Question about Chevrolet Cars & Trucks

Open Question

Need wiring diagram for the dash of a 1968 Impala SS with Tach

Have a gauge cluster going into a light cluster spot. Need wiring diagram for changeover

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 261 Answers

SOURCE: i bought a tachometer and

tach signal can be tapped either from the vehicles ecm or the ignition coil itself

Posted on Nov 16, 2008

Ad
  • 109 Answers

SOURCE: Tach,temp gauge,gas gauge intermitantly works

This problem can be tricky to solve... one thing I have run across is that some Cabrios have a factory fault that lets water leak though the firewall onto the fusebox! Needless to say this will cause any number of electrical problems due to the inevitable corrosion. The problem is fixed by inspecting under the hood directly above the fusebox (where the computer is mounted) Look for signs of debris or moisture. I have successfully repaired these with a good cleaning and the application of an asphalt based waterproofing membrane (unfortunately this was too late in some cases and neccesitated fusebox replacement!) Hope this helps... ;-)

Posted on Apr 13, 2009

  • 412 Answers

SOURCE: Instrument cluster on 97 Wrangler

IF YOU REMOVE INSTRUMENT CLUSTER AND UNPLUG IT,PLUG IT BACK IN AND UNPLUG IT AGAIN..DO THIS A FEW TIMES..IT SHOULD CLEAN OFF SLIGHT OXIDATION ON CONNECTOR TERMINALS..HAVE SEEN THIS BEFORE..I ALSO THINK REPAIR CONNECTORS AVAILABLE FROM DEALER

Posted on Jun 21, 2009

  • 295 Answers

SOURCE: Headlight wiring diagram for 2004 Chevy Impala

I would go to Alldata.com on line for your vehckle to get the wiring diagrams.

Posted on Jul 18, 2009

  • 1 Answer

SOURCE: 1995 impala ss instrument cluster went dead

Must replace the instrument cluster or send it out to be repaired.

Dr. Go

Posted on Sep 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1968 chevy impala ss blower fan relay wiring diagram


try to find a old Motors manual or Chiltons for it or ask the parts guy at a chevy dealer for it

May 12, 2014 | 1996 Oldsmobile Aurora

1 Answer

How to wire up factory tach for 70 ss chevelle with gauges


The original tachometer was powered from the negative side of the coil.
I don't know how many wires you have to work with, but the one that powers the tach should go to the pigtail wire on the harness for the coil - dist cap.

Jul 14, 2012 | Chevrolet El Camino Cars & Trucks

2 Answers

2004 Ford Taurus, Tach and fuel gauge going crazy


Ford 150 Van No Start No Crank Same problem aftermarket remote start problem !
Watch the second part too . Do you know what a wiring diagram is ? Look under dash or the hood an see where the remote start is hooked up , what wires ! You can find a wiring diagram here at http://www.bbbind.com/free_tsb.html Enter the vehicle info. year , make , model an engine size . Under system click on engine , then under subsystem click on starting . Click the search button , then on blue link . You'll see all the componets in the starter circuit .

Apr 11, 2017 | 2004 Ford Taurus

1 Answer

The car is a 1968 impala ss with full factory gauges. Problem is they dim out, go on and off occasionally, and most recently stopped illuminating the dashboard all together. Last year a simple tap to the...


You have a loose wire in the dash somewhere, if you are up to it, pull the dash panel covering the gauges and look for a loose or broken wire. A corroded terminal could also cause the problem, if so clean it up with emery paper and replace the plug side.

Jun 07, 2011 | Chevrolet Impala Cars & Trucks

1 Answer

Were dose green wire go in the group off altornater wires


your green wire in that harness goes to your temp light or temp gauge witch ever one you have

May 28, 2009 | 1983 Chevrolet Impala

1 Answer

2003 350z, my gauge cluster


if its not the wiring, it may be the fuses...check all your fuses

Apr 25, 2009 | 2003 Nissan 350Z

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...