Question about 2001 Chevrolet S-10

1 Answer

Truck will not start

Had my engine rebuilt,but will not start. i tookmy truck to chevy dealer and they say i need a fuel pump,tps,and mass air flow sensor. am i just lucky,or is that possible.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Chevrolet Master
  • 959 Answers

Why did you have the engine rebuilt?

Posted on Nov 19, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

3 Answers

2003 Nissan Altima 2.5L Service Engine Soon Light is on, Auto Zone says codes are for MAF and O2 Sensors. Car hard to start after driving a while but when starts appears to run smooth. Auto Zone thi

ok lets start with the codes they say your getting. P??? which 1's and how many. there are few o2 sensors, are they next to the Exhaust next to the converter? MASS AIR FLOW -MAF use this, for now i am guessing, until i see the correct codes your are getting. this could be the 1 you may have below, please read it........
  • P0103
    Mass Air Flow Sensor Circuit High Input
  • Possible causes
  • Faulty mass air flow sensor
    - Intake air leaks
    - Dirty mass air flow sensor
    - Dirty mass air filter
    - Mass air flow sensor harness is open or shorted
    - Mass air flow sensor circuit poor electrical connection
  • Before replacing the mass air flow sensor, try replacing the air filter and cleaning the air flow sensor with low compress air or mass air flow sensor cleaner. Reset code and drive vehicle. If the code comes back, it may be necessary to replaced the mass air flow sensor.
  • possible symptoms Engine Light ON (or Service Engine Soon Warning Light)
    - Engine stall
    - Engine running rough
    - Excessive fuel consumption
    - Excessive smoke
  • the code is generated when An excessively high voltage from the sensor is sent to Engine Control Module (ECM).
2003 NISSAN Altima Sedan OBDII Codes List

Oct 22, 2014 | 2003 Nissan Altima

1 Answer

1999 chevy camaro starting problem? help

check that fuel is getting to engine, next, are you getting spark, are your plug wires in the right order, are they all good, you must keep plug wires from touching each other, is the cap & rotor ok, coil ok, fuses ok, do you have a fuel pump relay, if so, check fuse in relay. is the fuel filter new, did any codes get stored ECM, put drygas in fuel tank. are spark plug wires fully engaged onto plugs, don't concern your self with any smoke, let's get the engine started first, CHECK EVERYTHING MENTIONED ABOVE, including fuel filter, air filter should be new also, todays fuel w/ ethanol is garbage, for older cars. is the mass air flow sensor for this car ? aftermarkets are garbage. let me know how things work out, my knowledge is not cheap, but I will help you to avoid egg on your face, KEN

Feb 05, 2013 | 1999 Chevrolet Camaro

1 Answer

Car starts and then dies when you give it gas

sound like engine running lean.could be clogged fuel filter or weak fuel pump check fuel pressure but change fuel filter fuel pressure should be 41 - 47 psi. if fuel pressure okay could have faulty TPS SENSOR OR MASS AIR FLOW SENSOR. have vechicle code scan first before buying new parts.

Dec 25, 2012 | 1998 Pontiac Grand Prix

3 Answers

My 1999 mercury cougar died randomly down the road...

i'd say crank angle sensor gone intermittant,does'nt often throw codes as ECU usually thinks driver stalled engine as it suddenly sees no rpm signal

Nov 20, 2017 | 2000 Mercury Cougar

1 Answer

I have a 1986 gts corrolla that will not run unless air flow meter is held open

Now if your old fuel pump was loosing pressure it tends to lean out Overheating your catalytic converter and melting it so exhaust gasses can't flow To test this is easy just remove the two bolts holding it on the engine pipe Start the engine if runs fine replace cat converter

Sep 15, 2012 | 1986 Toyota Corolla 2 Door

1 Answer

95 mercury i replaced tps and mass flow air and car running for 10 min now wont start at all

I would check for trouble codes in the computer and fuel pressure next.
You need to figure out if you are dealing with a no spark or low fuel pressure issue to proceed.

Aug 14, 2012 | Mercury Cars & Trucks

1 Answer

Chevy blazer 97 replaced the fuel regulator and pump and still

mine was doing the same thing, the mass air flow sensor and throttle position sensor were dirty...i changed the tps myself but had the dealer do the mas.

Jun 19, 2009 | 1997 Chevrolet Blazer

1 Answer

I have a 2000 Chevy Blazer I have replaced

maf sensor, tps sensor,or timing gear

Apr 16, 2009 | 2000 Chevrolet Blazer

Not finding what you are looking for?
2001 Chevrolet S-10 Logo

Related Topics:

94 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

78010 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides