Question about 2005 Chevrolet Impala

Open Question

How to install or replace heater core in a 2005 Impala

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 337 Answers

SOURCE: heater core on 2005 Silverado

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528008f2d5

Posted on Dec 11, 2008

Ad
allinbilly
  • 14 Answers

SOURCE: CHANGING THE HEATER CORE OF AN 04 IMPALA

Drain the coolant. Remove the dashboard first, then a bunch of air ducts, then the heater core cover. Remove the heater hoses in the rear of the motor, and finally the heater core.

Posted on Feb 21, 2009

localwonder
  • 6784 Answers

SOURCE: heater core

HI. This is not an easy job but, im sure you will be able to accomplish this with a little guidance. I have put together a guide for you to follow. Its a step by step guide and, it will help you with this replacement of your heater core.


REMOVING THE OLD CORE--

#
Step 1

Jack up the car and drain the Impala's cooling system. Loosen the water pump's drain bolt and let the coolant drain into a pan. Close the drain bolt and lower the car afterward.
#
Step 2

Remove the heater outlet and inlet hose from the heater core (reposition the hose clamps to do so). Take off the right console extension panel, body control module and left side extension panel on the front floor console
#
Step 3

Disconnect the left instrument center support bracket (pull away the carpet at its bottom to reach the nuts). Remove the accelerator control pedal from its position in the front of the dash.
#
Step 4

Disengage the center floor ducts by raising the outlet duct while pushing the ducts down. Rotate the outlet duct forward in the car and pull down to remove it from the HVAC module.
#
Step 5

Use a small chisel to remove all the heat stakes from the heater core cover. Loosen the nut behind the fuel line bracket. Remove the dash panel's stud at the heater hoses.
#
Step 6

Pull the core's cover down enough to reach the HVAC module's locating pins. Slide the cover rearward until the drain tube clears the dash front. Remove the cover by sliding it down, rearward, and to the right. You can now remove the core.
Installing the New Core


INSTALLING THE NEW CORE---

#
Step 1

Install the new core into the HVAC module, attaching a new seal onto the drain tube. Attach the core cover from the right side, sliding it up and forward into position.
#
Step 2

Align the drain tube with the front dash hole and the core cover holes with the HVAC locating pins. Install the core cover screws, cutting and folding back the sound insulator near the center screw to ease that screw's installation.
#
Step 3

Reinstall the dash panel stud at the heater hoses, tightening the nut behind the fuel line bracket. Align the center floor duct with the HVAC and push it up while rotating rearward to install it. Put the floor ducts and outlet duct back into the Chevy Impala.
#
Step 4

Attach the accelerator control pedal. Pull the carpet back and position the left center support bracket, then tighten the bracket nuts.
#
Step 5

Reconnect the left side front floor console extension panel and the body control module to the car.
#
Step 6

Put on the outlet hose and inlet hoses to the core, securing them with their clamps. Refill the cooling system with the proper mixture of water and coolant.


Inspect the foam seal for the core on the lower HVAC case. Replace it with adhesive black foam tape if damaged.

Please rate and have a good day:)

Posted on May 06, 2009

  • 1 Answer

SOURCE: 2005 impala instruction to remove heater core

oh, sucks for you!! i just replaced mine. it was a total pain in the ***. make sure you run the car up on some car ramps. this will help you quite a bit. because there will be times you'll be standing on your head, and in some horrible positions. it takes time and it takes patience. also make sure you have the correct heater core before you start. thanks to autozone, i drove around for about 3 days with the dash tore apart and the heating system bypassed because they gave me the wrong one. my recomendation is take your time. taking apart and putting together. 1/4 in drive metric set is handy to have. im no mechanic, however im also pretty handy and very mechanically inclined. i'd say with taking apart and putting together it probably took around 9 hours. but i was also by myself. lots of dash taking apart. and my car also has the center console, which didnt help my case. good luck!!!!!

Posted on Nov 26, 2009

  • 1024 Answers

SOURCE: How do I remove the dash board of a 2003 Impala to replace heater

you don't have to remove the dash to do this job

Posted on Mar 07, 2010

Testimonial: "What a relief, now I must find out how to replace it."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Changing heater core


    2005 Chevy Impala 3.8Liter - YouTube

    ? 3:51
    https://www.youtube.com/watch?v=pq2DoQq6q0A
    Apr 18, 2014 - Uploaded by DerrickTheMechanic
    How to change them out.And what they ... 2005 Chevy Impala3.8Liter ... Heater core information, coolant leak, bypass,replacement, hoses, etc.

    How To Change A Heater Core - Part 2 of 2 - YouTube

    ? 3:12
    https://www.youtube.com/watch?v=OFxQJXWszs8
    Jun 19, 2013 - Uploaded by klowny1969
    How To Change A Heater Core - Part 2 of 2. klowny1969 ...Impala . Caprice . Nova . Biscayne . Corvette . Denali . Landcruiser . ... Chevrolet 1500 * 2500 Truck * Heater Core Replacement * Gasoline * 1997 - Duration: 11:59. images for 2005 Chevrolet Chevrolet Impala LS ...


Feb 03, 2016 | 2005 Chevrolet Chevrolet Impala LS

2 Answers

Need to know exactly how and what is looks like for the heater core. how to replace it.


the heater core is simaliar your radiator It tipacly is located at the firewall passengers side 1 hose in 1 hose out not very large in demension.

Aug 21, 2011 | 2005 Chevrolet Impala

1 Answer

Im working on a 2006 chevy impala lt.....im replacing the heater core and i cant get the heat steaks off......all the manual says is that i need to use a chisle......but do i cut them off and if so what do...


I would drill them dimples by the heat stakes out and install heater core cover screws. Both inside the heater core cover and the heater air outlet cover. use a 7/32" or a 5.5mm bit.

Mar 22, 2011 | 2006 Chevrolet Impala

1 Answer

05 impala overheating have replaced waterpump thermostat bleed aie flushed radiatore and heater core but still over heates


check to see if rad fans come on when hot check this repl if you need more help

hope this helps you leave a comment

Jan 17, 2011 | 2005 Chevrolet Impala

3 Answers

How do you replace a heater core on a 95 impala ss


How to Replace the Heater Corein a Chevy Impala

Replacing your Chevy Impala'sheater core is no easy task. There are several parts you must carefully removeor reposition to disconnect the core from the heating, ventilating and airconditioning (HVAC) module. This module and the core are located behind thecar's floor ducts.

1. Jack up the car and drain the Impala's cooling system.Loosen the water pump's drain bolt and let the coolant drain into a pan. Closethe drain bolt and lower the car afterward. 2. Remove the heater outlet and inlet hose from theheater core (reposition the hose clamps to do so). Take off the right consoleextension panel, body control module and left side extension panel on the frontfloor console 3. Disconnect the leftinstrument center support bracket (pull away the carpet at its bottom to reachthe nuts). Remove the accelerator control pedal from its position in the frontof the dash. 4. Disengage the center floorducts by raising the outlet duct while pushing the ducts down. Rotate theoutlet duct forward in the car and pull down to remove it from the HVAC module. 5. Use a small chisel to removeall the heat stakes from the heater core cover. Loosen the nut behind the fuelline bracket. Remove the dash panel's stud at the heater hoses. 6. Pull the core's cover downenough to reach the HVAC module's locating pins. Slide the cover rearward untilthe drain tube clears the dash front. Remove the cover by sliding it down,rearward, and to the right. You can now remove the core.
Installing the New Core
1. Install the new core into the HVAC module,attaching a new seal onto the drain tube. Attach the core cover from the rightside, sliding it up and forward into position. 2. Align the draintube with the front dash hole and the core cover holes with the HVAC locatingpins. Install the core cover screws, cutting and folding back the soundinsulator near the center screw to ease that screw's installation. 3. Reinstall the dash panel stud at theheater hoses, tightening the nut behind the fuel line bracket. Align the centerfloor duct with the HVAC and push it up while rotating rearward to install it.Put the floor ducts and outlet duct back into the Chevy Impala. 4. Attach theaccelerator control pedal. Pull the carpet back and position the left centersupport bracket, then tighten the bracket nuts. 5. Reconnect theleft side front floor console extension panel and the body control module tothe car. 6. Put on the outlethose and inlet hoses to the core, securing them with their clamps. Refill thecooling system with the proper mixture of water and coolant.
Read more: How to Replace the Heater Core in a Chevy Impala ' eHow.com

Nov 10, 2010 | 1996 Chevrolet Impala SS

1 Answer

How to install or replace heater core in a 2005 Impala


its a little work about 5-6-hours to take apart and put back together give these websites a try www.alldatadiy.com and www.autozone.com if all fails stop by your local local library and get your hands on a Haynes auto repair manual for your car also like to give you this information if you every have any hard to find GM-parts they sells only GM-parts its Schram auto & truck parts 1-800-292-1032 and they website is www.schramauto.com wish you the best of luck Michigan Man.

Jan 12, 2010 | 2005 Chevrolet Impala

2 Answers

Heater is not blowing hot air


Do you have a sloshing sound in your dash? You may have an air pocket in your coolant lines that you need to bleed. I had this problem about 6 months ago in my '05 Impala

Mar 12, 2009 | 2005 Chevrolet Impala

1 Answer

2006 Chevy Impala - Heater recently worked on by garage and "control unit" replaced. Now heater motor runs on high at all times irregardless of fan speed control setting and whtehr ignition switch os...


the blower motor resistor is damaged probably in the process of removing the heater core replace the blower motor resistor, and please dont forget to rate me!!

Dec 02, 2008 | 2005 Chevrolet Impala

Not finding what you are looking for?
2005 Chevrolet Impala Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...