Question about Cars & Trucks

Open Question

How to remove rear door panel on 2007 Nissan armada

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 250 Answers

SOURCE: How to remove drivers door panel on a 2007 Nissan Tiida hatchback

The door handle has a c clip behinde it that you can not see.Goto a auto parts store and thay will have a cheep tool to help you.(you need a special tool for this. The WINDOW CRANK handle has a 'c-clip' behind it. The door opening handle trim is held in by either a screw behind a plastic flap that will pop out(behind the lever)or it is held in at four points by plastic tabs (two on top and two on the bottom)that can be undone carefully with a screwdriver or the like. When this plastic trim is removed the door panel should come off.
Be aware that there are plastic clips (back side of the panel) on the perimeter of the panel that hold it in as well.
the tweeter panel just pops out look on the bottom of the door for screws and around the door handle and you will have to pop your window and door lock controls out and the reflector on the door pops out and there is two screws there then al you have is the clips behind the door they make tools for it but a flat tip screwdriver will be fine just get the tip close to the clip and pull it out .
1. Remove window crank (it has a kind of 'bent wire' c-clamp, which holds it onto the window crank shaft). 

2. Pry upwards the top plastic cover to the arm rest (this is a plastic coated foam rubber piece, on which you rest your arm). 

3. Remover the two now visible screws which fasten the arm rest onto the door. 

4. Remove the one screw fastening the inside door handle. 

5. With a blunt tool, gently hit the inside door handle in a forward direction (towards the door hinge). This will release the door handle from the door. 

6. Pry between the door panel and the door, to unsnap the snaps holding the door panel in place. 

7. Finally, lift door panel out and up to remove it from door. 

Posted on Feb 09, 2009

Ad
  • 42 Answers

SOURCE: 1991 Nissan Maxima: Removal of front driver side door panel

This is out of my haynes manual
1 disconnect negative battery cable
2 on manual window equipped modesl remove the window crank using a hooked tool to remove the retainer clip.
3 on power window equipped models pry out the armrest switch control plate and disconnect the electrical connections
4 detach the armrest pull handle retaining screw then remove the inside door handle trim bezel
5 insert a wide putty knife, a thin screwdriver or a special trim panel removal tool between the trim panel and the head of the retaining clip to disengage the door panel retaining clips.then remove the remaining door panel retaining screws at the lower edge of the door panel.
6 once all of the clips are screws are disengage detach the trim panel disconnect any electrical connectors and remoe the trim panel from the vehicle by gently pulling it up and out.
7 for access to the inner door remove the door panel support bracket then peel back the watershield taking care not to tear it. it install the trim panel first press the watershield back into place. if necessary add more sealant to hold it in place.
8 installation is the reverse of removal

Posted on Mar 20, 2009

  • 1986 Answers

SOURCE: rear door panel removal

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

  • 1986 Answers

SOURCE: rear door panel 2002 cadillac dts

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

  • 1986 Answers

SOURCE: Remove right rear door panel 2003 Buick LaSabre

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you remove the rear door panels on a 2007 Nissan Altima.


Good day Peter.

You can find some pointers here
Inside Rear Door Panel Removal or here
How to remove door panels Nissan Forums Nissan Forum
To the Nissan Forum materials, I can add that auto parts stores and eBay are both good places to get kits of tools for popping auto panels. They make it easier to get them off without gouging up the paint or the panel with a screwdriver, and with less breakage of the pins.

Good Luck!
D

Nov 23, 2015 | 2007 Nissan Altima 2.5

1 Answer

Keys and FOB locked inside a 2007 Nissan Armada. Why does it lock with the FOB inside? How do I get in???


How would it know the fob is inside? Call a lock service and they will use an inflatable bag to push door open just enough to unlock door.

Feb 22, 2015 | 2007 Nissan Armada SE

1 Answer

2007 nissan armada will changegears but will not move in reverse


Well first of all it's a gear or transmission issue, cost some $$$

Feb 18, 2014 | 2007 Nissan Armada LE

1 Answer

How do you replace a rear passenger door latch?


WHEN YOU OPEN THE DOOR THERE ARE TWO BLACK TADS REMOVE THEM TO GET TO DOOR LATCH

Sep 20, 2012 | 2004 Nissan Armada

1 Answer

Where is the body control module located on a 2007 nissan armada


Along the steering column near the dianostic link connector. lower of the instrument panel
2_26_2012_7_55_29_pm.gif

Feb 26, 2012 | Cars & Trucks

1 Answer

I need to replace a rear door handle on a nissan maxima 2007


you will have to remove the door panel.. once you do so peel back the plastic film behind the door panel then look in the door with a flash light most likely will be a 2- 10mm bolts a

Mar 27, 2011 | 2007 Nissan Maxima 3.5 Sl Sedan

1 Answer

2004 rear upper brake light how to replace


Bulbs are not servicable have to replace as an assembly.

Sep 27, 2009 | 2004 Nissan Armada

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

458 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...