Question about 2003 Nissan Altima

1 Answer

My car refuse to start

My car remote fell inside water and since then the power on the remote refuse to come on,i took it to a tectnisian who said he can not activate security system what do i do?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 34 Answers

O.k... most likely you have some corrosion inside the remote... go to autozone... get the smallest wire brush they have... it should be 1/2 inch... by 1/2 inch... by about 5 inches long... or something close... and the bristles will be real close together... o.k., go home... remove the battery on the remote... and take remote apart... give it a good shake for 30 seconds... and place a paper towel around the circuit board of the remote... using the thumb and index finger... then ever so gently... apply very little pressure and dry out the remote some, now... leave the board in the towel and go get you a hair dryer and dry the remote the rest of the way... keep the hair drier about 6 inches away from the remote... do that for 2 minutes going side to side, remove the board from the towel... now... using a magnifing glass... inspect the remote... look for anything that looks like a white powder... and ever so gently... clean the board... both sides... when you think you have it all... put the remote back together and try out... if it works for you now... glad to hear it... be careful next time, if not... change batteries... if it still doesn't work... go get another remote and have it programmed... that one's done for... sorry

Posted on Oct 25, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Mercedes benz e230 1996 manual rear view mirror. need assembly drawing


1996 MB 300 D
My rear view mirror was dancing around. I took the mirror down because it was loose and the clips fell out.How do I re- install the retaining clips?

Jan 07, 2011 | 1995 Mercedes-Benz E-Class

3 Answers

I own a 1993 DX Honda Civic Hatchback. Recently I had a friend do an engine bay wash that did not end well for me. While driving it home it was running very poorly, shuddering, unable to reach speeds above...


Next time you bay wash your car, leave it running. This way the water evaporates instead of settling in or on your engine. Also make sure that you do not have any exposed wires or leaks in your engine prior to trying it again.

Jan 04, 2011 | 1995 Honda Civic

2 Answers

Power window not working


Check your switches...

Aug 05, 2010 | 1995 Buick Regal

1 Answer

Took 1990 sovereign for service and fix ac. now have blown gauges


they must of hooked up the terminals wrong. thats the only thing that could cause this other than leaving the key on when thry did this, They are responsible for fixing this. contact your state auto repair industry and lodge a complaint if they refuse to fix this for free

Nov 28, 2009 | 1990 Jaguar XJ6

1 Answer

2004 Isuzu Axiom with 29000 miles on it. The key fob fell apart and out fell the insides-so I've been using the key without the remote. Sometimes if I open any other door than the driver door the vehicle...


If it was factory fitted You will have to contact isuzu with the V.I.N. and proof of ownership they will get a new fob for you. If it's after market then you can either get a new fob and get it programed or get the imobiliser disabled

Sep 15, 2009 | 2004 Isuzu Axiom

3 Answers

Audi A6 Anti Theft Central Locking Tantrums


Sounds like you are having problems with your built-in alarm system. Like most systems in your Audi, you can read the error codes stored in the controllers. It takes a tool normally only a dealer has (VW or Audi) or an adapter like the VAG Com. (Google it)

I also think you can disable the alarm system and just use the key.

Could the lock button on your remote be stuck? Use a different key/remote. (leaving the suspect key at home.) The keys/remotes can be taken apart....

Sep 02, 2009 | 2000 Audi A6

1 Answer

Gear box


if a little steel ball also fell out then u need to find it that is the tension for your gears, if nothing fell out then the retainer inside the unit is out of place when you replaced the spring. you might need to have the unit serviced

May 25, 2008 | 2001 Kia Sportage

Not finding what you are looking for?
2003 Nissan Altima Logo

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...