Question about Cars & Trucks
The 3.8 liter lower intake bolts should be tightened to 11 ft-lbs in sequence.
the upper for the same engine is 89 inch-pounds, again in sequence.
Posted on Feb 14, 2012
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: torque specs
Hi my name is Allen!
I work for a Dodge Dealership. There are no torque specs for the upper or the lower ball joints on any of the Chrysler Vehicles. As long as you get them as tight as you can they will be fine, don't worry they are held in by road force anyway. Note: Be careful that you don't strip-out the nuts by getting them to tight.
For further asistance you may reach me at FixYa!
Posted on Dec 28, 2008
On 5.7L engines, install the bolts and torque in sequence as follows:
Posted on Mar 14, 2009
Tips for a great answer:
Feb 01, 2017 | 2002 Buick Rendezvous
Jan 05, 2017 | Cars & Trucks
Jun 24, 2016 | 2003 Dodge Intrepid
Aug 25, 2014 | 1996 Chevrolet K1500
Jun 17, 2014 | 2003 Pontiac Grand Am
Mar 04, 2011 | 2002 Lincoln LS
Fig. Intake manifold bolt torque sequence 2.7L engine
Upper intake manifold with a new gasket on the lower intake manifold and torque the bolts, in sequence, to: 105 inch lbs. (12 Nm)
Hope helps (remember to rate this answer). Good job.
Oct 11, 2010 | 2002 Chrysler Sebring
Oct 05, 2010 | Chevrolet Malibu Cars & Trucks
Aug 14, 2010 | 2000 Chevrolet Malibu
Feb 06, 2010 | 1999 Buick Century
184 people viewed this question
Usually answered in minutes!