Question about Chevrolet Cars & Trucks
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
There will be adjustment screws located on at least two different spots surrounding each headlamp. By turning these screws you move the angle of the headlamp. Most shops will do this at a very resonable rate, I say this because improper headlamp angle may lead to a ticket, or at least a warning. To say the least, they have to be at specific angles and heights. Good luck.
Posted on Feb 20, 2009
you take it to a repair shop and they unhook your transmission cooler lines and pump old fluid out and install new fluid in.
Posted on Apr 29, 2009
jack the car up and remove the trans pan (12 bolts I think), inside you will find the filter replace it, after u finish refill with the exact same amount of fluid (about 3-4 quarts of Dexron 6 ATF) and then recheck hot, don't overfill...
Posted on Jun 13, 2009
Start with the basics. Check the fuses (all of them) with a test light and be sure you have power to each and that they are good. Then be sure that the power lock relay is good by swapping it with another relay in the fuse block. If the fuses are good and the relay is swapped and the locks still aren't functioning, you may have an issue with the BCM. The BCM can be programmed to change the behavior, but if the car has had water damage, or other stress to the BCM (voltage, heat, etc.), it can sometimes damage the BCM and you will need to replace it and reprogram it at a GM dealership.
Posted on Jul 25, 2009
Fault with the IAC valve.there maybe a trouble code associated with it also./ Go to your nearby autozone or auto parts retailer and ask them to put a scanner to the car....make note of the codes if any are found. the IAC valve i usually locate don the throttle body and can be removed for inspection and sometimes cleaning using a good throttle body cleaner spray and a pipe cleaner brush.
Posted on Aug 04, 2009
Tips for a great answer:
Apr 17, 2015 | 2006 Chevrolet Cobalt
Sep 22, 2011 | 2006 Chevrolet Cobalt
May 18, 2010 | 2006 Chevrolet Cobalt
Jan 01, 2010 | 2006 Chevrolet Cobalt
Jun 12, 2009 | 2006 Chevrolet Cobalt
Jan 02, 2009 | 2006 Chevrolet Cobalt
188 people viewed this question
Usually answered in minutes!