2009 limited subaru tribeca low beam bulb on drivers side out how to replace

SOURCE: How do you change the

I just had to do this and learned the hard way.

First take the battery out.
Second remove the plastic cap covering the low beam bulb
Thirdly there are 2 screws holding a wire tension spring against the bulb. Losen the screw towards the outside of the car (Don't touch the screw closest to the engin).

Once you do this, the bulb will come out and you can replace it.

Lee A.

• 4472 Answers
• Posted on Aug 26, 2010

SOURCE: I have a 2008 Subaru

Here is all the information you will need:


If these images aren't clear enough you can register on this forum and find them in higher quality here:
http://www.scoobymods.com/headlamp-removal-and-aiming-t7377.html?s=e9b47833b123b35cbbcbaf64555610c6&p=26116#post26116
Thank you,
Lee

SOURCE: how do I replace a left hand side low beam light

please check the manual for light replacements

SOURCE: i need to replace the drivers side low beam on my

The High and low beams are all in the same bulb. You have to reach in behind the light in the engine compartment and undo the retaining collar and pull it out and then pull the bulb assembly out if it separates from the collar. Unplug the bulb and replace it. I usually stop at Walmart and use the little box they have there to find the proper bulb for the vehicle, in most cases they are the less costly of the places you can get the bulbs.