Question about 2005 Chevrolet Uplander

2 Answers

Fuses where is the fuse for the instrument panel cluster, for the speedometer and odometer

Posted by on

  • jjdumont Jan 18, 2009

    can't figure out what fuse is for the power lock.

  • gsoyalan Mar 17, 2009

    can 't locate the interior fuse panel

×

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

  • Expert
  • 185 Answers

It is usually on the left side of the dsk, just to the left of where the drivers knee is , There is uaually a detent in the dask where you can remove the fuse cover panel


Hope this helps Good luck Loringh

Posted on Oct 25, 2008

If you have an Uplander, I searched forever and finally found the interior fuse box. It is on the passenger side. Open the door and you will see where a portion of the dash sticks out and meets the door when the door is closed. There is a small panel that can be removed (it just snaps in) remove the panel and the fuse box is behind the panel.

Posted on Nov 08, 2008

  • tstefano Jan 04, 2011

    Not there!

×

1 Suggested Answer

  • 1 Answer

SOURCE: instrument panel cluster gauges and odometer has stopped working

I had all my analog instrument panel gauges stop working after they did the state emissions test. I found the proper fuse in the fuse block located under the hood. Simply unplugged the fuse, noticed it was still good, and plugged the same fuse (10A) back in and all the gauges started working again. Guess it needed a reset atfer they plugged in for the emissions.

Posted on Aug 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2001 Buick Century Limited speedometer problem, Speedometer not working but odomitor ok. Is there a fuse?


if the odometer is working then the problem is with the speedometer head unit as the odometer gets its information from the same source as the speedometer. you can have the speedometer head checked and fixed if its fixable.

Aug 22, 2015 | 2001 Buick Century Limited

1 Answer

What is the location of fuse for speedometer on 2o04 ford explorer


Speedometer The instrument cluster receives the vehicle speed sensor (VSS) signal from the powertrain control module (PCM) through the standard corporate protocol (SCP) communication network. The instrument cluster monitors the VSS input from the PCM and commands the speedometer with a corresponding movement of the pointer.
  • The speedometer/odometer is inoperative
  • Circuitry.
  • Powertrain control module (PCM).
  • Instrument cluster.
  • Go To Pinpoint Test L .
PINPOINT TEST L: THE SPEEDOMETER/ODOMETER IS INOPERATIVE Test Step Result / Action to Take L1 RETRIEVE THE RECORDED DTCS FROM BOTH CONTINUOUS AND ON-DEMAND INSTRUMENT CLUSTER SELF-TESTS
  • Use the recorded instrument cluster DTCs from the continuous and on-demand self-tests.
  • Are any instrument cluster DTCs recorded?
Yes
If instrument cluster U1123 is retrieved, REFER to Powertrain Control/Emissions Diagnosis (PC/ED) manual to continue diagnosis.

For all other instrument cluster DTCs, REFER to the Instrument Cluster Diagnostic Trouble Code (DTC) Index.

No
For inoperative speedometer, GO to L2 .

For inoperative odometer, GO to L3 . L2 CARRY OUT THE SPEEDOMETER ACTIVE COMMAND USING THE DIAGNOSTIC TOOL
  • Connect the diagnostic tool.
  • Key in ON position.
  • Enter the following diagnostic mode on the diagnostic tool: Instrument Cluster Active Command.
  • Select the instrument cluster speedometer active command.
  • Trigger the speedometer and scroll in increments of 10% while monitoring the speedometer. The speedometer should increase in increments of approximately 20 km/h (12 mph) for each 10% change.
  • Does the speedometer increase within specifications?
Yes
REFER to Powertrain Control/Emissions Diagnosis (PC/ED) manual to continue diagnosis.

No
GO to L4 . L3 MONITOR THE INTEGRATED CIRCUIT DISPLAYS
  • Key in ON position.
  • Monitor the compass, air temperature and message center functions of the integrated circuit display.
  • Do the compass, air temperature or message center displays operate correctly?
Yes
GO to L4 .

No
Go To Pinpoint Test AE . L4 CHECK FOR CORRECT INSTRUMENT CLUSTER OPERATION
  • Disconnect all instrument cluster connectors.
  • Check for:
    • corrosion
    • pushed-out pins
  • Connect all instrument cluster connectors and make sure they seat correctly.
  • Operate the system and verify the concern is still present.
  • Is the concern still present?
Yes
INSTALL a new instrument cluster. REFER to Instrument Cluster in this section. TEST the system for normal operation.

No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CLEAR the DTCs. REPEAT the self-test. There isn't a fuse just for the speedometer , there are four fuse for the whole instrument cluster . If one of these fuse's were burnt you would have more then just the speedometer not working ! You need to have a scan tool to find out what is up ! you could need a new cluster ! Is the check engine light on ? if not wouldn't think vehicle speed sensor bad , besides speed info for speedometer PCM uses for transmission shift points ! Good luck ,hope this helps !

Mar 17, 2015 | Ford Cars & Trucks

2 Answers

Display for gear display,odometer,trip odometer not lighted. Fuses check ok but replaced just to make sure. All other dashboard items ok. How do I get display back on 2000 Silverado?


The display is on all the time. You can only dim it with the headlight switch. If the display is blank, you will need a new Instrument Cluster. Some sites on ebay will repair yours cheaper than a new one, and keep your milage the same.

Aug 13, 2013 | 2000 Chevrolet Silverado

1 Answer

Instrument cluster bulb is out. how do i replace


It may not be a bulb, as the instrument cluster usually has a number of bulbs and they probably didn't all blow at once. Pulling instrument clusters can be touchy and may not be for the average "shadetree mechanic" however, typically there are a few screws above the cluster going into the dash pad and a few hidden behind the trim panels below the cluster.

Dec 22, 2009 | 2001 Chrysler Sebring

1 Answer

Speedometer Quit working, odometer also. Don't


Hello.
What sounds like happened is that the instrument cluster fuse sounds like its burnt out. Otherwise the wires on the back of them both may have been knocked out. Very simple fix if its the fuse, if not, pull the cluster out and check the wiring. Hope this helps!
-Steve

Dec 06, 2009 | 2006 Kia Spectra

2 Answers

Speedometer/odometer stopped working today (panel not displaying any data). where do i start?


Always start with the easy stuff first on electrical- fuse panel first.

Sep 04, 2009 | 1998 Cadillac DeVille

3 Answers

Speedometer, gas gauge, odometer, rpm gauge not working


My gas guage, speed odometer and tempiture does not work
The speed odometre is reading 9999999 what should i do

Jul 29, 2009 | 1998 Nissan Frontier

2 Answers

1995 Cougar Odometer/trip-meter inop


Section 13-01: Instrument Cluster—Conventional 1995 Thunderbird, Cougar Workshop Manual REMOVAL AND INSTALLATION Instrument Cluster Removal and Installation
  1. Disconnect battery ground cable (14301) .
  1. Remove screws holding instrument panel reinforcement (017A28) .
  1. Remove screws holding instrument panel lower shield (045G02) .
  1. Remove fasteners holding steering wheel column as outlined in Section 11-04 . Gently lower steering column.
  1. Remove fasteners holding the instrument panel finish panel (044D70) and gently pry off.



  1. Remove four instrument cluster retaining screws. (Do not remove screws from the instrument cluster main lens (10887) and instrument cluster mask (10890) ).
  1. Slide the instrument cluster (10849) to the right of the instrument panel opening and unhook the instrument panel harness from the back of the instrument cluster .
  1. Remove the instrument cluster from the instrument panel (04320) .
-----------------------
Speedometer/Odometer Federal law requires that the odometer in any replacement speedometer (17255) must register the same mileage as that registered in the removed speedometer . Since the speedometer mileage cannot be reset on this unit, affix odometer sticker to driver's door pillar and record original vehicle mileage. Removal
  1. Disconnect battery ground cable (14301) .
  1. Remove the instrument cluster (10849) as outlined.
  1. Remove seven screws retaining the instrument cluster mask (10890) and instrument cluster main lens (10887) .
  1. Remove speedometer assembly.
Installation
  1. Position the speedometer assembly to the instrument cluster back plate (10848) and install.
  1. Position the instrument cluster mask and instrument cluster main lens to the instrument cluster back plate and install the seven retaining screws.
  1. Install the instrument cluster as outlined.
  1. Connect battery ground cable and check the operation of the speedometer .
please rate if this helps

Mar 24, 2009 | 1994 Mercury Cougar

Not finding what you are looking for?
2005 Chevrolet Uplander Logo

505 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...