Question about Cars & Trucks
Posted by Anonymous on
Hi any one in Ireland ( Dublin) with the df505 code engine light solutions sorted it out for me email firstname.lastname@example.org
Posted on Mar 16, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Fault code description: DF055 Coded line circuit,Short circuit to +12V.Active - this code DF055 is Cylinder 4 injector circuit
Try checking the voltage on the immo wire that connects the immo ecu with the engin ecu this is the coded line. on this wire must be a signal and the Max. amplitude is 5v. if you measure more than 5 volts then check wire or any interference on it . if you dont know where to find the wire then look for pin 59 at engine ecu .
Posted on Oct 23, 2009
This could be a possibility of a bad connection to the engine speed sensor or in other terms flywheels sensor or TDC sensor located under the thermostat housing screwed to the gearbox by two bolts, when the problem occurs try playing around with the connector connected to the TDC sensor and then try to start it, renault has a new modified connector and TDC sensor on the market.
I hope this helps.
Posted on Apr 21, 2010
Hi - the way to enable code mode is to turn off the radio - then hold down 2&5 & press the on button - this will bring you into the 0000 code mode.
Posted on Apr 13, 2009
The track guide that operates the window from the motor is damaged or has jumped track. Remove the inner door panel and operate the window and see which has happened. If it has jumped track check for missing or damaged guide retainers if it is damaged or broken replace it. Normally runs about $15 to $20 for the part. Now if the drive guide is not damaged and it is still not working the gear that drives it is damaged and you will need to replace the motor as this is pressed on and not user replaceable. Good Luck
Posted on Sep 12, 2009
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls
Posted on Sep 23, 2009
Tips for a great answer:
Jun 16, 2016 | 2005 Renault Grand Scenic
Jun 26, 2014 | 2006 Renault Scenic 1.4
Jun 26, 2014 | 2000 Renault 181
Jun 03, 2014 | Renault SCENIC Cars & Trucks
Dec 26, 2013 | 2001 Renault Renault Scenic Sport
May 13, 2010 | 2000 Renault 181
Oct 23, 2009 | Renault Sportwagon Cars & Trucks
1,704 people viewed this question
Usually answered in minutes!