Question about 2005 Pontiac Montana

Open Question

How to disconnect 2005 pontiac montana door chime

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 98 Answers

SOURCE: My 1999 pontiac montana rear sliding power door will not work

I went to bulldogsecurity.com and looked up the wiring diagram for this vehcle. However, prior to checking this part, I would check to see if you have a blown fuse. It doesn't hurt and only takes a few minutes. There should be a fuse for that either somewhere on the side of the dash or near the brake pedal area. If not it may be under the hood, but it should be inside the vehicle. You may have multiple fuse boxes. If it has (2) sliding doors it will have a wire for the auto doors in each kick panel (under the plastic trim/molding) when you open the door and look down you will see all of the trim/molding it should snap out or may be held in place with a screw or (2). Once you remove that you should see the wires. It says for the left side it is either light blue or black and the right side is definitely light blue. Trace this wire until you find out where it ends (the motor or switch to control the auto doors) Then test the switch/motor to see if it is bad.

Posted on Mar 02, 2009

  • 50 Answers

SOURCE: 04 pontiac montana sliding doors no longer work

the sliding doors on montana assuming there power have a electrical harness on the bottom track that break and jam the doors but unlikly both have this problem do the doors lock @ unlock if not check switch at drivers door

Posted on May 27, 2009

wireguy212
  • 1627 Answers

SOURCE: I have a 2005 pontiac Montana. The heat in the

Get the heater core flushed for the front heater,if the valve in the upper heater hose actually moves.

Posted on Nov 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

06 montana chime wont stop out of park all doors shut tight


Might have a door switch bad is bad or wiring to one of the switches. I would begin by checking if there are any blown fuses. Would then check wiring to each door, along frame inside a rubber boot where door hinges are. If wiring is all good, I'd then move on to removing door panels and disconnecting each door latch harness until the chime goes off. This will indicate the specific switch that is bad. If all are good.

Nov 06, 2016 | 2006 Pontiac Montana

1 Answer

2005 PONTIAC MONTANA KEY IN IGNITION SECURITY PROBLEM


if the car does not start and the security light is on maybe check out this site.... I have bought a part from them and it fixed my issue.. if u r unsure email them they have great customer service.. also ifn its what I think it is you can install the part yourself

Jul 27, 2014 | 2005 Pontiac Montana SV6

1 Answer

2005 pontiac sv6 door alarm chimes all the time. how can I disable or bypass the chime?


On my '07 Montana SV6 was the same problem, I've fix it by moving up to 3 mm. contact plate at the body frame of the rihgt sliding door. If you check the spots on the plate where pins from the door comes to this plate, you will see that they contacting not in a middle. There are two ways to fix: move down pin unit in the door or move up contact plate on frame. For me second way was better. It's manufacture mistake comes sinse 2005 and on right door only.

May 24, 2011 | 2006 Pontiac Montana SV6

2 Answers

2003 remote control for 2005 van?


Transmitter Programming
If you lose a transmitter, program the old and new transmitter(s) into the remote control door lock receiver's memory. Up to 4 transmitters may be programmed.


Important
Once the remote control door lock receiver enters the programming/diagnostic mode, the programming of the first transmitter erases all previous transmitter programming information, requiring the programming of all transmitters.

Program only 1 vehicle remote control door lock receiver at a time. If more than 1 receiver is being programmed at the same time, it is possible that the same transmitter could be programmed to more than 1 remote control door lock receiver.


Perform the following steps in order to program the transmitter:

Remove the ignition key from the ignition lock cylinder.
Remove the BCM PRGRM fuse from the fuse panel. Refer to Fuse Block in Wiring Systems.
Close all of the doors.
Close the liftgate.
Turn the ignition lock cylinder to ACC.
Turn the ignition lock cylinder to OFF, and then back to ACC within 1 second.
Open and close any vehicle door. A chime will be heard when the system enters the BCM programming/diagnostic mode.

Important
After 7 seconds, a chime may be heard confirming successful synchronization. It is necessary to wait approximately 14 seconds for a second chime that will confirm successful programming.


Press and hold the transmitter LOCK and UNLOCK buttons simultaneously for 14 seconds.
Repeat the previous step on each additional transmitter to be programmed.
Remove the ignition key from the ignition lock cylinder.
Install the BCM PRGRM fuse back into the fuse panel. Refer to Fuse Block in Wiring Systems. IF THIS WAS HELPFUL,PLEASE RATE,THANK YOU

Jul 15, 2010 | 2005 Pontiac Montana

1 Answer

2002 pontiac montana, door chime keeps going off, even when the car is in park and locked.


Hi Daviesri,

While the chimes are going off, check each door switch, including the hatch. You're looking for an irregularity. Press each in manually as far as you can go. One of them is remaining in contact when it should be open (the switch not the door).

This will locate the problem switch. It's usually the mount, not the switch itself that's the problem

Best regards
Mike

Dec 09, 2009 | 2002 Pontiac Montana

2 Answers

Program my garage door opener on my pontiac montana 2005


you probably have a garage door opener that changes the code after each opening. I had to push a button on the door motor and then run to the car and push the opener button within 15 seconds. Your car salespwrson is usually an expert at this.

Mar 21, 2009 | 2005 Pontiac Montana SV6

2 Answers

Noise when turning the key to start my 2005 Pontiac Montana


the only thing that i can think of is the auto door locks engaging

Mar 05, 2009 | 2005 Pontiac Montana

1 Answer

2005 Pontiac SV6 Montana key fob unlocks doors but will not lock


For the sliding doors you need to clean the contacts, there are 6 or 8 on both sides, just wipe them clean as they are probably covered in oil/grease/grime.

Feb 12, 2009 | 2006 Pontiac Montana SV6

1 Answer

2005 Pontiac Montana radio Fuses


try checkig the wres to the alternator one might not be ground right

Jan 05, 2009 | 1999 Pontiac Montana

Not finding what you are looking for?
2005 Pontiac Montana Logo

Related Topics:

533 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...