Question about 2003 Hyundai Accent

1 Answer

Why does my hyundai accent 03 cut out sometimes when just sitting in park, this is still after ive had tps switch replaced and crank angle sensor and spark plugs changed Its driving me mad

Posted by on

  • yadayada
    yadayada Feb 14, 2012

    What are the OBD2 system fault codes you are getting now?

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Hyundai Master
  • 22,095 Answers

Have had this before where it will cut out and then sometimes it will not pick up and it was the mass air flow sensor just by airfilter faulty ,why it shouild have made it cut out i cannot fathom out but it did on this model car and i only know this because i went with the owner of the car to tha hyundai garage to translate and he went straight to the stores and changed the sensor and didnt charge any labour .So he must have have had product knowledge which i didnt because i couldnt cure it thats for sure

Posted on Feb 14, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 653 Answers

SOURCE: my car vibrates while sitting in drive while

Odds are your rough idle is caused by fouled spark plugs, bad spark plug wires, dirty fuel injectors, a dirty air filter, or dirty fuel filter. A less likely cause is jumped timing due to a bad timing belt, bad throttle position sensor, mass air flow sensor, oxygen sensor, camshaft position sensor, crankshaft position sensor, etc... Another possibility would be transmission problems. Run the car by an Auto Zone. Advance Auto, Pep Boys, O'Reily or other store and have them hook the computer up to the code scanner. If there are no fault codes, go to a transmission shop and have them drop the pan and look around. Don't be fooled when they bring the pan out and show you the sooty looking deposits in the bottom of the pan. Those are normal, but metallic or fibrous chunks are not.

Posted on Feb 27, 2009

motor1258
  • 6674 Answers

SOURCE: stalls after driving for 10 min

Ya it's a good chance, But I just hate throwing parts on without knowing for sure, but hey, it's your money, and it may be the cure. Good Luck.

Posted on May 26, 2009

  • 1 Answer

SOURCE: Window crank

I had the same problem. If you look at the outside of the door while cranking the window, look to see if the window is trying to go on the outside of the outer seal. If so, you will have to check to see if the window is loose on the tracks. On mine, the track frame had spread open. I repaired it and used graphite to lube the track.

Posted on Jul 01, 2009

SOURCE: Hyundai accent 07 mp3-03 security code

IT WIL LOCK YOU OUT BUT IF YOU LEAVE IGN.ON ACC. FOR TWO HOURS IT WILL RESET AND ASK FOR CODE AGAIN.

Posted on Jul 17, 2009

  • 14036 Answers

SOURCE: 2003 hyundai accent crank but no start, nospark ,nofuel pump op.

have it scan to check camshaft sensor and crankshaft sensor.and pcm.all 3 can cause no spark and no fuel problems.

Posted on Jul 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hyundai accent stalls


The O2 sensor code could be the answer. If the sensor is faulty it could be causing the fuel mixture to be too lean.

Jan 23, 2014 | Cars & Trucks

1 Answer

2001 hyundai accent 1.5l codes 300 301 303 have ck tim belt,comp at 200 psi .replace spark plugs,crank sensor ,fuel pump&filter .will start then die


Replace the throttle position sensor (TPS) (since you've checked/replaced anything else which could be causing this problem - except WIRING). Reinspect all wiring & connectors/connections before replacing the TPS. Also, I've seen (on occasion, a faulty "Main Relay" create the condition you describe). Suppose you have a faulty ignition switch (ignition key). When placed in the 'START' position, the engine starts normally, BUT, when you release IT to the 'RUN' position, the engine dies - CLUE?

Mar 22, 2011 | 2001 Hyundai Accent

1 Answer

How to install throttle position sensor in 2000 hyundai accent


Removal & Installation
  1. Disconnect the negative battery cable.
  2. Disconnect the sensor connector.
  3. Remove the sensor retaining screws. Remove the sensor from its mounting.

To install:

  1. Installation is the reverse of the removal procedure.
tps is located on throttle body across from accelerator cable make sure to mark the angle with a punch or mark so when install new one it will be in the same position
'
hope this helps
plz vote comment or reply if need more help

Jan 18, 2011 | 2000 Hyundai Accent

1 Answer

I have a hyundai accent 1997 and have problem with starting, sometimes i will go out to start it and it won;t start let it sit for little while and it will start no problem


sounds a bit like a problem I had with mine - had a crank position sensor replaced after trying allsorts and it sorted it for me - all good since.

Nov 17, 2009 | 1997 Hyundai Accent

1 Answer

No spark. replaced the cam angle sensor. was intermittant but now


dear friend-it highly unlikely that both coil packs will be faulty,so the most probible cause will be the crank angle sensor,if no saticfaction it can be the ecu.

Jul 18, 2009 | 2000 Hyundai Accent

1 Answer

No spark at spark plugs


dear friend-my feeling is that we have a faulty crank angle sensor,have it tested or replace

Jul 18, 2009 | 2000 Hyundai Accent

1 Answer

My 2004 hyundai accent will stall when driving and start back up later


dear friend-i get the idea that your crank angle sensor is faulty ,best thing to do is take your vehicle for a diagnotic test befor changing anything.

Jul 12, 2009 | 2001 Hyundai Accent

1 Answer

1.5TD engine cuts out under accelleration


Sounds like your mechanic is on the right track as it sounds like a fuel problem.

Nov 18, 2008 | 2002 Hyundai Accent

Not finding what you are looking for?
2003 Hyundai Accent Logo

211 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7711 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...