Question about 2000 Chrysler Sebring
This problem is caused by a leaking hydraulic pressure valve in the Active ABS system you van is equipped with. The ABS produces its own pressure and can apply the brakes with no brake pedal input from the driver, so the system has pressure always, if the valve that supplies brake pressure doesn't seal the brakes can lock up. You must most likely replace the ABS hydraulic control module under the hood to correct this. They sell them as rebuilt units at parts stores like Napa and Carquest.
Posted on Feb 16, 2012
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
According to the Chrysler manual the heater/AC control unit bulbs can only be serviced by an "authorized service center after removal from vehicle" If your comfortable taking it apart to look anyway it probably can't hurt.
Posted on Mar 26, 2009
check to make sure all vacuum lines are on especially the one behind the throttle body also get a digital volt meter and check out your throttle body position sensor and also ask yourself when was the last time the fuel filter was changed
Posted on Feb 06, 2009
If you are getting clear liquid, with the A/C on, then you have a clogged drain tube. If it is green or reddish, you have a bad heater core. Should be able to have someone blow out the drain tube to clear it out.
Posted on Jun 11, 2009
me too! - looking at fuse #5 red 10 Amp one but has black thing on it.
Can't get if off..
Have read the manual is wrong and to use panel on side of fuse box for fuse locations...
Posted on Jun 24, 2009
check the fuse panel for weak or blown fuse in the wiper/washer circuit if that all checks ok then using a test light or volt meter then find the washer pump leads at the bottom of the washer pump itself and with the circuit activated make sure you have 12 volts going to it also check the ground wire to it to insure proper ground if voltage is present then remove the motor assembly from the washer housing and relace the motor
Posted on Jan 23, 2010
Testimonial: "Quick, informatve response...perfect & thanks!"
Tips for a great answer:
Aug 11, 2016 | Chrysler Sebring Cars & Trucks
Jul 14, 2016 | Chrysler Sebring Cars & Trucks
Jan 31, 2015 | Chrysler Sebring Cars & Trucks
Oct 24, 2012 | 2000 Chrysler Sebring
Aug 11, 2012 | Chrysler Sebring Cars & Trucks
Dec 04, 2011 | 2004 Chrysler Sebring
Sep 25, 2010 | 2001 Chrysler Sebring
Feb 03, 2010 | 2002 Chrysler Sebring
Jun 11, 2009 | 2000 Chrysler Sebring
313 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: