Question about 1997 Honda Accord

1 Answer

Horn will not blow

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 104 Answers

Unplug the wire to the horn, use a test light to check if there is power there when the horn is pressed. If yes, replace the horn. If no, check the horn fuse, if that's ok, check for power at the horn relay and swap it for another relay the same to check if the relay is faulty. From there, if the fault still exists, you'd better get an auto electrician to look at it.

Posted on Oct 25, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuse keeps blowing when I honk the horn. 2011 Mitsubishi Galant SE


Try disconnecting the horn and see if the fuse still blows when you press the horn button. If it does not blow the horn is probably bad. Buy a new horn.

May 10, 2014 | Mitsubishi Galant Cars & Trucks

1 Answer

Horn no blow


check for blowed fuse or bad relay, you can hook test light to see if horn getting power when you press horn pad if fuse and relay okay,remove horn and hot wire it if it blows, more likely horn pad with airbag in steering wheel bad,if horn pad bad you have to replace whole airbag with with horn pad as a unit.if horn dont blow when hot wired then horn it self is bad.

Sep 17, 2012 | 2000 Honda Odyssey

1 Answer

For 2004 ford truck f150 extended cab, I found the horn fuse, where is the horn relay?


disconnect the horn or horns, operate the horn and see if the fuse still blows. if the fuse still blows then there is most likely a short in the wiring. relays rarely cause shorts. if the fuse doesnt blow with the horn disconnected, reconnect the horn and operate the horn again, if the fuse blows you have a shorted horn.

Jul 14, 2012 | 2004 Ford F150

1 Answer

The horn does not blow and when I replace the fuse it may blow once or twice but the fuse blows again.


you may have a short in one of the horn them self . the easy to test is to unplug both horns then see if the fuse blows. if not plug in the horn one at a time . and see which one blows the fuse . replace the one that dose. if you have only one horn still do the test.

Apr 30, 2011 | Chevrolet Impala Cars & Trucks

2 Answers

99 dodge durango. My horn keeps blowing the 20 amp fuse under hood. There is also a horn relay. Could that be the problem? The horn will work after I replace the 20 amp, but blows within a few times of...


could be you might check it out. many items take the same relay so you might try exchanging it with another one with the same numbers. If that isn't it you may have a short in the horn itself.

Aug 11, 2010 | 1999 Dodge Durango

1 Answer

On my 1972 duster,when i blow the horn,the fuse blows and the tail lights go out also. the same fuse runs both.what could be the problem?


This sounds like the horn may have a short in it somewhere. Does the horn blow at all? Try this: Make sure you have a good fuse installed to this circuit again. Disconnect the horn and place a volt/ohm meter set to DC volts on the horn connections. If there is just 1 wire going to the horn, put that wire on the red wire of the meter. Put the black wire of the meter to a good ground, preferably the negative battery terminal. Now press the horn and see if there is a reading of around 12 Volts. If so, replace the horn. If not, and the fuse blows again, check the wiring for a fray/short to ground. When you're looking at the horn of course, make sure the positive lead isn't shorting to ground as well.

I hope this helps! Let me know if you need any more assistance! :)

-Jason

Feb 11, 2010 | 1983 Plymouth Gran Fury

1 Answer

Horn just stop blowing,won't blow


When you press on the horn button do you hear the horn relay click? The start at the horn, bench test it, if it works then check for power, is the fuse good and is the relay ok. If the stuff checks out then it may be the horn contacts behind the steering wheel.

May 23, 2009 | 2001 Lincoln LS

2 Answers

Horn blows fuses


you may need to put a relay in it as the current from the horn may be back feeding up the immobiliser horn circuit and causing a short. Sounds like the immobiiliser has its own source of power seperate from the factory circuit When you press the horn the power goes to the horn and up the immobiliser horn circuit and it blows the fuse.

Oct 14, 2008 | 1999 Volkswagen Jetta

Not finding what you are looking for?
1997 Honda Accord Logo

Related Topics:

724 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...