Question about 2001 GMC Yukon

1 Answer

2001 GMC Yukon will not stay running - 2001 GMC Yukon

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 77 Answers

That's a statement not a question

Posted on Feb 16, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

old marine
  • 1972 Answers

SOURCE: 2001 gmc yukon xl 1500

Check to see if the power steering pump is still turning. If you have a broken drive belt (serpentine belt or "fan" belt), and the pump doesn't turn, you have no power assist. If the pump is still turning, check the fluid level in the reservoir.

Posted on Oct 31, 2008

  • 1 Answer

SOURCE: Heated seats won't stay on in 2004 GMC Yukon Denali

There is a widespread problem with electrical shorts with the seat warmers. I bought the extended warranty through CarMax and theyy fixed it. Retail repair cost on that would have been $900+. It may be covered by GMC via a recall, but only if you raise enough hell.

Posted on May 05, 2009

  • 10 Answers

SOURCE: airbag light blinks 7 times and it stays on.

One of your sensors are not working properly. It is still safe to drive. Have you bumped into something lately or had to jack the brakes? I know it's annoying but it will not go off on you.

Posted on Jun 17, 2009

SOURCE: u-joint repalcement for 2001 yukon xl

Mark your drive shaft coincidenly with the rear axle and tranny. Remove drive shaft. Press out the old u joints and press in the new. You will need a torch for heat and a lot of patience. Have fun!

Posted on Jun 20, 2009

  • 27 Answers

SOURCE: problems with acceleration - 2001 Yukon

Most likely it is due t5o dirty fuel injectors or bad mass air flow sensor

Posted on Jul 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change cam sensor 2001 gmc yukon


how to change cam sensor gmc yukon model 2001

Jul 18, 2012 | 2001 GMC Yukon XL

1 Answer

Where is the ac belt in a 2001 gmc yukon


You got two belts on this vehicle the serpentine belt which runs the power steering, water pump, alternator. Behind the serpentine belt toward the bottom if the engine compartment theres a smaller belt that runs frm the crank to the ac compressor and the belt tensioner.

Jun 20, 2012 | 2001 GMC Yukon

1 Answer

The parking lights on our 2001 GMC Yukon XL stay on after turning the vehicle off. This drains the battery down to prevent starting again. What is wrong?


Hi, there is a park relay in middle of the interior relay box under the dash to the left of the steering column. This is shown on page 6-61 of your owner's manual (http://www.extendedgmwarranty.com/owners-manual/gmc/2001-GMC-Yukon-Denali.pdf)
With the battery connected, pull out the relay and push it back in. If it clicks when you do this, the headlight switch is bad. If it doesn't click, the relay is bad. Try swapping the relay with another similar relay, such as the horn or A/C relay. If that solves the problem you need a relay. If not, you need a switch. Please let me know if you have any questions, and thanks for using FixYa.

jturcotte_1301.gif

Mar 24, 2011 | 2001 GMC Yukon Denali

1 Answer

2001 yukon codes causes banks 1 and 2 to run lean?


If bank one and two are running lean problem is the Mass Air Flow Sensor (MAF) Dirty or Defective.

May 20, 2010 | 2001 GMC Yukon XL

1 Answer

Yukon 2001 ABS and Brake light stays on


If any work has been done on it there is a sensor that needs to be reset usually by a dealer

Dec 02, 2009 | 2001 GMC Yukon

1 Answer

My GMC yukon XL 2001 engine runs after 4 times of cranking.


Try turning key to on only, not start, 2 or 3 times first then try to start. If it starts good first try, then I'd change my fuel filter & then have fuel pressure tested if fuel filter didn't help. You may be looking at a new pump, but lets do filter & test fuel pressure first.

Jul 06, 2009 | 2001 GMC Yukon XL

1 Answer

Airbag light blinks 7 times and it stays on.


One of your sensors are not working properly. It is still safe to drive. Have you bumped into something lately or had to jack the brakes? I know it's annoying but it will not go off on you.

Jun 17, 2009 | 2001 GMC Yukon Denali

1 Answer

Problems at low RPM


check coolant level! look for coolant loss

Mar 21, 2009 | 2001 GMC Yukon XL

Not finding what you are looking for?
2001 GMC Yukon Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...