Question about Cars & Trucks

1 Answer

Engine ,traction control, abs, and park brake lights are on

Posted by on

  • mark ferris Feb 15, 2012

    all these light came on at the same time , had it scoped but said to take it to the dealer. checked fuses. could this be a wheel sensor or a hub. are all these systems on the same circuit.

  • mark ferris Feb 21, 2012

    could this be a loose ground in the engine compartment

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Mentor:

    An expert who has written 3 tips or uploaded 2 video tips.

  • Expert
  • 245 Answers

Check parking brake is relies all the way.

Posted on Feb 15, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 8 Answers

SOURCE: traction control light and abs light

ok your problem is that your brakes are under force you shold get new brake pads ok

Posted on Jul 14, 2008

  • 27 Answers

SOURCE: ABS LIGHT AND TRACTION CONTROL LIGHT ON DASH

make sure u didnt break a wire, there are sensors on the brakes, make sure theyre plugged in

Posted on Jun 10, 2009

  • 1 Answer

SOURCE: abs light/traction control light

You can check out what the trouble code is by pushing and holding the information button and the up arrow (right side of instrument cluster above the radio) until all the instrument clusters light. Press the information button (last) to enter test mode. I've had an error C1234, meaning Left rear wheel sensor fault. I found the problem to be a corroded connector under the chasis just under the rear left door about 2 feet in. I had to by-pass (replace 1 wire due to corrosion at the connector.

Posted on Sep 15, 2009

  • 396 Answers

SOURCE: Engine light and ABS traction control light remain

The ABS sensor is a speed sensor also for Traction Control. This is why both lights are on , One of your front ABS sensors are bad or disconnected, or has a pinched wire.

Posted on Jan 16, 2010

SOURCE: my abs, traction control and parking brake light

Because you apparently have no knowledge of OBD govt emission
systems, that have been on our vehicles for the last 30 years

Any light on the dash, is a possible system malfuntion
You surely have heard of codes you get from the diagnostic
connector under the dash
You use the codes to follow a trouble chart, to a solution and repair
That is the short version

You need a local repair shop,the days of working on your own
car in the driveway, left about 1981 with the OBD1 and now OBD2
Systems (1996 thru 2011)

Posted on Dec 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Abslight stays on. How to fix? This is a2007trailblazer?


First you need to have EBCM - electronic brake control module check for DTC'S - diagnostic trouble code's . If the light is on there is a code stored . I think most part stores can do this and for free . After you find out what code is stored , looking up that code in service repair information for diagnostic trouble shooting chart would be next step . There are a few codes too.
DTC C0035 or C0040
DTC C0045 or C0050
DTC C0110
DTC C0131
DTC C0161
DTC C0186
DTC C0196
DTC C0201
DTC C0240
DTC C0241 or P0856
DTC C0244 or P1689
DTC C0245
DTC C0283
DTC C0287
DTC C0290 or C0292
DTC C0455
DTC C0550
DTC C0558

Find the code do the diagnostic's , fix the problem , wiring issue's , a sensor , bad module ,what ever it is . The light will go out then . Here is a sample of code discription .
• DTC C0035 Left Front Wheel Speed Sensor Circuit
• DTC C0040 Right Front Wheel Speed Sensor Circuit

Dec 30, 2016 | 2007 Chevrolet Trailblazer

1 Answer

Light abs traction control stays 1998 buick park avenue


PRE-DIAGNOSTIC INSPECTIONBefore diagnosing ABS/TCS, perform a comprehensive visual inspection of system as follows.Check ABS/TCS wiring harness connectors for looseness. Check harness routing; pay particular attention to wheel speed sensor wiring harness routing. Check fuses No. 1D, 5B and 6B in instrument panel fuse block. Check fuses No. 1 and 2 in underhood fuse block. Check brake fluid level in master cylinder reservoir. Check brake fluid level in Pressure Modulator Valve (PMV) assembly reservoir. Ensure parking brake is fully released. Ensure parking brake switch is functioning properly. Always perform ABS/TCS system functional check before using DIAGNOSTIC CODE CHARTSThe EBCM/EBTCM has self-diagnostic capability, which can detect system failures. Fault codes stored by EBCM/EBTCM can be displayed using Tech 1 scan tester. There are no provisions for flash code diagnostics.Begin ABS/TCS diagnosis with PRE-DIAGNOSTIC INSPECTION procedure. If failures are found during pre-diagnostic inspection, perform necessary repairs, and proceed with ABS/TCS FUNCTIONAL CHECK. See Fig. 5 .If no failures are found during pre-diagnostic inspection, go to ABS/TCS FUNCTIONAL CHECK. See Fig. 5 . The ABS/TCS FUNCTIONAL CHECK will either indicate ABS/TCS is functioning properly or direct technician to various diagnostic procedures such as diagnostic charts, symptom diagnosis or BRAKE warning light diagnosis.CHART D - TRACTION OFF WARNING LIGHT ON CONTINUOUSLY & NO DTC SET (BUICK WITH UH8 OR U2A INSTRUMENT CLUSTER)Circuit DescriptionWhen ignition switch is first turned to RUN position, EBTCM goes through a self-test, which lasts 2-4 seconds. During self-test, EBTCM commands TRACTION OFF indicator warning light on. Powertrain Control Module (PCM) can also command EBTCM to set a Code 75 which will illuminate TRACTION OFF indicator.Traction control switch is located either on instrument panel center trim plate or driver's front door trim panel. Switch allows driver to select traction control mode (on/off). When traction control system is turned off, TRACTION OFF warning light comes on.EBTCM monitors transaxle temperature through

Jul 12, 2014 | 1998 Buick Park Avenue

1 Answer

Parking Brake, ABS, Traction Control & Anti Skid lights on


One or more of the sensors in the wheels that are responsible for these functions is faulty. It is sending a signal that is mucking up the calculations that control the brakes and engine for traction control and anti skid. All of them need to be checked!

Jan 14, 2013 | 2006 Chevrolet TrailBlazer LT

3 Answers

Traction control and anti-locks(ABS) lights come on.


Traction control and anti-locks(ABS) lights come on there is sensors that are pluged in behind the rotors check and see if they are disconected or loose sometimes when you change your brake pads they might come loose and not making contact.

Jul 06, 2010 | 1998 Cadillac DeVille

1 Answer

Traction control indicator that traction is off


have the calipers and brake system checked, as for traction control is ran by abs system

Apr 13, 2010 | 2002 Chevrolet Impala

1 Answer

ABS, Traction Control and Park brake light on


If you have abs sensors at the wheels, have them checked. Usually abs & trac control work off these sensors

Sep 17, 2009 | Land Rover Discovery Cars & Trucks

1 Answer

Lincoln ls year 2000 v8 3.9litres


ABS and traction control really are only for panic stops and if your tires slip on wet surface's and yes each tire has a sensor on it. However if the brake light comes on this has nothing to do with the ABS or traction control lights. It's not a parking brake light. This light tells you, you have a serious brake problem.

May 13, 2009 | 2002 Lincoln LS

1 Answer

2001 Mercury Grand Marquis brake and ABS dash lights on and off


The red brake light is the key here. That usually indicateds a hydraulic problem. Check you fluid level in master cylinder and see if it is low. Also the level indicator sensor there in the master cylinder maybe sticking or corrioded. If ABS sees the red brake light it will shut off and turn on the ABS light,also traction control would be disabled as well.

Feb 04, 2009 | 2001 Mercury Grand Marquis

1 Answer

Transmission Traction "Off" light stays lit with Traction button


The traction control system is controlled through the Anti-lock brake system. The way it works is if one of your wheels starts spinning the ABS applys the brake to that wheel to transfer power to the oppsite wheel that is getting traction. If your ABS is bad then your Traction control won't work. To check it I would find a parking lot on a wet day. In an open space mash in the gas. if you hear the ABS system kick in and you don't squall the tires then your good. My guess is you won't. What I would be worried about is will my ABS work. When checking the traction control is a good time to check the ABS. Acclerate to around 15 mph, then mash the brake as your live depended on it. If you hear a motor run and feel a vibration or grind in the brake peddal, then it works.

Jan 09, 2009 | 1997 Buick LeSabre

2 Answers

Traction control light and abs light


ok your problem is that your brakes are under force you shold get new brake pads ok

Jul 14, 2008 | 2002 Audi A4

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...