Question about 2003 Volvo V70

Open Question

Volvo d5 injector removal

Cant get 3 injectors out

Posted by Anonymous on


5 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 36 Answers

SOURCE: Volvo se D5.Estate 2004 year .

press and hold button below speedo immediately switch ignition on Keep button depressed until service message has been reset release reset button within 4 seconds there will be an audible signal when reset complete if reset button is not released within 4 seconds then the service interval indicator will not be reset.

Good Luck

Posted on Sep 06, 2008

  • 22326 Answers

SOURCE: Need to change/tighten injectors and/or Conn

get your tools out and follow your nose,these engines are bullet proof and easly repaired.dont forget to renew the the thin leak off pipes while your at it

Posted on Mar 20, 2009

  • 1 Answer

SOURCE: Make is a volvo s60 D5, with a fault code 075 it

Volvo s80, 2004 ,.2.4 petrol. I have codes 042,058,075.This big problem? Thanks Ana

Posted on May 28, 2010

  • 66 Answers

SOURCE: I am unable to remove

Hi there?
If they got carbon deposit bult up round the injector, it helps to sock it in cocacola. Yeah i know weird but it does the trick.
If there is no such thing then try twisting them left and right and eventually it will give up, you may need to use a hamer........
Good luck.........

Posted on May 24, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Cant locate injector pump timing marks on my mazda 323 single cam

dont know that pump myself
mazda D5 engine ?
belt driven pump
picture any help



Apr 27, 2017 | Mazda Cars & Trucks

1 Answer

Why dose my 2002 Volvo xc90 d5 not start in the mornings

I have similar problem different vehicle, my ignition was not connecting well and the glow plugs were not initially getting properly hot, not sure how to fix it/ I disconnected the battery entirely and unplugged what I could and switched # 1 for #3 plug and waited overnight and charged the battery out of the truck, next day put all back and attached battery and started right up right since , so try take out battery and charge better first.

Sep 16, 2016 | Volvo XC90 Cars & Trucks

1 Answer

Injector stays open when it should be shut. We have a 08 Volvo 780 D12 . We have replaced the Egrs, injectors, cups, egr temp sensor. They rebooted the ECM. I'm thinking the Injector Wiring Harness.

The injector ground circuit has to be shorted to ground, only two things cause this, the wire to the injector from the ECM is damaged and grounded or the ECM injector driver circuit is shorted out.

Jul 01, 2016 | Volvo Cars & Trucks

1 Answer

Volvo v70,had to replace d5 engine and now will only start by spraying with diesel

without my head under the bonnet here iam at a loss as its about this time that common rail was introduced so i could write two seperate and completely different answers ,check the temperature sensors thik their is two of them for the engine gauge and the fan ,also the heater timer/relay as either way i think its not injecting enough fuel when cold ,also it may pay to fit a non return valve in the inlet line to stop the fuel from running back when stopped ,yes i know its a bodge answer but if a fuel pump its 600 euros to change the valve in the pump .but agn i would need to know what type of injection system is used

Apr 25, 2012 | Volvo V70 Cars & Trucks

1 Answer

D5 low end torque & power problems

U have a vacuum leak causing your headache

Mar 30, 2017 | 2004 Volvo V70

1 Answer

I am unable to remove the injectors from a Volvo Penta diesel 3 cylinder engine (2003).can you suggest anything. Thank you.

Hi there?
If they got carbon deposit bult up round the injector, it helps to sock it in cocacola. Yeah i know weird but it does the trick.
If there is no such thing then try twisting them left and right and eventually it will give up, you may need to use a hamer........
Good luck.........

May 24, 2011 | Volvo 240 Cars & Trucks

1 Answer

Hi there, I`ve got a problem with cold start my Volvo, MY 2003, D5, 2.4 Turbo Diesel. After overnight parking, outside temp. is 10C or less engine wont start - when I`m warming up temp. sensor by...

Sounds like a faulty injector, had the same problem about 2 years ago cost over £1500 to have new injectors fitted.

It might be worth trying some redex or similar cleaning product incase its just blocked.

Dec 04, 2010 | Volvo V70 Cars & Trucks

2 Answers

Clinder 3 misfiring

well you will have to remove the whole fuel rail at the same time there should only be two or four bolts that holds it in place remove all bolts and gentally use pry bar to pop injectors up out of holes

Aug 18, 2009 | 2001 Volkswagen Passat

2 Answers

S80 Difficult to start

Change the fuel filter. If pump is new, and you are not leaking gas from lines, than either the filter is clogged, injector stuck open

Jun 22, 2009 | 2002 Volvo S80

Not finding what you are looking for?
2003 Volvo V70 Logo

Related Topics:

264 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts


Level 3 Expert

78919 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides