Question about Ford Cars & Trucks

1 Answer

Blower fan wont turn off in ea ford - Ford Cars & Trucks

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Ford Master
  • 80,339 Answers

I have found that this problem can be caused by the blower motor speed control resistor/module. It is located in the air ducting near the blower motor

Posted on Feb 16, 2012


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Model Ford Tourneo Kombi. fault: a/c works but fan only operates on max speed (positions 1 to 3 fan wont work) any clues welcomed

Sounds like an blower motor resistor. It regulates voltage going to the motor depending on what speed you select. Speed one , or low only lets so much voltage to the motor and full lets all the voltage through. If it is blown, it cannot regulate voltage and acts like its not there. I would start with that.

Aug 14, 2011 | Ford Transit Connect Cars & Trucks

1 Answer

On my 1999 ford contour fan wont turn wired it and it temperature gauge in control panel on all the way over.i dont know if the relays are good or not. dont know where if the temperature...

1. Check the fuse to the fan
2. Have a look at and replace the sensor.

(I'm not sure what the problem is with the ac/heater: I understand that the blower worked but, for some reason you replaced the resistor, and now it doesn't...)

Aug 08, 2017 | Ford Contour Cars & Trucks

2 Answers

I need to know whats the problem with the heater what is it

Excatky what is the problem? Wont heat? Blower Fan Motor wont work?

Dec 27, 2010 | 2003 Ford Expedition

1 Answer

Ac compressor/wont blow

Test the fan for voltage you need to have 12 volts to the fan for it to work, if you have twelve volts between the two terminals at the blower then you have a failed blower motor.

May 29, 2010 | 2004 Ford Crown Victoria

2 Answers

No air blowing 1998 Ford E350

blower motor location is in the heater box down by the passengers feet the fan relay in out under the hood in the power fuse box check this first
check to see if the blower motor turns you can do this by removing the three screws the motor and squiral cage will come out spin it if it moves freely putit back replace the switch assembly

Mar 03, 2010 | 2002 Ford E350

1 Answer

How to remove fan heater motor from 91 ea ford fairmont

you have to remove the right side ventilator access the blower motor and wheel.

Jan 04, 2010 | Ford Fairmont Cars & Trucks

1 Answer

I turn the the fan on for the heating but the fan

Sounds like a seized up (bad bearings) blower motor. It may not pull enough current to blow the fuse at the lower fan settings but does at the high one. Something could also be jamming the blower fan in its air duct.

Most blower motors can be accessed under the hood. Replace the fuse then put the blower switch on one of the lower settings (don't blow the fuse). Get yourself a good sized screwdriver and hit the back of the blower motor with the screwdriver handle a couple of times.

Sometimes (unless the blower motor has totally seized up) you can get it to spin and this will tell you for sure you need a new blower. Other than that, you can get a spare blower motor, remove the connection wires from the old motor and hook them up to the new one to test before you go to the trouble of replacing the blower.

Hope this helps you out... -Dan

Oct 14, 2009 | 2000 Ford Focus

1 Answer

I have a 2001 Ford F 250 power stroke and the A/C stopped working?? First the blower would only work on High then the blower stopped working all together. I can put the selector knob on A/C, high and when...

The blower is like a small exhaust fan and most likely the armature coils of the fan have shorted out, stopping the fan completely. You will have to replace the blower fan since repairing it wont be cost effective. A/c fuses are clearly marked so most probably the fuses you checked are the normal ones, cos the A/c fuses are bunched in one location(behind the dashboard of the Drivers side)...............sodeep

Aug 01, 2009 | Ford F-250 Cars & Trucks

1 Answer

1999 expedition 5.4L eddy bauer

check fuses,check power and ground at blower motor.if the blower has only one speed it will mean a resistor is easy test if blower is not working at all is to turn blower on hi and tap on the bottom of blower motor with hammer if the blower motor kicks in then you know the motor is the problem.if the motor still does not work,the wiring to the switch and the switch will need to be tested,if the wiring and switch are ok,then replace the blower motor.

Oct 31, 2008 | 2001 Ford Expedition

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides