Question about 1993 Chevrolet K1500

Open Question

How do you remove the seat armrest on a 1993 chevy pickup

Posted by on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Chevy Uplander LS 2006

Go to your local salvage yard. We bought LS seats to replace on our LT model. I liked the intergrated child seat and it only came in the LS model. The dealer charged almost 500 a seat. I found out later, salvage yards have many parts that are brand new and half the amount. The seat could have cost us $350 for both! Some yards will search for you. Good Luck!

Posted on Aug 27, 2008

  • 6982 Answers

SOURCE: how do you remover the rear axle on a 1993 chevy

On yours, you need to remove the diff cover, remove the small retainer bolt at the end of the spider gear cross shaft and remove the shaft. push the axle in and remove the "c" clip on the axle end. It can then be pulled out of the housing. Reverse to install. Don't turn the gears while toe cross shaft is out or the spider gears will exit to the floor. You can put your finger into one hole and gently turn it to avoid that, but don't jam your finger in there.

Posted on Sep 26, 2009

johnjohn2
  • 5763 Answers

SOURCE: remove armrest from a 1999 suburban bucket seat

theres a bolt at the bottom were it swivels up and dowm, it behind colth, some have a zipper to open and some you just have to pull cloth away to get to screw and some have a plug covering it, also you may have to remove seat unless you have enough room,to acces screw, good luck.

Posted on Nov 13, 2009

  • 1702 Answers

SOURCE: My drivers side armrest needs

Hi, Why don't you go to a wrecking yard you might find a good one. It will be cheaper too. Good luck

Posted on Jun 23, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove front middle arm rest 1998 lincoln town car?


Easiest way is get a hacksaw and cut the rod its attached to on both sides.

Only other way I can see doing involves removing the all seats.

Oct 29, 2015 | 1998 Lincoln Town Car

1 Answer

How can i remove 1993 chevrolet silverado bucket seat armrest


There are two screws on either side of the armrest. Remove with Allen wrench or Phillips head. Be sure the armrest is closed position. After removing screws lift straight up to remove the armrest. Save the screws.

May 25, 2014 | 1994 Chevrolet S-10 Blazer

1 Answer

How do you remove the armrest from the driver bucket seat from a 1994 chevrolet silverado, it does not have the clip from the backside like the newer chevrolets?


It is possible that the role pin to remove the armrest is hidden inside the zipper cover. I do not know this particular vehicle, but GM did that to some of the vans. Some also have to require the removal of the actual seat and turn counterclockwise to "unwind" the armrest. Good Luck, hope this may help.

May 19, 2014 | 1994 Chevrolet S-10 Blazer

1 Answer

How to remove the driver seat armrest?


on the end of the armrest should have a cap or a zipper and inside is the screw to un do the arm

Apr 27, 2014 | 2010 Kia Soul

1 Answer

Remove rear seat 1993 chevy 1500


I just took out my rear seat from my 1993 Cheyenne ext cab. Fold the back seat in the up position. There are 2 square stubs sticking out from each side that the hinge plates of the seat slip over. Take out the 5/8 bolt and washer securing the hinge plate to the stub--slide the seat assembly toward the rear of the cab--and lift up and out.
Once you have the right solution--it is a 5 minute job !!!

Feb 23, 2013 | Cars & Trucks

1 Answer

How do i take off the armrests from the bucket seats


  • On most vehicles the arm rest are attached the same way, here is something you can try...Put the armrest in the upright position. Look along the bottom and sides of the armrest where it connects to the body of the seat. There should be small circles like tabs if the armrest is made of plastic, and there should be a seam that you can look through if the arms are made of cloth.
  • Pop out the tab or peel back the fabric to reveal the holding mechanism. If the chair is screwed in then you'll need a screwdriver, and if there's a nut or a bolt then you're going to need a socket wrench.
  • Hold the armrest up and make sure it doesn't move. Unscrew or unbolt the arm from the bucket seat. Pull the arm outwards once the hardware is removed.
  • Nov 13, 2012 | 2007 Dodge Grand Caravan SXT Minivan

    1 Answer

    How do I remove folding back seats on 1997 bmw 328i


    Remove the headrests (if equipped). Grip the lower seat at the front part of the seat and pull upwards to clear the clips(1), and the remove the lower seat.
    Fold down the armrest and remove the bolts behind the armrest. The upper seat(backrest) is then pushed up, pulled forward and then moved either left or right out of the vehicle from behind the seat belts

    Jun 29, 2012 | Cars & Trucks

    1 Answer

    How do I remove the back seat / backrest from a bmw 328IC 1997


    Remove the headrests (if equipped). Grip the lower seat at the front part of the seat and pull upwards to clear the clips(1), and the remove the lower seat.
    Fold down the armrest and remove the bolts behind the armrest. The upper seat(backrest) is then pushed up, pulled forward and then moved either left or right out of the vehicle from behind the seatbelts.


    suzman_15.jpg

    Nov 15, 2010 | 1997 BMW 328

    1 Answer

    How do you remove the armrest on the front seats?


    The armrests have covers that can be removed. Locate the zipper on the arm rest. Once you unzip it pull it toward the back of the arm rest and this will expose the one bolt that hold the armrest on. You will need a large torx and rachet to get it off. Once you take out that bolt the armrest will come right off.

    Feb 02, 2010 | 1995 Ford Bronco

    Not finding what you are looking for?
    1993 Chevrolet K1500 Logo

    Related Topics:

    336 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chevrolet Experts

    yadayada
    yadayada

    Level 3 Expert

    75817 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8180 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...