Question about 2001 Dodge Stratus

Open Question

How change crankshaft sensor on 2001 stratus 3.0

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

c17hydro
  • 2984 Answers

SOURCE: I HAVE A 2000 DODGE STRATUS 2.5 V6. WHERE IS THE

Cam is on the end of the block, crankshaft sensor is on the bottom of the block. Both are easy to change....are you changing these due to poor performance or no start condition?

Posted on Mar 21, 2009

  • 151 Answers

SOURCE: crankshaft sensor

2-0L-2.4L I-4 crankshaft sensor mounts to the engine block, behind the alternator, just above the oil filter. 2.5L V-6 crankshaft sensor mounts to transaxle just below the distributor.

Posted on May 07, 2009

  • 396 Answers

SOURCE: 2002 dodge stratus crankshaft sensor location?

The crankshaft or the shankcraft as we refer to it is inside the engine, it turns over the pistons. Never heard of such an animal. You may have a fuel pump going out, clogged fuel filter, fuel injectors, Idle air control valve going out, bad plugs, plug wires or distributors. Just began checking them one at a time.

Posted on Jun 30, 2009

  • 172 Answers

SOURCE: where is the crank shaft speed sensor located on

right top of the transmission bell housing

Posted on Apr 15, 2010

  • 630 Answers

SOURCE: 2001 Stratus: where is the egr valve loated on my stratus 2001 3...

should be on the intake manifold should be a dish looking shaped part... go online and pul;l a pic of one up on a parts page to help identify... also check with Auto Zone parts house as they will give you a print out of its exact location and the part if they have it in stock.

Posted on May 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2001 Dodge Stratus se is there a way to test a crank sensor?


There is but you have the have a meter that will check ohms and hertz. They run about $300 for a cheap one.

May 02, 2016 | Dodge Cars & Trucks

1 Answer

2001 dodge stratus 2.4 dohc change timing belt, cam sensor crank sensor, and coil pack. Wont spark on the number 2 and 3 cylinder coming from coil pack


check your work again check All sensors are working measure each one with meter check against manufacturers specs, check coil check all joins and earths especially, check distributors reluctor sensor etc
are you sure you got cambelt on right? one didn't get it a tooth out? again check.

Mar 25, 2015 | 2001 Dodge Stratus

1 Answer

I HAVE A 2000 DODGE STRATUS 2.5 V6. WHERE IS THE CAMSHAFT SENSOR AND CRANKSHAFT SENSOR LOCATED


Cam is on the end of the block, crankshaft sensor is on the bottom of the block. Both are easy to change....are you changing these due to poor performance or no start condition?

Mar 21, 2009 | 2000 Dodge Stratus

2 Answers

Replaced cam shaft sensor now the code flashes


Check the part number with the dealership. Make sure you have the correct part.

Mar 06, 2009 | 2001 Dodge Stratus

1 Answer

Where can I find the oil pressure sensor on a 2001 Dodge Stratus, 2.4 DOHC?


It is located in the back of the engine....the side facing the firewall....it sits above the crankshaft position sensor....you have to jack the car up and get almost in the middle of the car looking up, to see it.

Mar 04, 2009 | 2001 Dodge Stratus

1 Answer

2005 Dodge Stratus with a engine crankshaft code set, after a oil change


The crankshaft sensor has nothing to do with an oil flush. I dont think it could have been hit while draining oil either

Jan 31, 2009 | 2005 Dodge Stratus

2 Answers

Crank shaft sensor


replacing the crankshaft sensor might solve the problem.

Aug 19, 2008 | 2001 Dodge Stratus

Not finding what you are looking for?
2001 Dodge Stratus Logo

Related Topics:

94 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...