Question about 2006 Chevrolet Trailblazer

Open Question

Brake light fuse for 2006 trailblazer

Both brake lights do not work but the thrid brake light does

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
reichweinj
  • 71 Answers

SOURCE: 2006 Chevy Trailblazer Tail Lights

There was a recall on this, take to the dealer and they will replace the whole socket on this.

Posted on Nov 10, 2008

Ad
DAD5bbbbg
  • 111 Answers

SOURCE: 2004 Chevrolet Trailblazer brake light doesn't work

If the other side is working, then it will not be a fuse problem. more then likely it is a grounding problem or there is a short in the wire. Take a test light and check and see if you are getting a hot wire to the brake light. If it is hot then it is a grounding problem. Make sure that the bulb is in the right way and look for any corrosion where the bulb goes and clean it out.

Posted on Mar 03, 2009

  • 255 Answers

SOURCE: No rear brake lights on 2006 silverado

brakelight switch above brake pedal. sounds like the prob.at this point.

shack

Posted on Apr 18, 2009

  • 121 Answers

SOURCE: 2006 chevy trailblazer heater blower motor not working

You might wanna check and make sure the heater switch didn't go bad. It could even be the blower motor itself.

Posted on May 06, 2009

  • 1 Answer

SOURCE: 2003 trailblazer brake lights do not

  1. Did you get this fixed because I am having the exact same problem.

Posted on Dec 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Brake lights do not work.


Are the brake lights the ONLY lights that do not work? Does the third (high mount) brake light work when you apply the brake pedal?
The Hummer H3 is basically a Chevy Trailblazer in Hummer clothing.. so the first place to look is the brake light fuse. If it is good, then check for power at the brake light switch mounted near the top of the brake pedal pivot area. Also be sure that the bulbs themselves are OK.

Jul 11, 2013 | 2006 Hummer H3

1 Answer

Brake light s not working but third light does. and flashers work


Does the 3rd brake light turn off & on with the stomp of the brake pedal?Do the normal running light work?Their is more then one location for fuses for this vehicle.. did you check them all?One is located in the engine compartment far as I know it does not have a separate fuse for rear brake lights.The second one is of course under the dash.The thrid is a rear power distribution box located near the spare tire... btw other fuses could cause this issue like towing light fuse possibly.. so make sure you check them all. Of course start with brake lights first.

Nov 22, 2011 | 2001 Lincoln LS

1 Answer

2006 trailblazer ac only blows on #5 speed. Replaced blower resistor & control panel. Also on any lower speed ip lites up i.e. abs, traction control,e-brake &seat belt?


****, you can check some more but from what I am reading your problem could be related to a faulty ignition switch. I am sending you a copy of some fixes.. you can compare to your condition..
Best of Luck to you..

2006 Chevrolet Trailblazer LS 4.2L, Vin S, Eng Cfg L6
Customer Concern: No blower motor function. AntiLock Brake System (ABS), Red Brake Warning Light (RBWL), Traction lights all on. Radio does not work. Tests/Procedures: 1. Check for battery voltage at fuses #31 and 39 in Rear Fuse Box under the rear seat.

2. If the voltage value is less than battery voltage, check the Orange wire at the 48 cavity connector located at the base of the steering column at pin D1.

3. If the voltage is low at C201 check the voltage at pin "G" of the ignition switch.


Potential Causes: Ignition Switch


2006 Chevrolet Trailblazer LS 4.2L, Vin S, Eng Cfg L6
Customer Concern: ABS, Low track light comes on intermittently. The heater blower motor quits running, 4WD not working. No communication with the ABS. If you disconnect the ABS computer and plug it back in, it may work. Tests/Procedures: 1. Test voltage at HVAC 30A, 4WD 15A, HVAC 1 10A, BRAKE 10A, TBC RUN 3A labeled fuses in the rear fuse block during the problem.

2. Inspect connector 101 38 cavity connector mounted along the underhood bussed electrical center. This harness may be routed tightly around the underhood fuse block, causing chafing or connector terminal contact that could induce any of the concerns listed.

3. Clean and secure ground G110 located on the lower left side of the engine block. Potential Causes: Damaged Circuit 300
Damaged Connector C101
Improperly Installed Engine Compartment Harness
Malfunctioning Ignition Switch

Aug 26, 2011 | 2006 Chevrolet Trailblazer

1 Answer

2006 Chevy Trailblazer...the top "third"


Brake light problem - if bulbs and fuses (#34 and #43 in rear fuse panel) are good, then only other possibility are the circuit boards where all the tail lights are located.

Noise coming from rear is the mode control actuator in the rear HVAC unit, it is trying to move a stuck blend door.

Aug 06, 2011 | 2006 Chevrolet Trailblazer

1 Answer

Chevy trailblazer 2006 brake fuse number for brake lights


There are two fuses for the brake lamps system. In the underhood fuse panel, fuse #12 (25A) and in the rear fuse panel, fuse #34 (15A)

Jul 11, 2011 | 2006 Chevrolet Trailblazer

1 Answer

The brake lights on my 2006 trailblazer are not working, all others lights blinkers etc are working, checked and replaced bulbs and fusses


Thanks for choosing FixYa Rick and welcome. You probably have a bad brake switch. It is located right above the brake pedal in the cab. The pedal hits the switch and activates the brake lights. It is a round looking chrome cylinder usually. Change it and the brakes should work. It cost 10$-30$.

Apr 24, 2011 | 2006 Chevrolet Trailblazer

1 Answer

Brake lights don't work on 2006 trailblazer


check the little switch behind the brake pedal, known as a brake switch

May 27, 2009 | 2006 Chevrolet Trailblazer

1 Answer

'06 trailblazer tailight won't work but the brake light does work....any suggestions??


does your park light working if it is working then check the bulb maybe it is busted. if the park light is not working check the fuse. if the fuse is ok then check your switch.

Apr 29, 2009 | 2006 Chevrolet Trailblazer Ext

1 Answer

2006 chevy trailblazer heater blower motor not working


You might wanna check and make sure the heater switch didn't go bad. It could even be the blower motor itself.

Apr 20, 2009 | 2006 Chevrolet Trailblazer

1 Answer

2006 Chevy Trailblazer Tail Lights


There was a recall on this, take to the dealer and they will replace the whole socket on this.

Nov 06, 2008 | 2006 Chevrolet Trailblazer

Not finding what you are looking for?
2006 Chevrolet Trailblazer Logo

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...