Question about 2000 Jeep Grand Cherokee
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Code 54 - Mixture Control (MC) solenoid is shorted or the ECM is faulty.
Fuel Injected Engines:
Code 54 - Camshaft (or distributor sync.) reference circuit - No camshaft position sensor signal detected during engine rotation.
Hope this helps
Posted on Jul 14, 2008
You can do one of three things.1. buy a scan tool 2. go to a dealer and pay to have the codes read and diagnosed 3. go to your local parts chain to have it read for free. (call first to verify). The code will tell you what system is malfunctioning and what the malfunction is. The parts store option is my choice, because you can also get the part to fix it if needed and you are not out the $ for diagnostics, nor did you need an appt to get it in.
Posted on Apr 26, 2009
The idle air control valve is located on the back of the throttle body. It has an oval electrical connector and two torx screws holding it in. Unplug the connector, remove the two screws then lightly tap the body with a soft faced mallet to loosen it from the body.
Once you have it out and prior to installing a new valve clean the seat inside the throttle body where the idle control fits. This must be very clean! Installation is in the reverse order.
To save some cash, pull the valve out and clean it with throttle body cleaner, this usually fixes the problem for quite a while.
Good luck and hope this helps.
Posted on May 28, 2009
P0700 means there is a transmission fault code in the transmission controller. Since the transmission controller doesn't have a light attached, it tells the engine controller to turn the light on using this code. You'll have to access the transmission controller to further diagnose the problem.
Posted on Jun 14, 2009
Trouble Code: P0113 (4.0L L6 VIN S Auto)
IAT Sensor Circuit High Input Print this code data Number of Trips to Set Code: 1
OBD II Monitor Type: CCM Details
Indicators: MIL Details
Check with ignition on or engine running; battery voltage more than 10v; The PCM detected the IAT Sensor input was over 4.90v (exc. Dakota, Durango, Ram) or 4.98v (Dakota, Durango, Ram) for 3 seconds.
Posted on Dec 01, 2009
Tips for a great answer:
Apr 24, 2017 | Jeep Cars & Trucks
Apr 09, 2014 | Jeep Grand Cherokee Cars & Trucks
Jan 02, 2014 | 2001 Jeep Wrangler
May 18, 2010 | 1994 Jeep Grand Cherokee
Nov 18, 2009 | 1999 Jeep Grand Cherokee
Nov 05, 2009 | 1999 Jeep Grand Cherokee
Oct 09, 2009 | 2004 Jeep Grand Cherokee
May 02, 2009 | 2001 Jeep Grand Cherokee
Jan 09, 2009 | 2004 Jeep Grand Cherokee
137 people viewed this question
Usually answered in minutes!