Question about 1985 Dodge Ram 50

Open Question

1988 dodge truck 318 runs for a minute then runs rough and turns off

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
motor1258
  • 6674 Answers

SOURCE: line up of trans to motor doing clutch replacement 88 dodge ram

Leave your clutch assembly bolts loose, so the clutch plate can move as needed to line it up, then tighten them after tranny fully in place. I believe most autoparts store now will lend or rent you an alignment tool if necessary. I guess I was lucky, I always seemed to find something I could use to align it by eye.

Posted on Nov 29, 2008

Ad
  • 201 Answers

SOURCE: 1992 dodge 318 engine turns over, but no start. No

if truck has a ceramic ballist resistor near and connected to coil this could be problem or the crk posistion sensor could be too, i would change ballast first if you have on your truck appx cost $10

Posted on May 09, 2009

  • 1 Answer

SOURCE: 1988 Dodge Ram 150 318 V-8

check the starter relay or the ignition moduale which is located behind the distributer

Posted on May 10, 2009

  • 76 Answers

SOURCE: 1993 DODGE DAKOTA V8-318 5.2L EVERY 3 TO 5 DAYS

possible you ignition switch

Posted on Aug 16, 2009

  • 15 Answers

SOURCE: 1998 dodge ram pickup 318 eng.

If the engine seems to run fine over 1450 RPM maybe there is a vacuum hose leaking or EGR valve is slightly stuck open. Any help from the OBD II trouble codes? Or is there simply no MIL and no stored information in the OBD II computer read at the local parts store through the connector by the drivers knee?

Posted on Dec 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1988 v8 318 4x4 ram charger starts and runs rough then puffs white smoke out of throttle body and dies what could cause this


Have you checked youre water level? White smoke can indicate water. May be headgasket. I would also dble check valv clearances and timing for tge rough running. 180° out of timing may be the rough running too.Just go through top to bottom your work. could be wires not in correct position.

May 16, 2016 | Cars & Trucks

1 Answer

I have a 1988 dodge ram d250 with a 318 fuel injected motor that runs rough when u hit the gas and it is blowing black smoke out of the til end and i do not know why


Black smoke could indicate blow by in a cylinder or the valves might not be closing properly. Start with a compression test.

Jan 17, 2016 | Dodge Cars & Trucks

1 Answer

Edelbrock 1406


You need a subscription to the car magazines & follow
that stuff

Call Edelbrock, I'm sure they have tech people to help you

Mar 27, 2014 | 1988 Dodge B Series Cargo

1 Answer

My 1988 dodge d150 runs rough when cold and going uphills


how old is this truck ? needs complete tuneup, new air & fuel filters, wintertime brings out the all the problems, also, replace EGR valve, & PCV valve, they will choke the hell out of the engine, your filters are very important also, if there dirty/old, they will starve the engine. talk to the ole girl while you do all this work, she'll respond, I promise !!!! make sure all the vacumn lines are good, tighten all throttle body bolts, etc

Jan 30, 2013 | Dodge Ram 50 Cars & Trucks

1 Answer

Idle promblem


Sounds like you have a vacuum leak. Check all your vacuum hoses to be sure they are attached properly and also look for cracks in them

Jul 09, 2010 | 1988 Dodge Dakota

2 Answers

1988 318 ramcharger idles very rough stalls alott


EGR valve stuck or not working clean or replace

Feb 05, 2009 | 1988 Dodge D-Series Pickups

1 Answer

1989 Dodge Ramcharger that idles rough but still cranks like br..


Check your fuel filter and your carb. sounds like the you may have gotten dirt in the carb. or your floats are sticking

Jan 14, 2009 | 1988 Dodge D-Series Pickups

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...