Question about 2000 Dodge Stratus

Open Question

My 2000 dodge stratus hood latch isnt working

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: Hood Latch Wire ???

I had the same problem on mine. You can get to the latch from underneath right behind the bumper. You will need a long screw driver or pry bar to push the tab that the cable connects to. On mine I had to have someone push down on the hood slightly while I pushed the tab.

Posted on Aug 21, 2008

  • 1 Answer

SOURCE: the hood release isnt working. how can we open the

Hope this is not too late. I just worked on this exact car and problem. If the cable is broken upstream from the in car release handle here is my solution: The Stratus has four grill panels. Remove the screws from the upper two panels. The panels have a plastic rivet at the very top which can't be removed unless the hood is open so bend the panels up to gain access. With a flash light look through the grill openings and find the latch. The latch has three 12mm bolts holding it in. The two outside bolts are easily removed through the grill openings. The third bolt is tricky because it is lower and dead center to the grill. It is not in alignment with the openings. It is hard to even see it but with a long extension, universal joint and 12mm socket, it is possible to get to it and remove it. I got to it through the passenger side grill opening. With all the bolts removed, the hood opened with the unbolted latch still attached to it.

Posted on Jul 16, 2009

abauto
  • 353 Answers

SOURCE: 2000 dodge stratus rear end suspension diagram

Diagram

02c5fb4.jpg0007120.jpg

Posted on Sep 15, 2009

SOURCE: im trying to che ck the fuel pump under the hood

You should have a shrader valve that you can hook up a gauge to. If you dont then even if you have pressure by opening a line you wont know if its enough. . Also if you find the shrader, should have a cap on it, cycle the key and then push the shrader in. If no squirt then the pump isnt working. It may be a bad pump or it may have lost its power source. Could be a fuse or broken wire somewhere

Posted on Sep 22, 2009

  • 151 Answers

SOURCE: How do you release hood latch with cable jam on a

I would have a friend help and one of you pull the hood latch and the other tap on the hood with the palm of your hand you might have to do this more than once but usually works once open oil the hood release with something like wd-40 or pb blaster.

Posted on Apr 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuse for the horn because it keeps going off


open the hood and look in the under hood electrical fuse relay center should be a relay that is marked horn or you can pull the fuse marked horn.must likely its the air bag on steering wheel.it coukd be the alarm but you would have to take to shop or get a book to help you, good luck

Jun 03, 2015 | 2000 Dodge Stratus

1 Answer

Where do the vacuum lines go on a 2000 Dodge Stratus


All over the place, there should be a vacuum hose diagram under the hood for the most important functions.

Feb 15, 2015 | 2000 Dodge Stratus

1 Answer

My stratus isnt geting power to the distibuter so it wont fir


stratus in the USA don't have distributor it has a crankshaft position sensor that fires a coil unless this auto is a European or some other country that still uses carburetor and distributor.

Jan 23, 2011 | 2000 Dodge Stratus

1 Answer

R&R Blower motor resistor on my 2000 Dodge Stratus 4cyl 2.0. It only works on highest position.


Change resistor when these start to go you usually loose 1 speed of settings or two at a time until non left usual these are located in the air box duct in passenger side foot area about two inch long half a inch wide with a singe plug sometimes found under hood in fire wall.

Dec 23, 2010 | 2000 Dodge Stratus

1 Answer

How do you release hood latch with cable jam on a 2000 dodge interpid (Hood closed)


I would have a friend help and one of you pull the hood latch and the other tap on the hood with the palm of your hand you might have to do this more than once but usually works once open oil the hood release with something like wd-40 or pb blaster.

Apr 07, 2010 | 2000 Dodge Intrepid

2 Answers

My 1998 Intrepid has a broken hood latch. When I pull on the inside latch, nothing happens. How can I open my hood, and fix this problem for the future ?


can you grab a piece of the cable from under dash?if so pull it and see if it will open.
if not you will have to try to get at latch from under car.
if you cant get at it find a reasonably priced body shop they are pros at getting stuff like that open
then get a new cable or pull handle or latch whichever it needs and replace it

Mar 28, 2010 | 1998 Dodge Intrepid

1 Answer

My horn isnt working. we checked the fuses but nothings working


check and see if you have power at the horns, mostlikly you have bad horns,usauly thats what happens horns brun out and pop the fuse, il bet horns are bad. good luck.

Oct 08, 2009 | 1997 Dodge Stratus

1 Answer

Im trying to che ck the fuel pump under the hood by a hose going into the motor. which hose would i be looking for? i have a 2000 dodge stratus.


You should have a shrader valve that you can hook up a gauge to. If you dont then even if you have pressure by opening a line you wont know if its enough. . Also if you find the shrader, should have a cap on it, cycle the key and then push the shrader in. If no squirt then the pump isnt working. It may be a bad pump or it may have lost its power source. Could be a fuse or broken wire somewhere

Sep 22, 2009 | 2000 Dodge Stratus

1 Answer

The hood release isnt working. how can we open the hood on a dodge 2004 stratus coupe


Hope this is not too late. I just worked on this exact car and problem. If the cable is broken upstream from the in car release handle here is my solution: The Stratus has four grill panels. Remove the screws from the upper two panels. The panels have a plastic rivet at the very top which can't be removed unless the hood is open so bend the panels up to gain access. With a flash light look through the grill openings and find the latch. The latch has three 12mm bolts holding it in. The two outside bolts are easily removed through the grill openings. The third bolt is tricky because it is lower and dead center to the grill. It is not in alignment with the openings. It is hard to even see it but with a long extension, universal joint and 12mm socket, it is possible to get to it and remove it. I got to it through the passenger side grill opening. With all the bolts removed, the hood opened with the unbolted latch still attached to it.

Jun 23, 2009 | 2004 Dodge Stratus

Not finding what you are looking for?
2000 Dodge Stratus Logo

Related Topics:

190 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...