Question about Cars & Trucks

Open Question

WHAT IS THE CORRECT IDLE SPEED FOR A 1999 NISSAN ALTIMA WITH A 4 CYLINDA 2.4L ENGINE

Posted by on

  • carl Feb 15, 2012

    The proper idle speed is 700 rpm in neutral with all accessories turned off. good-day !

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
ilragatzzo78
  • 241 Answers

SOURCE: Replacing a starter for a 1999 Altima

  1. Disconnect battery ground cable.
  2. Disconnect starter wiring from starter.
  3. Remove starter retaining bolts and the starter.
  4. Reverse procedure to install.
the bolts should be on the drivers side.
you will have to crawl underneath the car to do this task

Posted on May 15, 2008

Ad

SOURCE: 2003 Nissan Altima?

Where is the sensor placed on the car?

Posted on Oct 07, 2008

  • 5 Answers

SOURCE: my 1995 Nissan Altima idles rough when at a stop

change ur Airflow sensor buddy. thats the only problem. And if yet it doesnt work then check ur crank sensor....

Posted on Aug 04, 2009

  • 1 Answer

SOURCE: how many engine mounts on a 2003 nissan altima 4

I TOOK MY CAR TO GET AN OIL CHANGE AND WAS TOLD THAT MY CAR HAS 3 MOTOR MOUNTS. I HAVE A 2003 NISSAN ALTIMA ALSO

Posted on Dec 27, 2009

  • 2 Answers

SOURCE: heater blows cold air at low speed and idle

I worked at a Nissan dealer for 18 months and we'd get a lot of these in. The cold heat at idle is accompanied by a sloshing noise from behind the dash - you've got an air pocket in the heater core. What we used to do was lift the front end of the car about 3 feet off the ground using the hoist and take the rad cap off. Then we'd run the engine at a fast idle (jam a screwdiver against the throttle stop to hold it fast or put a slight weight on the pedal if it's Electronic Throttle Body. Run the heater on full heat and the engine like this. You'll see the rad 'burping' as the air in the cooling system travelling to the highest point it can - the open rad cap. Top up with a 50/50 mix of coolant and water as you go. When it burps no more, you have a full cooling system and should not suffer any more "cold heat".

If you do this yourself, PLEASE use jack stands, block the back wheels and put the parking brake on!!!

answer from a Nissan mechanic, (not me)

Posted on Dec 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I locate ignition coil #3 on a 2005 Nissan Altima 4 cylinda?


on top of the engine remove the plastic cover depending on which model you will have 1. a coil pack for all 4 cylinders so you change the whole part or maybe 2. 4 seperate coils if so no.3 is 3rd from front of engine or 3rd from drive belt end as you look under hood

Apr 04, 2017 | Nissan Cars & Trucks

1 Answer

Adjust idle sensor 2005 altima nissan 4 cylinda


You mean adjust idle air volume? You will need Consult II,III for do it properly.If you can;t get it,try manual idle air volume learning: http://nissanhelp.com/diy/altima/projects/nissan_altima_idle_air_volume_learning_procudure.php

Jun 11, 2014 | 2005 Nissan Altima

1 Answer

My 96 nissan altima dies at idle


Could be a dirty throttle body, vac leak, or a defective idle air control valve. The computer adjusts idle speed by controlling the amount of air entering the throttle body via the control valve.
Is the check engine light on ?

Dec 24, 2012 | 1996 Nissan Altima

1 Answer

94 nissan altima won't start and iddle after cleaning IACV valve


An IAC (idle air control) motor is designed to adjust the engine idle RPM speed by opening and closing an air bypass passage inside the throttle body. The cars computer or PCM (powertrain control module) receives information from various sensors and will output signals to adjust the idle air control motor in or out to adjust engine idle speed by controlling engine idle air. An idle air control motor can fail one of two ways, either the motor short circuits and stops working or the motor will develop high resistance and cause the idle air control motor to react slowly, either failure can cause the engine to stall at idle. When a trouble code scan is performed it sometimes won't always detect a failed or weak idle air control motor.

Oct 08, 2012 | Nissan Altima Cars & Trucks

1 Answer

I have a 2005 nissan altima, the service engine light came on, the tach ometer goes up and down, when pressing on the excelerator the car will jump, the service engin light came on, the code read speed...


Is the car idling high? It sounds like air control valve has gone bad..just a though. I know when a car isn't idling right, its usually that idle air control valve or a vacuum leak

Jun 17, 2011 | 2005 Nissan Altima

1 Answer

99 nissan altima engine stops when idling


What is the idle speed? You may need to adjust it, it should be around 800.

Jun 11, 2011 | 1995 Nissan Altima

3 Answers

My 2005 altima idles high and engine code


This P0507 code is one that's sometimes triggered on vehicles that have electronic throttle control. That is, they don't have a regular throttle cable from the accelerator pedal to the engine. They rely on sensors and electronics to control the throttle. In this case, the P0507 DTC (diagnostic trouble code) is triggered when the PCM (powertrain control module) detects an engine idle speed that is greater than the desired (pre-programmed) RPM. In the case of GM vehicles (and possibly others) if the idle speed is over 200 rpm higher than expected, this code will be set.

Jun 07, 2010 | 2005 Nissan Altima

1 Answer

Engine dying


MY BACK LIGHTS DOENT TURN OFF WHEN I LOOSE THE BRAKE AND STAYS ON ALL THE TIME WHAT CAN CAUSE THIS

Jul 11, 2008 | 1999 Nissan Altima

Not finding what you are looking for?

Open Questions:

Cars & Trucks Logo

Related Topics:

189 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...