Question about Cars & Trucks

1 Answer

How do I remove the glove box door from my 2000 Dodge Ram 1500?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 12,223 Answers

  • Have the air conditioning system discharged at a dealer service department or auto AC repair facility. Drain the cooling system by removing the plugs under the radiator and then the engine block, draining the coolant into a clean container. Disconnect the negative battery cable.

  • 2

    Disconnect the heater hoses at the engine compartment's right side at the firewall by sliding the clamps away, then plug or tape shut all the openings. Disconnect the accumulator and refrigerant lines to the AC accumulator and mounting bracket, then detach the accumulator and its mounting bracket from the firewall.

  • 3

    Remove the instrument panel from inside the truck. With the front wheels turned forward and the steering column locked, remove all trim and kick panels along the door frames. Then lower the steering column and remove its covers and the instrument cluster, glove box, cup holders, all electrical connectors and panel fasteners. Lift the panel out through the front door.

  • 4

    Remove the Powertrain Control Module from the engine. Carefully disconnect the three to four electrical connectors on the module, then remove the module's mounting bolts.

  • 5

    Disconnect the two nuts on the studs mounting the heater unit in the engine compartment. Disconnect the electrical connector to the blower motor resistor from the interior of the truck along with the connector and vacuum hoses from the heater unit. Remove the mounting nuts and bolt to the unit from the interior and remove the heater unit.

  • 6

    Remove the two retaining screws on the heater core, located at the top of the two lines on the core that form a triangle. Pinch the release tabs on the upper corners of the heater core and lift the core from its housing


    sincerely. God bless you


    ernesto cuadra

    managua, nicaragua

  • Posted on Feb 15, 2012

    6 Suggested Answers

    6ya6ya
    • 2 Answers

    SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

    Hi,
    a 6ya expert can help you resolve that issue over the phone in a minute or two.
    best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
    the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
    click here to download the app (for users in the US for now) and get all the help you need.
    goodluck!

    Posted on Jan 02, 2017

    SOURCE: 2000 dodge ram 1500 speed sensor location

    Hi my name is Allen!

    The sensor you are looking for is located in the rear diff housing, its mounts on top of the housing it is also used for ABS if equipped.

    For further asistance you may reach me through FixYa!

    Posted on Dec 27, 2008

    • 1 Answer

    SOURCE: remove front axle from differential on 2003 dodge ram

    That works fine on a relatively new vehicle but one that has run in salt etc you'll save a lot of time if you remove the steering knuckle completey by separating lower ball joint and outer tie rod end ball joint and bring the whole steering knuckle to a bench to separate the hub/bearing. Soak everything with penetrant, loosen the bolts a few turns and try hitting right on the bolt heads. I also made a very sharp wedge from a chisel and rammed it hard on the other side to seoarate the hub. It will finally come apart then you'll see all the **** that was binding it due to an alumininum knuckle re-acting with a steel hub. Clean the hole and grease everything and fit new bearings

    Posted on Feb 15, 2009

    • 114 Answers

    SOURCE: fuel filter removal for dodge ram 1500 2003 model


    The combination fuel filter and fuel pressure regulator is used on all engines. It is located on the top of the fuel pump module. A separate frame mounted fuel filter is not used with any engine.
    Both fuel filters (at bottom of fuel pump module and within fuel pressure regulator) are designed for extended service. They do not require normal scheduled maintenance.

    Posted on Mar 22, 2009

    • 593 Answers

    SOURCE: Remove headlight assembly from a 2001 Dodge Ram

    On the upper grill side of the headlight assy. there
    should be 1 or 2 push pins that hold the seal on the
    headlight assy to the front of the fender. Also check
    for a guide/push pin on the inner top of the assy on
    the outer fender side. That should be all there is to
    hold the headlight in place. Hope this helps.

    Posted on Apr 10, 2010

    • 1 Answer

    SOURCE: The lower glove box on my 2009 Rav4 won't close.

    I had the same problem with my 2009 RAV4 lower glove box. I removed the box by popping the top front right post and then the top left front post from theside housings by prying them free with my fingers. They pop out easily. I then let the box fall open and while holding it level to the floor, pulled forward, released the piston from the post on the right, and the glove compartment came out without tools. There was a plastic electrical box cover, which came loose behind the glove box, blocking it from closing. I snapped the cover plate back in place and then reversed the glove box removal process. It took a few minutes and I needed no tools.

    Posted on Dec 20, 2010

    Add Your Answer

    Uploading: 0%

    my-video-file.mp4

    Complete. Click "Add" to insert your video. Add

    ×

    Loading...
    Loading...

    Related Questions:

    1 Answer

    How do you remove the air bag door on passanger side on a 2001 dodge ram 1500


    Remove the glove box liner and behind it are studs I think with nuts, remove them. DISARM THE SYSTEM FIRST!!!!

    Nov 19, 2016 | Dodge Cars & Trucks

    1 Answer

    How do you remove the passenger side airbag cover in a 2001 dodge ram 1500 truck


    Remove the glove box and then remove the fasteners to take out the airbag .

    Feb 12, 2015 | 2001 Dodge Ram 1500 Truck 2WD

    1 Answer

    Location of fuse box Ram 1500


    Depends on the year of your Ram 1500; there is one under the hood, and 1 or 2 others inside the cab. One of the locations is at the end of the dash, you can only access it when you open the door all the way; another (depending on the year) is behind the passenger side kick panel; another (again depending on year) is behind the glove box; you don't have to take the glove box out to get to it.

    Nov 07, 2014 | Dodge Ram 1500 Cars & Trucks

    2 Answers

    Where aux fuse panel for 99 dodge ram 1500


    Check the Owner's manual. it could be located under the dash, in the glove box or under the hood.

    May 25, 2010 | 1999 Dodge Ram

    1 Answer

    Remove dash to get to sensore for blower on 2002 dodge ram 1500 the blower only works on high


    If the blower motor is only running on high the problem is the blower motor resistor. location for resistor is behind the glove box. Remove all items in glove box. remove glove box from dash and to the left of the blower motor you will see a electrical plug, remove the plug and the resistor mounting bolts. remove the resistor and replace it with new resistor. reinstall all items as you have taken them off. hope this will help you.

    May 12, 2010 | 2004 Dodge Ram 1500

    1 Answer

    What is the towing capicity of a 98 Dodge 1500 4x4 with 5.2 V8


    This Information you ask for Is On the Vehicle Information Tag on door or Door JAM and Also In the GLOVE BOX

    11,000 GVW Cab and Chassis

    Jan 05, 2010 | 1998 Dodge Ram 1500 4WD

    1 Answer

    2004 dodge ram 1500 hemi, battery drains overnight


    ck. glove box ,, @ night see if you can se any light coming from around the edges ,, with door closed ,, try opening it slowly see iff it is staying on ,,, also under hood light

    Nov 16, 2009 | 2004 Dodge Ram 1500

    1 Answer

    How do you replace the heater core?


    should be under dash behind glove box, remove hoses and glovebox open panal and remove core. berrydalewolf

    Oct 27, 2009 | 2004 Dodge Ram 1500

    1 Answer

    Rear door power lock--1996 Dodge Ram van (Roadtrek)-- won't open


    Check all of your dash fuses inside the glove box if these are fine. Remove the door panel nd check to see that the wires have not come loose they tendto come loose from closing the rear door.

    Mar 13, 2009 | 1996 Dodge Ram 1500 Club Cab

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    189 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Cars & Trucks Experts

    yadayada
    yadayada

    Level 3 Expert

    74896 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22095 Answers

    Randy Ohler

    Level 3 Expert

    14585 Answers

    Are you a Car and Truck Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...