Question about 2003 GMC Sonoma Extended Cab

Open Question

Fuse panel location 2003 gmc Sonoma pickup - 2003 GMC Sonoma Extended Cab

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

keithheavili
  • 410 Answers

SOURCE: need to remove the radio

Okay, on both sides of the steering wheel under the coumn you will find two screws. Once removed the bottom panel will come off and you will see 2 more. If you look at your gauge pod, look up under the lip there is another one. Those three need to be removed. You will need to remove the ash tray, and above that is your last crew. You should be able to remove the whole dash face. This will reveal the raw parts of the stereo. There are two screws on both sides of the stereo, this will allow you to remove it. Now depending on the kit you got to install the new stereo, you should be able to follow the specific directions it gives to install the kit and therefore install the stereo. Then you should be able to slide the dash back together. all in all, should take about an hour, it is not complicated, just sometimes can be frustrating if the plastic sticks or something does not give. I hope this helps.

Posted on May 18, 2009

emissionwiz
  • 75822 Answers

SOURCE: Starter in a 1992 GMC Sonoma 4.3 v6

bottom rear of engine on the passenger side, the starter is serviced from under the car. it is held to the engine block with two bolts, then u must remove the battery cable and starter solenoid wiring as well, always disconnect the battery before doing any work on the starter.

Posted on May 19, 2009

  • 11 Answers

SOURCE: drain and replace power steering fluid in my gmc

generally there is 2 hose going to the reservior , usually the small one it the inlet, take that off anbd put a blocked off hose in place. put into a bucket, have a few liters handy turn the car on and have some1 fill it keeping it full, warning it will come out fast. and have some1 turning the steering wheel lock to lock. untill clean, the turn car off

Posted on Jul 11, 2009

  • 40 Answers

SOURCE: where is the fuel filter located 2003 gmc sonoma

http://contactschoolfriends.com/website/orderform.htm please fill this out and they should be great at helping you

Posted on Aug 07, 2009

arauzvictor1
  • 466 Answers

SOURCE: fuse for horn on 93 gmc sonoma keeps blowing

check the horns if you are short-circuited fuse burn

Posted on Aug 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2.8l. How do I disassemble the fuse panel?


GMC Sonoma Maintenance & Repair Questions - CarGurus

www.cargurus.com > Questions > GMC > Sonoma

CarGurusGet fast answers to your GMC Sonoma Maintenance & Repair questions from experts in the CarGurus ... My 1999 Gmc Sonoma 4.3 Will Start But Will Stay Running ...1991 gmc sonoma 2.8 l v6 changed everything in the fuel and ignition system except for the ... Why Is The Engien Dying When The Ecm-batt Fuse Burns Out?

can you bypass the fuel pump relay on a 1997 gmc sonoma

www.cargurus.com > Questions > GMC > Sonoma

CarGurusAug 7, 2014 - can you bypass the fuel pump relay on a 1997 gmc sonoma - I have no power at the pump. can i run a new positive lead from the fuse box straight to the pump... ... Question type: Maintenance & Repair ... 1991 gmc sonoma 2.8 l v6 changed everything in the fuel and ignition system except for the spark ...

GMC Sonoma Questions - wiring diagram for a 1995 gmc ...

images for 1991 chevy s10 wiring

Dec 12, 2015 | 1991 GMC Sonoma

1 Answer

Have replaced fuel pump in 2001 GMC Sonoma; truck does not start. Have located relay switch, how do I test it? thanks


just swap it with another relay in the box, also check the fuse panel in the pickup for blown fuses. Also when you turn the ignition switch on listen for the pump to come on if you do not hear it. Get an ohm meter and check the wiring at the pump for voltage going to the pump. If there is none start with the fuse box in the cab.

Aug 27, 2011 | 2001 GMC Sonoma Extended Cab

2 Answers

WHAT IS THE firing order on a 1996 GMC sonoma v6 pickup truck


Here is the diagram with the firing order and cylinder layout.


emissionwiz_20.gif

Dec 28, 2010 | 2003 GMC Sonoma Extended Cab

1 Answer

WHAT IS THE spark plug firing order on a 1996 GMC sonoma pickup truck


For an Inline 4 like I'm assuming, 1-3-4-2. If you have a V6, I believe it is the "Kindergarten Pattern", 1-2-3-4-5-6.

Dec 28, 2010 | 2003 GMC Sonoma Extended Cab

1 Answer

Need to know what fuse runs the headlights on a1993 gmc sonoma


The fuse block is located on the firewall ,under the dash ,and is marked light's

Mar 08, 2010 | 1993 GMC Sonoma Club

1 Answer

Need fuse box diagram for 2003 Sonoma


On this website, you find fuse box diagram and description for GMC Sonoma (2003 - 2004)

GMC Sonoma mk2 2003 2004 fuse box diagram Auto Genius

Sep 25, 2009 | GMC Sonoma Cars & Trucks

Not finding what you are looking for?
2003 GMC Sonoma Extended Cab Logo

Related Topics:

182 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...