Question about Toyota Highlander

Open Question

Remove rear bumper cover on a 2003 toyota highlander

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

shaggyrat
  • 1224 Answers

SOURCE: Remove rear bumper from 2003 Porche Cayenne

removing takes about 5 minute refiting the back bumper will take about an our to refit the rear bumper if your using power tools

the easiest way to do this is tank some white nail polish mark 3 lines on the mounts on both sides this will give you a guide to placen back the bumper to vehicle

Posted on Jun 10, 2008

  • 99 Answers

SOURCE: Remove rear plastic bumper cover

please email me at meanness628@aim.com with any other info or questions if you have already gone to a body shop

Posted on Sep 29, 2008

rteemon
  • 578 Answers

SOURCE: My Toyota Corolla rear bumper has at big dent on

you have to take the whole bumper off and the bolt the u see holding it on the re-bar and bumper cover should come off

Posted on Jul 01, 2009

MNfisherman
  • 11896 Answers

SOURCE: how to remove the rear bumper cover on a town and

From underneath the vehicle. The bumper is held on by 4 bolts and nuts. (2 on each end) Remove the nuts and bumper will pull off. Then you can pry off bumper cover to once entire bumper is off.

Posted on Nov 23, 2009

satitus
  • 273 Answers

SOURCE: 2003 Toyota Highlander clock resets when I turn off the ignition

Have you checked any fuses? Does the climate control light up? If not then in the under hood fuse box (left of drivers side) check the ECU-B fuse should be 7.5 amp. Check the heater fuse in the fuse box inside the car it should be 15 amp. If the fuses are OK and only the clock is bad check out my site www.autoclockrepair.com I offer a repair service.

Posted on Jul 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The rear bumper cover came off how can I reinstall it


2000 Toyota Sienna rear Bumper cover replacement (1998 ...

? 3:40
https://www.youtube.com/watch?v=AY1BBdg3q74
Sep 20, 2013 - Uploaded by SergSpace
2000 Toyota Sienna rear Bumper cover replacement (1998-2003) .... Automotive Bumper Repair Specialist- How to repairyour plastic bumper cover ... Toyota Sienna Rear Shock Installation 2003, 2004, 2005, 2006 - Duration: ... 2015 Toyota Sienna XLE - Duration: 28:13. by MikesCarInfo 35,234 views.

Fixing My Mom's Prius: Loose Rear Bumper Cover - YouTube




Nov 29, 2015 | 2005 Toyota Sienna LE

1 Answer

Remove rear bumper cover 2008 highlander


There are tabs at each end of the cover that snap into small slots. The slots will crack if not taken apart very gently. I inserted a small blade to help open the slot and allow the tab catch to slide under the blade and come out.

Feb 10, 2015 | 2008 Toyota Highlander

1 Answer

How to take out rear bumper from 2003 toyota corolla?


If you follow the same techniques as in this video, you should be fine.....attached video of 2011 which should be very similar to 2003 TOYOTA CAMRY 2011 REAR BUMPER COVER REMOVAL REPAIR

May 26, 2014 | 2003 Toyota Corolla

1 Answer

Remove front headlight assembly 2002 toyota highlander


I changed my 2001 Toyota Highlander headlights recently. First, remove the grille. There is one screw in the center which will require a loonng Phillips screwdriver to reach it, down behind the grille, right in the center. Then remove the four plastic clips at the top by prying them up with a small flathead screwdriver. The bottom just pulls forward. Important: Now go to each side of the car, and in front of each fender well, there is one clip that holds the bumper cover on. Pull the top corner of the bumper cover toward you to release the clips, one on each side, at the top corner, along the front of each fender well where the bumper cover meets the fender. The bumper cover can now be loosened along the top without entirely removing it. It just pulls forward. Inspect the underside of the bumper cover for broken clips and replace as necessary. Now remove the two bolts that hold down each headlight at the top. Disconnect the wiring and bulbs and wiggle the old headlights out. Install the new ones and reverse the process. If your AC isn't blowing cold, check the condenser for leaks before you reinstall the grille. A new aftermarket condenser/filter dryer is easy to install by removing the battery and tilting the radiator back to get the condenser out. A replacement only costs $75 and can be swapped out in one half hour with a few metric sockets. Then you will need to recharge the AC system with R-134a, which is easy. Just buy a R-134a kit with hose at Autozone and follow the directions. $50 Replacement fog lights are only $52/pair for aftermarket. You may consider replacing those as well. They have a strange installation with clips and you will need to pry/bop them forward, not remove them from the back. They are aggravating to replace but not technically difficult.

Apr 17, 2013 | 2003 Toyota Highlander

1 Answer

Rear bumper cover 2003 RAV 4 mounting problem


try the library for the manual its free

Aug 22, 2009 | 2003 Toyota RAV4

3 Answers

How do you replace the rear taillight assembly on a 2009 toyota


actually, you need to remove the bumper cover as solution 2 says, then there is one screw there that you take out. but then there are 2 nuts that you have to access from inside - which they want you to take the whole interior of the truck apart to access. i have the same issue, except it was my husband who backed into our minivan,and i'm not sure what i'm going to do. if you take off the access panel, you'll see that it looks like you could almost get those nuts off if you had the right tool - a very narrow long socket and socket extender to fit in the access holes. i'll let you know if i'm able to do it or not.

Aug 14, 2009 | 2009 Toyota Highlander

2 Answers

Does anyone know how to replace an Echo Rear Bumper?


Look inside the trunk you will find the bolts under some groomets, get under rear fenders and remove the plasitc covers and remove the bolts for the sides and you will remove it.

Jul 09, 2009 | 2004 Toyota ECHO

1 Answer

Need to remove rear bumper cover from a 2009 Toyota Corolla


paint it on the car or simply remove all the bolts and screws.  Duh

Mar 15, 2009 | 2009 Toyota Corolla

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

294 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...