Question about 1996 Pontiac Grand Am

1 Answer

1996 grand am with high idle

I have a 96 grand am replaced thermostat and in the process took off housing unti to fuel injector. when put back together it now idles high can not get idle to lower. Any suggestions on adjusting idle

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Guru:

    An expert who has written 7 tips or uploaded 3 video tips

  • Master
  • 674 Answers

You need to look around a listen with the engine running for a vacuume leak. could be just a hose that came off or a cracked hose or cap missing
good luck
paul

Posted on Oct 25, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can I fix a 96 jeep grand Cherokee with 4.0 has rough idle and is hesitant until it reaches operating temp. but sets no codes?


Check the condition of spark plugs, if dirty or oily could be the timing gear or timing, wouldn't show a code, if plugs are white suggests lack of fuel, also no code . ( injector cleaner and ethanol remover for the latter ). Repair shop for timing.

Sep 14, 2014 | 1996 Jeep Grand Cherokee

1 Answer

96 s10 blazer idles high and stalls after tune up and replacing spider injector


Check the air filter box for fuel lying in it then pull the vacuum hose off of the map sensor and see if any fuel runs out of it.If you see fuel in either of these or both of them then replace the fuel pressure regulator.

Jun 10, 2012 | 1996 Chevrolet Blazer

1 Answer

I have a 96 grand cherokee. I could get it


When you floor the gas does will it start?

Apr 10, 2010 | 1996 Jeep Grand Cherokee

2 Answers

96 jeep grand cherokee starts but wont idle


CHECK FUEL REGULATOR ON FUEL INJECTOR RAIL,&ALSO FUEL PUMP, CHARLIE

Feb 21, 2010 | 1996 Jeep Grand Cherokee

2 Answers

96 buick lesabre was running fine but dies at stops


First thing to do is chg. fuel filter and then do a fuel pressure test, i know you said you have heard of people wasting money on fuel pumps, but it is a common problem on G.M. products. Even if it turns out not to be the problem at least you can eliminate that and your only out a few bucks. If it was water in the fuel why did it take 60 mi. to show up, unless you just put gas in it a couple of blocks from your house, and also if it were an injector it would only miss on one cyl. like a fouled plug, and most likely the chk. engine light would come on, and you maid no mention of that.

Jul 27, 2009 | 1996 Buick Century

1 Answer

96 mercury loses power going up a steep grade


It may be a leaky injector. The injector is connected to the bank. 1 of 2 fuel rails.

Jul 01, 2009 | 1996 Mercury Grand Marquis

2 Answers

96 grand cherokee crank no start, no spark from


have the crank sensor replaced this controls the spark and injector pulse it is located on the drivers back side of the engine above the transmission housing!

Jun 08, 2009 | 1997 Jeep Grand Cherokee

1 Answer

3.1 engine 96 misfires trough driving speeds and idle


i had a 94 that ran into problems like that with very rough idles and misses. i get about five different codes from injectors to oxygen sensor. turned out my negative wire from the battery was so corroded inside the insulation it was causing all sorts of problems. bought new cable and ends from canadian tire $40.00 and installed (had to clean the connection to the block with sand paper) but fixed all my problems after that.

cheers

Apr 15, 2009 | 1996 Pontiac Grand Am

1 Answer

My 96 Grand Am wont start but it makes noise


check all the ignition supply wires and yes the plugs could be the problem if you had an injector problem it could have fouled out some plugs

Nov 08, 2008 | 1996 Pontiac Grand Am

Not finding what you are looking for?
1996 Pontiac Grand Am Logo

Related Topics:

200 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

63242 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...