Question about Chevrolet Camaro
When i give it gas its like its slipping in 2nd gear, but speeding up, then shifts back to 3rd go for 30 secs. then repetes
Sounds like a loss of hydraulic pressure inside the transmission die to leaking seals to the clutch pack.
Posted on Feb 17, 2012
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
call a dealer and they will tell you you are suppose to change your transmission fluid every 2 years or 30,000miles but if you was carrying this much load you may have over heated the transmission so I would shop around and get a good deal at a transmission place where they can replace the filter and the fluid and adjust the bands on the transmission if needed
Posted on Jan 13, 2009
SOURCE: engine noise
Sounds like a problem with the power valve actuator in the intake manifold collector. I would check with a Nissan dealer first and inquire of any recalls or service bulletins. Might save ya time & money.
Posted on Jan 21, 2009
SOURCE: 4l60e slips in 3rd and 4th
There are to many things that can cause this problem, best thing to is go get the ECM scanned for DTC codes at a transmission shop or Auto zone or Parts Source since they scan for free.
The ECM should have DTC code in it's memory on how the transmission is Performing and have the Transmission line tested for Fluid pressure.
Good luck and hope this helps. Oh and also ways check with more then on transmission shop if there tell you that you need a new Transmission,
It could be a simple as the transmission filter falling off causing the lost of transmission fluid pressure. Check the transmission fluid too.
Posted on May 07, 2009
The EMC detected and problem so it's in limp mode, As long as it's in limp mode the 4th and OD will not activate. Take care not to burn up the transmission by running it hard while your in the limp mode.
Your going to have to get the truck scanned to clear any codes and why there are DTC codes. Auto Zone scan for free and most auto shops charge $10.00 to $20.00 to scan sine they want the business.
If you want to clear the codes your self you can put the ignition to the run position and pull the ECM (Batt) fuse out for 20 sec and place it back in then start the truck. It may stall but let it, just start it again and this would have cleared all the DTC code history.
The transmission should be running fine unless there is a problem and the service engine light will be on again and you'll be in limp mode still with an updated DTC in the ECM.
Good luck and hope this helps.
Posted on May 26, 2009
i got a 1996 chev. blazer s-s10 4.3 engine 4x4.problem i got is i got 1st 2nd & overdrive & reverse but no 3rd gear what should i do
Posted on Jan 19, 2010
Tips for a great answer:
Mar 02, 2014 | 2007 Chevrolet Avalanche
Feb 28, 2014 | Cars & Trucks
Jul 16, 2012 | Cars & Trucks
Dec 27, 2010 | 1999 Chevrolet Silverado 1500
May 28, 2010 | Chevrolet Blazer Cars & Trucks
Apr 21, 2010 | Chevrolet Silverado Cars & Trucks
Nov 20, 2009 | 1995 Oldsmobile Cutlass Ciera
Jun 30, 2009 | 1996 Chevrolet Blazer
143 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: