- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
There are going to be tons of small hex-head screws holding plastic panels on. Take them all out. If you get stuck, tug on the panel and see about where its still holding on. Chances are there is a screw that you didnt see before. Dashboards suck to work on so be prepared to be very frusterated
Disconnect the battery remove the fanbelt, Theirs a bracket on the top held with 10mm headed bolts, the wire loom for the plug wires can be pushed back enough with the bolts out thiers a cover on the motor that needs to be removed and set aside. theirs two 10 mm headed bolts in the bottom of the altenator that go fronm the front into the engine thier log remove them and the altenator is loose with it moving to the front some you can remove the wires and them the altenator
I solved the problem by ordering the filter fro an online site that gave instructions:
instructions at this link are:
Turn on wipers until they are in an upright position then turn ignition off. Open the hood. The filter compartment is on the passenger side, directly beneath the windshield. Pull back weather strip and remove cowl. Slide the water shield toward the front of the vehicle then lift to remove. Replace filter and reassemble.
The cabin air filter is located under the cowl. Open the hood, proceed to the passenger side of the car and you will see where the right side wiper is resting, under the black plastic cowl there the cabin filter is.
Hello, you must turn the system off,in the trunk.Then you must support the car with jacks.With the vehicle raised the bolts on the bottom of the airbag must be removed.Put another jack under the side of the suspension you are removing.Then undo the shock and it should come out.Then dis connect the air line and remove the airbag.