Question about Cars & Trucks

1 Answer

Not starting all lights on dash ok but not turning over after taking out all fuses and cleaning and replacing

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Did u try the starter relay under the hood usually a long black box usually along the fender and firewall.try that

Posted on Feb 14, 2012

  • eric haynes Feb 14, 2012

    did u try the starter relay under the hood usually a long black box usually along the fender and firewall.try that

×

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 179 Answers

SOURCE: dash lighting and tail light.

the bulb in the dash went out you need to remove cluster panel near where the light went out

Posted on Jun 02, 2009

  • 439 Answers

SOURCE: 96 Voyager won't start

Then the next thing to check is the starter itself, are you hearing any popping noises from the base of the motor? The starter should not be hard to change. Once you pull it out you can take it to the autozone and they can test it for you. The starter solenoid may be bad also, but these are normally attached to the starter. I hope this helps give you some insight.

Posted on Jun 23, 2009

  • 1 Answer

SOURCE: 97 honda civic Speedometer bouncing lights dimming fuse ok

hey ! guyz i dnt knw for sum reason my dash board lights are not working, i have checkd the fuse and the bulbs buh they are perfect can ny1 tell me whatz wrong wiv ma 1998 honda civic dashboard lights.

Posted on Apr 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the crank sensor located


Might be wise to check fuses and determine why dash lights don't work. Can you hear fuel pump run? Have you checked fuel pump fuse and relay? Often when a pump fails it has been drawing extra amps for some time prior to failing, which can harm the relay. If possible, hook up a fuel pressure gauge and insure you have correct pressure. Also be aware that some cheap parts store fuel pimps are junk, and may not work even when new. Also, did you clean the gunk out of the tank?

Jan 05, 2015 | Cars & Trucks

2 Answers

Pcm.Cavalier 1998 2.2L 4 cyl. won't start,only cranks.No spark on all plugs.replaced crankshaft pos.sensor.Pour gas in the intake but still wont run,only cranks.Hooked up a tech 2 scanner but no...


Its very possible the computer is dead. A mechanic would pin test the computer plugs to verify it has power and ground.
Does the check engine light come on when the key switch is turned on ?

Jan 22, 2014 | Cars & Trucks

1 Answer

The car is starting 1/10.. Firts i turn ignition key and the light in the dash are lighting up good,i turn the key and nothing happen.I take the off the ignition and it make a tic-tic-tic on the...


We have to assume the battery is usable, if not, anything else doesn't help. A couple of possibilities- First, get a simple, cheap device that uses a 9V battery and the car's cigarette lighter to prevent losing anti-theft codes. Once this is plugged in, remove the negative battery cable first, then the positive. CLEAN the battery connectors and terminals. Try to start the engine. If it still does the same thing, remove the negative battery cable again and follow it to its next connection and clean that point. While it is off, remove the other end of the positive cable which goes to the starter terminal and clean both points.
While under the hood, look for the cable connecting the engine block to the body of the car and clean both ends of that cable.
If the problem is still there, it can be related to one of these; the ignition switch, the starter solenoid or a corroded fuse connection. The starter is not protected by a fuse but the solenoid may be.
Good luck-

May 28, 2011 | Nissan 300ZX Cars & Trucks

2 Answers

Won't crank.No sound from starter.Starter tested ok. Battery new.Dash lights light up.Fuses not blown. 1992 Toyota Camry XLE V6 automatic


Battery cables off the starter ,starter relay and ignition switch. these are the remaining items in the starting system for no crank and no start.
Get Shop manual and do the appropriate testing for each.

Feb 19, 2010 | 1992 Toyota Camry V6

1 Answer

My dash lights are out, my shifter lights are out, my passenger side tail light and pass. side driving light is out too... however, the turn signal still works and my brake light still works. No fuse is...


sounds like a fuse - - even if the fuse looks new - it can break internally - so - get a test light and just for fun - even replace the fuses - and keep the old ones as extras - as for the dash lights - it is usually a fuse as you sound like you know - still- i would again change the fuses and also - - take down the vin number and ask the local dealer if there have been any recalls or service bulletins

Dec 27, 2009 | 2001 Hyundai Santa Fe

1 Answer

2005 pt cruiser wont start


First check to make sure all the harness plugs on the PCM are pushed in and tight. It happened to me.
Then check your grounds.
And you need to get that multi switch replaced to fix that fog light problem.  Just remember to take the relay off of the old one and replace it on the new one.

May 25, 2009 | 2006 Chrysler PT Cruiser

1 Answer

2003 dodge durango #4 fuse keeps blowing,


OK there is a short in your car
take all the light bulbs out of the light that trigger the problem this break the current place one bulb in at a time checking that the fuse has not blown this will pin point where the problem is
once you find the problem you can replace the socket as it may have started to corrode check for water
once you replace the socket you should not have a problem
if you do let me know
dj_ricko_1988 at hot mail dot com

Dec 27, 2008 | 2003 Dodge Durango

2 Answers

Dash lights are not working 1999 Mercedes-Benz CLK


most probable cause could be a faulty ignition switch. Does the lights on the dash come on when you turn the key to the on position ? Do they turn off when you turn the car to the start and are about to crank the engine ? If that does not happen you will have to replace the Ignition switch. They don't have a fuse for the dash lights.

Dec 03, 2008 | 1999 Mercedes-Benz CLK

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...