Question about Cars & Trucks

Open Question

Overheating suzuki forenza 2005

Replaced thermostat, cylinderhead, headgasket and the beauty is still overheating.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

husni_g2002
  • 112 Answers

SOURCE: suzuki forenza thermostat 2004, 56000m

yas you can, drain the cooling system,disconnect the radiator hose at the thermostat housing cover , undo the two bolts and lift off the thermostat housing cover and gasket, withdraw the thermostat from housing, ri-fitting is the reverse sequence to removal , but use a new cover gasket and ensure that the thermostat is fitted with the jiggle pin uppermost . fill the cooling system .

Posted on Jan 20, 2009

  • 31 Answers

SOURCE: 2005 Hyundai accent overheating, radiator

A car can overheat for a lot of reasons.First make sure this is the problem by checking the radiator hose or water level. Open the radiator cap when the car is cold, crank it, and then watch the water level. If it drops when the car warms up this is not the problem.
The tools you will need will depend on what you have to take off to get to it. If you can access the thermostat you should only need a ratchet or wrench to remove it and something to scrape off old gasket with.
Location:The thermostat should be inside the thermostat housing on the motor. Follow your top radiator hose to the place where it goes into the motor. There should be a sort of dome shaped housing there with probably a bolt on either side of it.The thermostat is inside that.
This is a reasonably easy job, but shouldn't be done carelessly. It's also kind of messy.
When the car is cold remove the bolts from the housing with a ratchet. Lots of coolant and water will drain out. But the thermostat will be visible.Pay attention to which side of the thermostat is up.It should just lift up. Remove all the old gasket from around the area and clean it up well. Replace the thermostat and gasket then the bolts. Be very careful not to over tighten the bolts or the housing will be ruined.

Posted on Apr 22, 2009

  • 33 Answers

SOURCE: p0496 engine code 2005 suzuki

The ECM or computer needs a reflash done to it. The code is for the EVAP system. Takes over a hour to check the EVAP system and to reprogram the computer. Then the idle speeds need to be relearn. I know, I work on them. Don

Posted on Jul 25, 2009

  • 90 Answers

SOURCE: I WANT TO KNOW THE TIMING MARKS FOR SUZUKI FORENZA

just mark the pulleys with tip-ex ,same thing and youd be finished in half the time

Posted on Feb 21, 2010

tgv1501
  • 870 Answers

SOURCE: where do you put transmission fluid in my 2005

it goes from the dipstick. Can you locate the dipstick?

Posted on Dec 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuse relay radiator fans


If the vehicle is not overheating then do nothing. There is a chance that the system is controlled by the vehicle computer and the fans in some vehicles only come on when the engine is under load, like when it's actually moving. Maybe sitting stationary and not working the engine it is normal for the fans not to run.

Nov 10, 2013 | Suzuki Forenza Cars & Trucks

1 Answer

2006 suzuki forenza keeps overheating have had the water pump replaced and the thermostat and gaskets.


Sounds like a leaking head gasket. The gasket may have been damaged when the engine ran hot the first time.
You should not need to add coolant, so it has to be going somewhere.

Jun 25, 2013 | 2006 Suzuki Forenza

1 Answer

Idle fluctuates when I stop at a stop sign or light


I had the same problem in my 2006 suzuki forenza, it ended up being that my valve cover gasket was leaking engline oil all over the place, into my spark plug reservoirs and everything. When my husband replaced the gasket and cleaned all of the oil that had leaked into my spark plugs and reservoirs the problem was solved, now it runs beautifully!! Good luck

Apr 04, 2013 | 2005 Suzuki Forenza

1 Answer

2005 suzuki forenza changed thermostat still runs hot top hose is hot bottom hose is cold and no hot water to the heater coree


check thermostat may have put it in rong it will make a difrence also make sure all your belts are spinning may have bad pully and not spinning water pump

Mar 02, 2012 | 2005 Suzuki Forenza

1 Answer

How to change thermostat on a 2005 suzuli forenza


you remove the rad hose on top of the engine and pull the thermostat out and replace it and reconnect the hose

Jun 02, 2010 | 2005 Suzuki Forenza

1 Answer

Is the thermostat located at the end of the upper radiator hose on a 2005 Suzuki Forenza?


Hi!!

It sounds about right, but you need to remove the thermostat housing, (the part where the hose goes into), to remove the thermostat.

Don't forget to rate this post. Good Luck!!

May 14, 2010 | 2005 Suzuki Forenza

1 Answer

2005 Suzuki Forenza AC leaking


the dealer is right, replace cycling switch, and look for cracked ac/heat case

Sep 15, 2009 | 2005 Suzuki Forenza

1 Answer

Overheatin gin my 2004 suzuki forenza change the therstat in it


Most likely cause of this is a clogged thermostat. Especiallly if you've ever used a sealer in the past, the thermostat clogs with age and a bad thermostat will tend to back up and fill your reservoir tank. Best of luck with this situation and I hope you've found this post a solution to your problem. All the best!
Greg

May 13, 2009 | 2004 Suzuki Forenza

1 Answer

Suzuki forenza thermostat 2004, 56000m


yas you can, drain the cooling system,disconnect the radiator hose at the thermostat housing cover , undo the two bolts and lift off the thermostat housing cover and gasket, withdraw the thermostat from housing, ri-fitting is the reverse sequence to removal , but use a new cover gasket and ensure that the thermostat is fitted with the jiggle pin uppermost . fill the cooling system .

Jan 19, 2009 | 2004 Suzuki Forenza

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

156 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...