Question about Cars & Trucks

1 Answer

Knocking noise on my 2000 buick regal when i steer

When i turn steering wheel i hear a clunk more on the right than left

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

The cv joint on the right needs to be replaced

Posted on Feb 14, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: 1993 buick regal steering column repairs

http://www.alldatadiy.com/

Posted on Aug 31, 2008

  • 4 Answers

SOURCE: 1999 Buick Regal Steering Problem when making left turns

there is a recall from the dealer that they will fix this

Posted on Sep 03, 2008

  • 1 Answer

SOURCE: Clicking or knocking sound when turning the steering wheel

Sounds like a cv shaft or cv joint

Posted on Mar 20, 2009

  • 1 Answer

SOURCE: power steering fluid

Just went to a dealer today for my 2000 regal. It took them a while, but they showed me where my power steering cap was.

It is black and very hard to see. You need a small flashlight (LED recommended), and then need to look on the left side behind the engine and in front of where the glove box is. WAY down, under some hoses, and adjacent to the engine is the power steering cap (I'd estimate about 8-10" down). The best way to see it is to lean into the engine from the front while standing to the left of the center of the car. Lean forward and place the flashlight pointing down and slightly to the left behind the engine and at a level just below the block. Good luck!!

Posted on Nov 05, 2009

mister_b_65
  • 74 Answers

SOURCE: Where do you add power steering fluid for a 2000

The power steering filler cap is on the passenger side just behind and under the alternator (I had to use a flashlight to find mine but it's visible if you lean over the front fender - passenger side). . There is a cross brace by the firewall that I had to remove so I could get to the filler cap. The cross brace is held on by 4 nuts - 1/2" or 13mm - and removing them and the brace allows fairly easy access to the filler cap. Remove the cap and fill. I'd recommend using a small funnel since it's virtually impossible to get the power steering fluid bottle behind the alternator and around several hoses. A funnel made it a cinch. Check to be sure you don't over fill, replace the cross brace and you're finished.

Posted on Dec 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 2005 Pontiac grand am and every time I go around a corner, doesn't matter if its a left or right turn, I hear what sounds like a grinding noise coming from the front of the vehicle near the...


this might help:
Here is the Technical Service Bulletin that maybe of help, worth looking into but can't guarantee that it would fix your problem Steering - Steering Column Clunking When Turning TECHNICAL Bulletin No.: 01-02-32-001P Date: November 25, 2009 Subject: Clunk Felt/Noise Heard From Steering Column, Steering Gear and/or Front Of Vehicle During Turning Maneuver and/or Steering Wheel Rotation (Replace Intermediate Shaft As Directed) Models: 2001-2004 Buick Regal 2005-2008 Buick Allure (Canada Only), LaCrosse 2000-2008 Chevrolet Impala 2000-2007 Chevrolet Monte Carlo 1998-2002 Oldsmobile Intrigue 2004-2007 Pontiac Grand Prix Supercede: This bulletin is being revised to add the 2008 Buick LaCrosse/Allure. Please discard Corporate Bulletin Number 01-02-32-001O (Section 02 - Steering). Condition Some customers may comment on a clunk type noise coming from the front of the vehicle while driving during a turning maneuver.

1. Locate a large area (parking lot) where the vehicle can be turned in a tight circle. 2. Turn the steering wheel to the right and/or left all the way to the steering lock, then off the steering lock a 1/4 turn. 3. Drive the vehicle approximately 5 km/h (3 mph) in a circle, preferably over rough pavement or seams on the road surface. 4. Drive the vehicle straight ahead at idle speed while applying and releasing the brake pedal. Listen/feel the steering wheel for the clunk/noise condition. 5. If a clunk is felt in the steering wheel, the MOST likely cause is the I-shaft - not the steering gear. Continue with the correction. Correction DO THIS - Replace the intermediate shaft DON'T DO THIS - DO NOT lube the intermediate shaft Replace the existing intermediate shaft

Apr 13, 2013 | Cars & Trucks

1 Answer

Clunking noise when you turn the steering wheel while driving


The noise will be either the universal joint on the steering column or a component in the steering rack or outer tie rod ends, get someone to sit in the car and move the wheel slightly left and right and have a look and you will be able to see and hear where the noise is coming from

Mar 08, 2012 | 1998 Dodge Stratus

1 Answer

2006 Toyota RAV 4 Limited


our 2007 Rav 4 had a clunk in steering when turning at about 28000 miles it was do to a weak stearing knuckle, had replaced, and went away

Apr 03, 2010 | 1997 Toyota RAV4

1 Answer

Steering wheel


What kind of noise, if growling and grinding check and replace wheel bearing. If thumping clunking type noise check steering intermediate shaft, makes noise in both directions.

Mar 08, 2010 | 2000 Chevrolet Silverado 1500

2 Answers

My 2003 Buick Regal makes a load whinning sound when I turn. WHat could be causing this?


Hi, it could be a wheel bearing. if you turn left and you hear it it will be your right front bearing and visa-versa. could be the power steering belt that needs replacing, good luck with it.

Mar 06, 2010 | 2003 Buick Regal

1 Answer

1984 buick regal, ignition swtich won't turn


you may have to replace the steering column you can get one from a salvage yard and have the switch rekeyed for your key to fit it

Jan 01, 2009 | 1984 Buick Regal

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

104 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...