Question about 1992 Buick Roadmaster

Open Question

How ro remove radio from 1992 buick roadmaster

How to get to the screws that are holding the radio in place.Does the entire dash have to be removed.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 337 Answers

SOURCE: replacing brake booster on 1992 buick park avenue, how ro remove?

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528004ac0f

Posted on Dec 07, 2008

Ad
emissionwiz
  • 76682 Answers

SOURCE: replace heater core on 1992

It appears I was incorrect about removing the dash assembly, here are the instructions from a Buick owners club.

Under the passenger dash is an access panel that will allow you to remove the heater core, it really isn't that hard, there are lots of little dash screws and panel screws to remove before you get where you need to be but at least it is roomy. The AC evaporator is located by the heater core. I will give you a tip. I changed mine last year and the heater core that I ordered for my 92 Roadmaster was not correct, when I took my old one out and matched it in a book at the local part store, the heater core for my vehicle was listed as a 96 Caprice???? The car has been in my family since it was purchased new and the heater core had never been changed!!!! Explain that one!Oh yeah, one more tip, if your heater core is leaking, this access panel lowers towards you, if there is nasty sweet smelling water in there it will pour all over you, be careful! Caprice parts are the same as a Roadmaster,so if you ever need anything just look up caprices

Posted on Dec 16, 2008

  • 1 Answer

SOURCE: need to find wiring diagram

I locked my keys in my car! 1992 buick roadmaster, can someone tell me how to jimmie it open?

Posted on Mar 05, 2009

  • 1 Answer

SOURCE: Car will not start

If the starter is good, a bad ignition module or failed fuel pump will produce similar symptoms, i.e. no cranking, nothing happening when you turn the key. Ignition module sits under the distributor cap and is about the size and shape of a cassette tape with 2 female plugs and one male plug. Quick way to check the fuel pump is to put the car in a quiet place like inside the garage. Find a quiet friend to sit behind the wheel and turn the key so the dash lights come on, DO NOT TURN THE KEY FULLY LIKE YOU'RE TRYING TO START. You get down on the ground and listen near the gas tank for the quiet hum of the fuel pump that tells you it is working.

Posted on May 31, 2009

  • 563 Answers

SOURCE: starter install 1992 buick roadmaster

Do you mean the starter-motor removal?
Disconnect the battery. Disconnect the red/positive battery cable from the starter. Trace the red/positive cable to where it ends (that's the starter), disconnect it from the solenoid. Use applicable socket wrench/flat-wrench to unbolt/remove the starter-motor. Installation is reverse of removal.

Posted on Nov 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replace fuse dashboard 1992 buick roadmaster


press the helpful button and check links below, it is a 1993 manual, should be the same.
one fuse panel on that vehicle. It's on the driver side end of dash, you have to open the driver door to get at it. The box is under the hood, labeled relay center I believe. http://www.vadengmpp.com/owners-manual/buick/1993-Buick-RoadMaster.pdf

Buick Workshop Manuals

1992 Buick Roadmaster the tail lights nor dash lights work tried replacing...

Feb 03, 2016 | Buick Cars & Trucks

1 Answer

I have a 1992 buick roadmaster limited edition and my reverse lights stay on all the time how do i fix this problem


Hi...sounds like your Neutral Safety Switch needs to be adjusted. Loosen screws enough to slide switch one way or the other until your backup lights go out when the vehicle is in park, then re-tighten screws. Check to make sure backup lights come on only in Reverse. Here is a link showing the location of your Neutral Safety Switch: http://www.autozone.com/autozone/parts/1992-Buick-Roadmaster/Neutral-Safety-Switch/_/N-iwj89Z9cid6 (copy and paste entire link into your browser if the link is not live)

Sep 14, 2011 | Buick Roadmaster Cars & Trucks

1 Answer

How to remove the factory installed radio?


Hello,

To remove the radio of your car, follow the process below:
  • Turn the vehicle off and disconnect the negative battery terminal cable from the car battery before working on the radio.
  • Take off the dash trim area around the car radio. You may need to use the flat head screwdriver to carefully pry the paneling and trim off. Some cars use plastic clips or screws to hold the dash trim in place. Locate any clips or screws and remove them.
  • Use the Phillips head screwdriver to unscrew each of the screws holding the car radio in place. Most car radios are held in place by four screws, one on each corner. After removing each screw, carefully slide out the entire car radio.
  • Disconnect the wiring harness, main power supply and ground wire from the back of the radio. You may also need to disconnect any antenna connections or speaker connections.
Take care and good luck

Oct 31, 2010 | 2002 Lincoln LS

1 Answer

How do you get the stock radio deck out of a 1991 buick park avenue?


*It's a bit tricky but not difficult, if you know how the dash in the Park Avenue is put together. But before you do anything, safety first. *Disconnect the negative cable from the battery before doing any electrical work on a car. This prevents shorting out your cars electrical system.

*If you own the 90 -91 Park Avenue model, simply pull off the decorative trim away from the radio to expose the torq screws that hold the radio into the dash. You will need a torq screwdriver of the right size to remove the radio.
Available from your local autoparts store.

*If you own the 91-92 model, it's a whole different ball game. This since the dash is much more tightly compacted. It's a combination of a snap together assembly and Torq screws. The dash is held together in columns or sections.

*The torq screws on these models are hidden behind the heater vents in the upper dash. First pry the wooden trim (Which surrounds the climate control module) on the bottom of the dash off, gently but firmly until it comes free, exposing the Torq screws on the lower dash. Remove the heater vents (hiding the upper screws ) by popping them out with a straight blade screw driver. Then remove all Torq screws visible to the eye, only from the column that is holding is holding the radio in place.

*You will then be able to remove the black colored plastic off the dash to expose the radio. (Use care when removing the lower dash column as some climate control and airbag sensors might be embedded).

*Remove all Torq screws holding the radio in place, (and keep track of all screws) pull the radio out of the dash, and disconnect electrical connectors. If you'll be replacing the stock radio with a non factory radio, make sure all electrical connection watch up, since security feature in the radio are integrated into the radio. (some of these effect basic function on your vehicle like the headlights) If you will be reinstalling the stock radio, you will have to have it unlocked by the dealership. The DelcoLoc system will now think the radio is stolen, because of it's internal security features. Installation is the reverse of removal.

Hope this helps.

May 20, 2010 | 1991 Buick Park Avenue

1 Answer

How do you take out the radio


Disconnect the negative battery terminal to prevent an
accidental short circuit. Remove the plastic trim piece to
the left of the glove box and (1) phillips screw exposed.
Unsnap the top edge of the knee bolster panel. Remove
(1) phillips screw from the panel. Remove the ashtray
cluster and (2) phillips screws from each side. Unclip the
entire dash trim bezel and remove.Open doors and
unsnap end caps from each side of dash. Unsnap and
remove radio/instrument cluster panel. Remove (3)
screws in order to remove radio.
Disconnect the negative battery terminal to prevent an
accidental short circuit. Unsnap and remove dash bezel.
Remove (3) 9/32" screws and remove radio.
1
BUICK Rendevous 2002-2007

Feb 11, 2010 | 2002 Buick Regal

1 Answer

Where is the blower motor located on 92 buick roadmaster


Passenger side of dash, directly underneath the glove compartment. Remove the plastic cover under the dash to access the motor.

Jan 30, 2010 | 1992 Buick Roadmaster

1 Answer

Heater & ac fan only runs at low speed no matter what the setting


You will need to replace the fan. It is located under the Pass dash tucked in the corner. Not to expensive and you could do it yourself I think there are (3) 6mm screws that hold it in place. Correct me if I'm wrong about the size. Good luck.

Chris

Oct 10, 2009 | 1992 Buick Roadmaster

1 Answer

Change starter 192 buick roadmaster


dissconect battery, remove flywheel cover,remove 2 bolts holding starter, now drop starter and remove wiring and take out,

Sep 30, 2009 | 1992 Buick Roadmaster

1 Answer

Changing out the radio on 1996 buck century


Remove the hex screws from the lower section of the dash, under the steering column. This will reveal more screws that hold the wood tone panel down. There are more screws visible just under the top of the dash, look carefully as the upper screws, so you do not remove more than you need. Carefully, twist the woodtone panel around the steering column and remove. You will see 2 more hex screws to the right of the radio that hold the black plastic cover just to right of the radio. Carefully pop that cover off to reveal 2 more screws that hold the radio in place. Remove those 2 and the 2 on the left and you can pull the radio forward to unhook the harness and antenna wires.

Sep 26, 2009 | 1996 Buick Century

2 Answers

Replace heater core on 1992 buick roadmaster


It appears I was incorrect about removing the dash assembly, here are the instructions from a Buick owners club.

Under the passenger dash is an access panel that will allow you to remove the heater core, it really isn't that hard, there are lots of little dash screws and panel screws to remove before you get where you need to be but at least it is roomy. The AC evaporator is located by the heater core. I will give you a tip. I changed mine last year and the heater core that I ordered for my 92 Roadmaster was not correct, when I took my old one out and matched it in a book at the local part store, the heater core for my vehicle was listed as a 96 Caprice???? The car has been in my family since it was purchased new and the heater core had never been changed!!!! Explain that one!Oh yeah, one more tip, if your heater core is leaking, this access panel lowers towards you, if there is nasty sweet smelling water in there it will pour all over you, be careful! Caprice parts are the same as a Roadmaster,so if you ever need anything just look up caprices

Dec 16, 2008 | Buick Roadmaster Cars & Trucks

Not finding what you are looking for?
1992 Buick Roadmaster Logo

Related Topics:

202 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...