Question about Jaguar XType
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Try disconnecting the battery for 10 minutes and then see if the code goes away. The info I have says the problem could be the part you replaced or the connector. You may have to test the wires to see if they are broken.
The tires would not cause this problem. But call the dealer with your Vin# about yet another cruise control recall. There are various electrical faults and false readings for all kind of sensors due to defective cruise wiring.
Let us know what you found out.
Posted on Nov 30, 2009
That is right I was haveing the same problem with my 99 mazda 626 with 139,000 miles. It started shifting crazy. Come to find out that alot of the mechanics wanted me to think my tranny was on its way out! But I showed them different. It was the transmission range sensor switch. It cost like $40 at advance auto parts. I tried to clean the original one but the problem came back. So I replaced the swich and the problem is gone! Also they dont call it a transmission range sensor in the parts stores, Its called a Neutral saftey switch! Same thing, but different prices at the dealer and parts stores. The dealer wants $70 dollars for the part!
Posted on Feb 20, 2010
You might check this site out for Jag codes. Oxygen sensors can be a sticky job, they're screwed into exhaust and can literally weld themselves in place. Plus in most cases you need special wrench/socket to get around the sensor. (they can be a real pain)
Posted on Jan 04, 2011
change the pedal sensor...thrttle is fine and will function properly as soon as its changed..make sure once you change it you turn the key to position two for 5 seconds then turn it back to position one ,then wait ten more seconds and turn the key to postion two for 5 seconds again to allow the ecu to calibrate.And make sure you unplug the neg terminal to do the install...once reconnected follow the above procedure...the crank the car.
Posted on Aug 28, 2011
Tips for a great answer:
Dec 13, 2015 | Cars & Trucks
Nov 25, 2015 | BMW Cars & Trucks
Jun 14, 2014 | Cars & Trucks
Jul 01, 2017 | Jaguar Cars & Trucks
The Engine and Automatic Transmission (not applicable to manual transmissions) in this vehicles drive train are fully electronically controlled by a computer called the PCM and TCM (Power Train Control Module, Transmission Control Module). When a problem like this or other drive-ability related problems occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM. Also always check fuel pressure for correct spec for your make and engine type.
Sep 20, 2012 | 2002 Jaguar X-Type
P0177....Fuel Composition Sensor Circuit Range/Performance
P0173....Fuel Trim Malfunction (Bank 2)
Sounds like a O2 sensor but try disconnecting the battery and joining the leads together for 5 mins and then read codes again
Feb 11, 2011 | 2002 Jaguar X-Type
P1512 Throttle Position Sensor Idle Switch Sense Circuit
P1513 Throttle Position Sensor Idle Switch Sense Circuit
P1514 Park/Neutral Position Switch High Load Neutral/Drive
P1516 Gear Change Park/Neutral Malfunction
P1517 Engine Cranking Park/Neutral Malfunction
P1607 MIL Output Circuit
P1608 Automatic Transmission
P1609 Internal ECM Error
P1641 Fuel Pump Relay No. 1
P1646 Fuel Pump Relay No. 2
P1739 Automatic Transmission
P1775 Transmission Control Module MIL Circuit
P1776 Torque Reduction Request Signal
P1777 Torque Reduction Circuit
P1780 Automatic Transmission
P1781 Automatic Transmission
P1782 Automatic Transmission
P1783 Automatic Transmission
P1785 Automatic Transmission
P1790 Automatic Transmission
P1791 Automatic Transmission
P1792 Automatic Transmission
P1794 Automatic Transmission
P1796 Automatic Transmission
as you can no such code exists for a jaguar ,contact code reader manufacturer
Jan 03, 2011 | 2004 Jaguar S Type
Dec 01, 2010 | 2003 Jaguar X-Type
Sep 28, 2009 | 2002 Jaguar X-Type
333 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: