Question about Cars & Trucks
Changed battery an alternator car still shuts of when head lights are turned on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The instructions for installing a new alternator usually read to fully charge the battery (12.3 - 12.8 volt range). Otherwise, the alternator will be damaged when it initializes. I have seen some extreme damage result from installing a new alternator with a low-charge battery. The torque required to turn an alternator when damaged in this scenario is unbelieveable!
Posted on May 02, 2009
i1m sorry to say that wheel bearings are not set to a torque specification, when you have repacked the bearings [ inner and outer ] ,reassembled it ,take the nut up until thewheel starts to drag and not turn very far when you try to spin it spin it backward and forward several times,grab the top of the wheel and try to push it in and out,if you getany movement at all tighten the nut a couple of castilations. do it all over again, spinthe wheel a few times and then try for the crossways movement again, if there is no movement ,you are very close to being right....................now comes the experience bit , iwould take it one more castilation of the nut because i know the feel that is need ed,,without that i suggest you put the pin in where you ereput the cap on and go for a 5 minute drive . whenyou get back ,jack it up and thespinning of the wheel again and try for the top crossways movement ,if there is any tighten thenut 2 castilations, and provided that when you try to spin the wheel by hand with a reasonably strong push the wheel should trael about 6 inches at least after your hand leaves it ,it is now a close as you are going to get itput it all to gether and for the next day or so put yor hand on the grease cap after you have driven anydistance, and you will feel it is warm but you should be able tohold your hand on the grease cap. there you have it ,any questions come back."youdoit"
Posted on Nov 06, 2009
SOURCE: 1993 geo tracker fuel injector
ecm does control but is also based on input from the Throttle position senser. unplug the TPS and try again. Also make sure the ECM and engine grounds are good
Posted on Feb 21, 2010
A 1993 Tracker will have OBD1 technology. Just unplug the battery for 5minutes and plug it back in. If the light persists You will have to find out and repair the problem that your cars computer believes it has.
Posted on May 12, 2010
Tips for a great answer:
Dec 01, 2013 | 1991 Geo Tracker
May 05, 2013 | 1994 Geo Tracker
Apr 06, 2013 | 1993 Geo Tracker
Apr 14, 2012 | 1996 Geo Tracker 2 Door
May 05, 2011 | 1993 Geo Tracker
Jan 04, 2011 | 1993 Geo Tracker
May 11, 2010 | 1993 Geo Tracker
Nov 07, 2009 | 1995 Geo Tracker
38 people viewed this question
Usually answered in minutes!