Question about 2005 GMC Yukon Xl Denali

1 Answer

Speedometer i was with you like 5 min. ago it got somehow got disconnected

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 83 Answers

Hello, plz. give me some more details about your problem on speedometer
 

Posted on Nov 07, 2008

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you replace the speedometer cable in a 1998 chevy tracker


Removal Procedure
  1. Remove the instrument cluster assembly. Refer to Instrument Cluster Replacement .
  2. Unhook the speedometer cable from the heater case.
  3. Remove the grommet from the bulkhead.
  4. Feed the speedometer cable through the bulkhead.
  5. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
Unscrew the speedometer cable (1) from either the transfer case or the transmission. Remove the speedometer cable (1) from either the transfer case or the transmission. Remove the speedometer cable (1) from the clamp. Remove the speedometer cable (1) from the vehicle.
Instrument Cluster Replacement
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
Disconnect the negative battery cable. Remove the hazard lamps switch by gently pulling the knob straight up. Remove the instrument cluster bezel from the instrument panel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement . Remove the 4 screws and pull the instrument cluster assembly forward from the instrument panel. Disconnect the 3 electrical connectors. Remove the speedometer cable at the speedometer head. Remove the instrument cluster assembly from the vehicle.
Remove the 5 screws (2) and the steering column upper and lower covers (1, 3).
Remove the 4 screws and the instrument cluster bezel from the vehicle.

Jun 17, 2015 | 1998 Chevrolet Tracker

1 Answer

Speedometer on 04 hyudai sonata went out. Replacd speed sensor on trans axl, but didn't fix the problem. what else could be the problem?


The actual speedo head in dash. Try to disconnect battery for 30 mins. Can reset unit , make sure you have radio code fist.

Apr 06, 2013 | Hyundai Motor 2004 Sonata

1 Answer

Speedometer not working


you need to give more information for anyone to know... but I will take a crack anyway. In my expierance, I would guess that the cable to it broke, but it could be that it just got disconnected somehow. if it is digital, then it is a different deal all togather. post your trouble shooting results and I will try to help. good luck. Tim

Sep 16, 2012 | 2002 Renault Clio

1 Answer

Speedometer and odmoeter don,t work


Either the cable got disconnected somehow behind the dash, the cable broke, or the plastic gears wore out. If yours is digital check fuses.

Apr 24, 2012 | 1991 Mazda Protege

3 Answers

Battery changed on 2002 toyota camry, speedometer pegged at 140


Try disconnecting the battery again, only the + side. Wait for 3-5 min before hooking back up. Turn the switch on but not over, then start the car after a few seconds.

Jul 16, 2010 | 2002 Toyota Camry

2 Answers

My odometer, my fuel gauge, and my mileage lights not working. I cannot tell how much gas I have and how fast I am going or see the mileage lights on my van. All the fuses are fine. What now?


If you give the top of the dashboard directly above the speedometer (and gauge cluster) a nice open handed whack 2or3 times, with the key in the on position and see if the cycle on. if this is the case the 6-8 wire plug behind the gauge cluster is faulty and should be replaced. if not...Open the hood of the engine and directly in front of the driver located on the firewall a big square box mostly likely with rubber over it to protect it, with a nut directly in the middle of it, if this is lose tighten it, or if tight take it off and unplug look for corrosion on pins 46-54 these pins control your speedometer and mileage. look for corrosion. Good luck

Apr 09, 2010 | 2000 Dodge Caravan

1 Answer

Speedometer wont work


HI. If your speedometer needle doesn't move, or if it flutters, your speedometer cable may be bad.

To determine if it is the cable, disconnect the cable casing from the transmission and from the back of the speedometer on the instrument panel. Draw the cable out from inside of the casing. The cable looks like a twisted piece or wire. If the cable is broken or if it is dry or brittle. It probably needs to be replaced. If the cable is intact and the same length as the cable casing, the problem is likely the speedometer head.

I would also advise to check the speedometer gear as well.

The speedometer gear is located on the output shaft. Inspect it for damage.

This gear rarely suffers damage because the gear from the speedometer that meshes with it is usually made of a softer material. Sometimes, the speedometer gear on the main-shaft is replaceable. A clip can hold it in place or it can be a pressed fit. A special puller is available to pull these gears on the car/truck.

Mar 12, 2009 | 1989 Chevrolet C3500

1 Answer

Transmission speedometer problem


This all can be caused by a defective Vehicle Speed sensor, also called a VSS, also run a test on the computer to see if any codes are in memory that will help to sort this problem out.

Nov 08, 2008 | 1994 Pontiac Grand Am

1 Answer

Vss location on 2000 miata


VEHICLE SPEEDOMETER SENSOR REMOVAL/INSTALLATION
  1. Disconnect the negative battery cable.
  2. Drain the transmission oil.
  3. Disconnect the vehicle speedometer sensor connector.
  4. Remove the vehicle speedometer sensor.
  5. Apply transmission oil to a new O-ring and install it on a new vehicle speedometer sensor.
  6. Install the vehicle speedometer sensor. Tightening torque 69.5 - 95.4 inch lbs.
  7. Connect the vehicle speedometer sensor connector.
  8. Add the specified amount and type of transmission oil.
  9. Connect the negative battery cable.

Oct 08, 2008 | 2000 Mazda MX-5 Miata

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

106 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...