Question about Dodge B Series Cargo

1 Answer

1998 dodge b1500 cargo van check engine light flashes and then stops

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 115 Answers

A flashung check engine light mean you have a severe misfire which can damage the catalitic converter

Posted on Feb 15, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 18 Answers

SOURCE: flashing light on dashboard 98 dodge neon service engine soon light on

11= Timing belt skipped 1 tooth or more from initial learned value, Intermittent loss of either camshaft or crankshaft position sensor, No crank reference signal detected during engine cranking for dodge odb readout. Hope this helps.

Posted on Dec 08, 2008

ewashmidas
  • 362 Answers

SOURCE: engine light and battery light

No, and a new battery may not cure the battery light being on. A low or no charge condition will turn the red battery light on, a bad battery will not. A low charge condition could have turn the check engine light on. I would have it checked before I would start replacing parts.

Posted on Jan 31, 2009

  • 49 Answers

SOURCE: 1998 dodge stratus bogs while accelerating

try putting some seafoam in the gas tank

Posted on Mar 11, 2009

  • 58 Answers

SOURCE: check engine light is on, motor runs rough, sometimes stalls

Go to Advance or Auto Zone and have them run an obd scan on it and it will pin point why your light is on and could solve your problem. This is often done for free.

Posted on Apr 12, 2009

SOURCE: gauges and odometer don't work

unfurtanetely the the board is burned out due to moisture on the wiring, you may have to replace the board but keep in mind that the wiring must be dry.

Posted on Jul 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Temp gauge up to 260!


One thing at a time.
Once the engine cooled down, how long did you run it before the engine heated up ? The thermostat could have stuck closed.
Or the water pump impeller may have failed.
Have you checked the computer for trouble codes yet ?

Feb 18, 2013 | Dodge Ram 1500 Cars & Trucks

1 Answer

I have a 1998 dodge van B1500 with a 5.2L . Problem is that the van just shuts down while driving. I have replaced the fuel pump, fuel filter, fuel relay, TPS fuel pressure regulator... I out of ideas can...


My Ram recentlystarted running horribly to the point of the engine not even reaching 2000rpms. I was fearing the worst but it turned out to be the catalytic converter stopped up. I fixed it and it runs good as new.

Dec 08, 2012 | 1998 Dodge Ram 1500 4WD

1 Answer

I cant seem to find the voltage regulator on my 1992 dodge B3W van. anybody got any ideas?


its built into the alternator ,start engine and take the neg battery terminal off if engine stops renew the alternator

Jan 17, 2011 | 1991 Dodge B Series Cargo

2 Answers

My 1997 Dodge mini van will not start. When I do


The flashing check engine light would mean that the engine is misfiring, If you have a scanner, use it on the diagnostic port of the engine to check for the error code to get which cylinder is misfiring and if there are other errors that needs to be checked.

Jan 19, 2010 | 1997 Dodge Caravan

1 Answer

1998 dodge 3500 1 ton 5.9 van is missing at idle check engine light was blinking


IF CHECK ENG. LIGHT WAS FLASHING OR STILL FLASHING YOU HAVE MULTIPLE CYLINDER MISFIRE, HAVE YOU PERFORM A MAJOR TUNE UP: SPARK PLUGS, CAP, ROTOR, WIRE SET, CLEAN THROTTLE BODY, RESET SENSORS?LET ME KNOW

Nov 19, 2009 | 1998 Dodge Ram 3500 2WD

1 Answer

2001venture van service engine soon light stays on


most any sensor going bad can cause the check engine light to come on,try disconnecting the posative battery cable for 15 seconds ,then put it back on,will reset the codes, or take it to auto zone,they will test your computer for codes at no charge to you.i had a venture van my was ox. sensor. thanks robert b.

Jun 16, 2009 | 1998 Chevrolet Venture Cargo

1 Answer

I think maybe my TPS is gone in my 1998 venture mini van. My check engine light is on and my van stalls out on acceleration once having already come to a stop and taking off again. I have replaced both...


You should really have the van scaned before you put any more parts on it. Autozone will scan it for free. You could spend alot of money just putting parts on it. If you can come up with a code/DTC for your problem then let me know and I will be better able to help you. Good Luck

May 16, 2009 | 1998 Chevrolet Venture Cargo

1 Answer

1998 chevy venture van....check engine light came on


This means that you need to Replace the Catalytic Converter. Please Rate My Response! Thanks!

Jan 31, 2009 | 1998 Chevrolet Venture Cargo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...