Question about Cars & Trucks

Open Question

How to remove transmission from a 2004 chevy impala

Posted by Anonymous on

6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 158 Answers

SOURCE: how to remove transmission from a 2003 chevy

hang drivetrain from above. Remove rack from cradle. Remove all other connections holding the cradle to the body and carefully lower thr cradle out of the car. Now you can unbolt the trans and separate it from the engine.

One of the easiest FWD's to remove - believe it or not

Posted on Aug 11, 2010

  • 295 Answers

SOURCE: Headlight wiring diagram for 2004 Chevy Impala

I would go to on line for your vehckle to get the wiring diagrams.

Posted on Jul 18, 2009

  • 1 Answer

SOURCE: 2003 Chevy Impala transmission

my 03 impala only jerks hard when the engine is cold or slightly cold. when its warm its fine. i never had it looked at before.

Posted on Feb 04, 2010

  • 1311 Answers

SOURCE: I have a 2004 chevy impala that makes a clunking

Problem could be a worn or broken engine mount.

Posted on Nov 08, 2010

  • 580 Answers

SOURCE: how do you remove the

Remove the rear seat. On later models remove the rear upper quarter panel by pulling down & out to disengage the retainer clips, then sliding the roof leg out from under the trim panel over the door. Detach the rear seat belts through the slot in the rear parcel shelf. Pry up the plastic clips securing the rear parcel shelf. Then lift up & out to remove it from the vehicle. Remove the speaker retaining screws or tabs. If the speaker seal has bonded with the metal shelf, hold the tabs & pry the housing away from the metal. Disconnect the electical connector & remove the speaker. Install in reverse order. Good luck!

Posted on Feb 22, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Starter for 2004 chevy impala

Click on the link, that is part of starter removal info.
Down low on front side of engine.

Apr 01, 2017 | Cars & Trucks

1 Answer

Windshield wipers on 2004 chevy impala when just the driver side works

Did u replace fuses/windshield wiper relay ,both relays ,should be 2 inside the engine compartments fuse box, if not that then the wiper transmission arm could be partially busted or stripped....seems like common problem on this page, maybe lookup if might be free recall replacement

Oct 08, 2015 | 2004 Chevrolet Chevrolet Impala

1 Answer

2004 chevy impala radiator removal 3.4 engine

There is a very detailed write up here:
The radiator is the same for both the 3.4 and 3.8 engines as well as various other GM vehicles around the same year. The cheapest radiator I was able to find was from
It's a fairly simple process, my 17 yr old son was able to do it all by himself. Don't forget to buy new radiator coolant and some Transmission fluid as you will lose about a quart worth when you pull the old transmission out.

Apr 15, 2015 | 2004 Chevrolet Impala

1 Answer

I have 2004 chevy impala And the ignition switch no return when you stared, And the back lights doesnt work when you press the brake pedal And turn on direcctional any side

It has a defective ignition switch spring. Replace or repair. Either that or the starter interlock on top of and visible on the transmission/engine intersection is bad. Google "picture image" of "2004 Chevrolet Impala Starter Switch" to find location, remove and replace one or the other.

Sep 03, 2014 | Cars & Trucks

3 Answers

Automatic transmission input shaft speed sensor

(440) Automatic Transmission Input Shaft Speed (A/T ISS) Sensor Assembly


Jul 02, 2014 | 2004 Chevrolet Impala

1 Answer

Need to replace drivers powered mirrow, 2004 chevy impala

Easy just remove door interior unplug,remove 3 nuts holding the mirror and put back all .just don't desperate

Jun 11, 2014 | 2004 Chevrolet Impala

1 Answer

2004 chevy impala solenoid stuck open

The solenoids are inside the transmission.
You may need a book and some special tools to make the repairs.

Jul 10, 2012 | Cars & Trucks

1 Answer

I need to change transmission filter and fluid on my 2004 chevy impala and being single and all and female I'm not up to car care that great. Where is the trans filter located. Trying to do my s

The transmission filter is under the car under the transmission fluid pan. you have to lift up your car loosen the volts, take of the pan, take of the filter put in the new one, put the new one on, put the transmission fluid pan in place, put the bolts and tighten them, lower the car and put however much transmission fluid your car takes. Hope the best of luck for ya.

Mar 03, 2012 | Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

779 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

75824 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides