case relay
    7*= NOT USED
    8*=20A Auto Ride Control Switch/on off switch
    9*=40A Auto Ride Control relay
    10*=30A PCM power relay

    mini fuses
    1=10A A/C relay
    2=20A Aux power point
    3= not used
    4=15A Fog lamps-Daytime lamps
    5=10A Air Bag diagnostic monitor
    6=10A Powertrain Control Module (PCM)
    7=30A 4WABS module
    8=30A PCM relay
    9=20A Fuel Pump relay and RAP module
    10= 15A Horn relay
    11=15A Park Lamp relay-Main Light Switch
    12=30A Main light switch--Multi Function switch
    13=15A Heated O2 sensors, EGR Vacuum Regulator, EVR solenoid,Camshaft position (CMP) Sensor,
    Cannister Vent Solenoid, A4LD Auto Transmission
    14=30A Generator-Voltage regulator

    Interior fuse panel (mini fuses)

    1=7.5A Power mirror switch
    2=7.5A Blower motor relay,PAD module,Air Bag diagnostic monitor
    3=7.5A Trailer tow connector
    4=10A Left headlamp
    5=10A Data link connector (DLC)
    6=7.5A Air bag diagnostic monitor, Blower motor relay, Passive deactivation Module (PAD)
    7=7.5A Trailer Tow connector
    8=10A Right headlamp, Daytime running lamps (DRL) module, Foglight relay
    9=7.5A Stop Lamp switch
    10= 7.5A Speed control-amplifier assembly,Brake pressure switch, Generic electronoc Module (GEM)
    Shift lock actuator, Blend door actuator, Main light switch, RABS resistor, A/C heater assembly
    11= 7.5A Instrument cluster, Main light switch, RABS resistor
    12= 10A Power window relay, Washer pump relay
    13= 20A Stop lamp switch, Brake pressure switch
    14= 20A Rear Anti Lock Brake system (RABS) module
    **10A 4WABS module**

    15=7.5A Instrument cluster
    16= 30A Windshield wiper Motor, Wiper Hi-lo relay, wiper run/park relay
    17=7.5A Cig lighter
    18=15A Drivers unlock relay-All unlock relay
    19=25A PCM power diode
    20=7.5A RAP module GEM module, Radio
    21=15A Flasher (hazard)
    22=20A Aux power socket
    23=15A Turn signals
    24===not used
    25= 7.5A GEM module, Instrument cluster
    26= 10A Battery saver relay, Electronic Shift relay, Interior lamp relay
    Power window relay,Electronic shift control module, transmission control
    27=15A Switch,DRL, Backup lamp switch, DTR sensor,Instrument illumination dimming control module
    Dome/map lamp, GEM,electronic shift,Interior lights,Glove box lamp and switch
    28=7.5A GEM module-Radio
    29= 15A Radio
    30=15A Park lamps, trailer Tow relay
    31===not used
    32=10A rear blower
    33=15A Headlamps, DRL module, Instrument cluster
    34=7.5A Rear integrated control panel, CD
    35=10A RABS test connector
    36=7.5A CD, rear integrated control panel, memory seat, Message center Attached images __________________



6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 14 Answers

SOURCE: 1988 ford thunderbird brake lights and turn signals not working

When this happens the problem is most likely the multi-funtion switch aka turn signal switch. Check to see if the 3rd brakelight comes on when the brake pedal is pushed. If so replace the MFS. The 3rd brakelight in late 80's fords bypasses the turnsignal switch.

Posted on Dec 29, 2008

  • 667 Answers

SOURCE: brake lights on 2003 Ranger quit working

if you do not have an owners manual, you can get one at the diagram you are looking for is in there

Posted on May 20, 2009

  • 1 Answer

SOURCE: Ford 2003 ZX2 Blower does not work need fuse diagram

The fuse box is under the dash on the drivers side, the cover for it has a map showing which amperage fuse goes to what, includes the three most common sizes in the cover and a little plastic tool to remove them...hope this helps

Posted on Jun 20, 2009

  • 521 Answers

SOURCE: Brake lights on a 2003 chevy silverado 2500HD wont work.

same bulb but 2 seperate elements. wiring diagram u should be able to obtain from your local auto parts store like autozone(preferred)

Posted on Sep 23, 2009

  • 5 Answers

SOURCE: 2003 Ford Focus ZX-5: Brake lights stuck on

Check the lights on the 3rd brake light. If the bulbs are out the brake lights will remain on when in gear, but work properly when in park. I had the same problem had to go to Napa to get bulbs (5) and now all is fine.

Posted on May 07, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Abs wiring diagram to cancel lights and repairs required

You'll need to have someone check the body computer for trouble codes to know what to test. Its also possible you are low on brake fluid.

Aug 03, 2014 | 2003 Ford Focus

1 Answer

Brake system diagrams 2003 F-150

The brake lines connect to the calipers. That's about it!

Jul 20, 2014 | Ford F-150 Cars & Trucks

1 Answer


Check to see if the wiring harnesses are properly seated, may have a loose connection.

Jun 06, 2013 | 2003 Chevrolet Silverado 1500

2 Answers

Cruise control not working

On these case,to troubleshoot these problem,there are solved help links.Click the link directly and refer the details to solve these problem yourself,with help of diagrams:------
Ford ranger cruise control not working?

----------- Horn and Cruise control quit working?


Horn and cruise control not working on Plymouth Grand Voyager?

Horn and Cruise control quit working on 2003 Jaguar S-Type?

Cruise Control stops working, Excessive cranks to start the engine and RPM goes max 2500

Cruise control stop working on 1994 Ford ranger?

Cruise control not working?

1996 Ford Explorer: Cruise Control Wiring Diagram?
These will help.

Nov 22, 2012 | 2003 Ford Expedition

1 Answer

2003 focus brake lights stays on in all gears

Here is the Ford diagrams that you could to check(click for zoom)...





If it only lights up the tail lights when its in RND21 but works correct in park then I believe your looking at a internal shorted brake shift interlock on the shifter back feeding and sending power back to the brake switch and turning the lights on. I would access the shifter assembly and depin the wire I am pointing to and reconnect the connector and see if the brake light issue stops. You will need to manually shift it out of park or temporarily attach this wire to get it out of park for the test.


Check it and send us your comments.

Jun 30, 2011 | 2003 Ford Focus

1 Answer

Brake lights on a 2003 chevy silverado 2500HD wont work.

same bulb but 2 seperate elements. wiring diagram u should be able to obtain from your local auto parts store like autozone(preferred)

Sep 23, 2009 | 2003 Chevrolet Silverado 2500HD

1 Answer

I've checked all the components, relay, pedal switch, fuse, bulbs and I still don't have brake lights. The third brake light works but no brake lights, every thing else works, tail lights, flashers and...

The mechanic needs to check again the connection of the brake light to the fuse and the wires . then try checking terminal sockets of the brake light that can also be the problem.if still not working try to look at the sensor .

Aug 11, 2009 | 2003 Ford E150

1 Answer

Brake lights on 2003 Ranger quit working

if you do not have an owners manual, you can get one at the diagram you are looking for is in there

May 20, 2009 | 2003 Ford Ranger Regular Cab

Not finding what you are looking for?

Open Questions:

Cars & Trucks Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

77186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides