Question about Cars & Trucks

Open Question

How to replace a blower motor in a 1993 suburban

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 220 Answers

SOURCE: blower puts out too many amps

I never read that the fuse was blowing in any of the descriptions, but if we are going to jump ahead and suppose the armature is shorted, wouldn't it be easier to just pull the plug off the motor and replace the fuse and turn the motor switch on and see if the fuse pops after we have eliminated the motor. If fuse does not blow, the motor is bad. If fuse blows, you have a short somewhere.

In my experience, armatures usually fail open and the motor simply won't work. I still stand by my suggestion of step by step methodical troubleshooting rather than buying the parts first.

Posted on Jan 07, 2009

  • 2920 Answers

SOURCE: I need to replace the heater blower in a 1993 BMW 325I

the blower motor will be under the hood on the passemger side on the firwall there should be three screws that hold it in place

Posted on Jan 14, 2009

  • 215 Answers

SOURCE: Blower motor access for replacement

Should be on the firewall under the hood or under the glove compartment. Depending on which engine you have in that car.

Posted on Jun 04, 2009

  • 1810 Answers

SOURCE: 98 suburban k1500, need to replace blowere motor

if the motor works after a tap then the brushes are burnd in hit the back of the heater motor on the dome with a hammer it will work for the rest of winter then change it in the summer

Posted on Jan 03, 2010

  • 1165 Answers

SOURCE: 1993 volvo blower fan motor

Replace the A/C Power Module. It's a bit pricey at about $130.00. My research did not reveal the location of the module, but I believe it is under the hood near the firewall.

Posted on Jan 07, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1997 chevy suburban front blower issue.... doesn't work unless a gust of wind or I hit a bump. wondering what part I need for it to work.

it may be either a bad connection at the resistor block or the blower motor. check this out. if going over a bump starts the motor it may be a bad blower motor that needs replacing.

Sep 14, 2014 | 1997 Chevrolet Suburban

1 Answer

Blower motor

If its not working at all try this.

Find it up under the passenger side of the dash. They are a real treat to get at. With the key on and the blower speed setting set to high tap on the blower motor. If it starts working replace it. If it doesn't start working let me know and I'll get you some info to check wiring.

Feb 09, 2012 | 1993 Chevrolet Suburban

1 Answer

How to replace a 2004 Suburban Heater blower motor?

the blower motor is mounted under the passenger side of dash. there are two types of blower motors in this truck, one version the blower motor has no screws that hold in place, you just simply turn the blower motor out, the other and most common has three screws that hold it place. here is the instructions

  • Remove the sound insulator panel. Instrument Panel, Gauge., and Console.
  • Disconnect the electrical connector (2) from the blower motor (1).
  • Remove the screws from the blower motor (1).
  • Remove the blower motor (1) from the HVAC module (3).

  • mrtechwrench_30.gif

    Jun 08, 2011 | 2004 Chevrolet Suburban

    1 Answer

    Easiest way to replace heater blower motor in 1989 Chevy Suburban?

  • Disconnect the negative battery cable.
  • Disconnect the blower motor lead connector from the wiring harness connector.
  • Remove the blower motor cooling tube from the blower motor.
  • Remove the four retaining screws.
  • Turn the motor and the wheel assembly slightly to the right so that the bottom edge of the mounting plate follows the contour of the wheel well splash panel.
  • Lift up on the blower and remove it from the blower housing.
  • Installation the new blower motor by reversing the removal steps.
  • Connect the negative battery cable.
  • Dec 20, 2010 | 1989 Chevrolet Suburban

    1 Answer

    The rear a/c blower keeps running after the engine is off on my 2003 Suburban.

    Replace your relay to your rear blower motor and inspect your wire harness. Common for the harness to melt or the relay to melt causing it to short and keeping the blower motor to run.
    Thank you for using Fixya, good luck.

    Mar 24, 2010 | 2005 Chevrolet Suburban

    1 Answer

    98 suburban k1500, need to replace blowere motor

    if the motor works after a tap then the brushes are burnd in hit the back of the heater motor on the dome with a hammer it will work for the rest of winter then change it in the summer

    Jan 03, 2010 | 2003 Chevrolet Suburban 1500

    3 Answers

    2003 Suburban heater fan will not working.

    three things left to check,
    using test light see if you have power at motor with key and switch on,if you do replace motor,if not locate blower motor resistor it will be close to motor,check for power going in,last is the heater control assembly

    Dec 10, 2009 | 2003 Chevrolet Suburban 1500

    1 Answer

    2001 Suburban. Blower only works on speeds 3, 4,

    replace the blower resistor. should be down under dash near blower motor.

    Sep 26, 2009 | 2001 Chevrolet Suburban

    2 Answers

    1983 Chevrolet Suburban Heater fan not working

    Heater blower motor resister is bad, replace, located under dash above heater motor.

    Mar 15, 2009 | 1983 Chevrolet Suburban

    2 Answers

    1993 Chevy Suburban heater blower blockage?

    under the hood on the passenger side is where the motor is located.there are 3 or 4 screws that hold it in place and once you remove the fan motor youll know if its bad or not. the bearings may be worn out on it.

    Jan 01, 2009 | 1990 GMC Suburban

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    39 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Cars & Trucks Experts


    Level 3 Expert

    76846 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22246 Answers

    Randy Ohler

    Level 3 Expert

    14585 Answers

    Are you a Car and Truck Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides