Question about 2004 Hyundai Santa Fe

Open Question

Diagnostic code P0340 2004 hyundai santa fe - 2004 Hyundai Santa Fe

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Fog Light Replacement Hyundai Santa Fe

The above statement is GREAT!!! The wheel-well piece folds down across the area you need to be in. There are 2 screws to undo this part. Push it back and there is a cap that unscrews which holds the wires and socket he is talking about. Unscrew the cap, unscrew the wire and housing. The bulb comes out. You pull the wire harness off and install the new bulb. It has a triangular push-in and it has to go just right so take note of how it comes out. Also, being a halogen light bulb, do not touch the bulb with your hands - the oils will make it explode.

Posted on Apr 06, 2009

  • 6 Answers

SOURCE: how to change spark plugs on hyundai 2004 2.4L

Remove the plastic cover that goes over the engine (the one with the Hyundai logo).
At this point, you will see the cables that goe to each fo the spark plugs.
Noting their position, remove them.
The spark plugs are ready to be removed, turn counterclockwise and replace with manufacturer recomended ones.

Posted on May 16, 2009

emissionwiz
  • 75005 Answers

SOURCE: PROGRAM KEYFOB FOR HYUNDAI SANTA FE

This is from the factory service manual of your car:
There is no onboard programming procedure for this vehicle. This vehicle requires special equipment be connected to the vehicle to program the keyless remote. Translation you need the dealer to do this.

Posted on May 22, 2009

e-Guru
  • 3917 Answers

SOURCE: How to change fuel filter in 2004 Hyundai Santa Fe

Hi,

Please follow the steps to change the fuel filter. You would need to remove the left rear seat (four 14mm bolts). I think you'll need to finish cutting through the tabs on the carpet to be able to lift up the carpet. Then remove the access cover. You can then remove the fuel pump from the top of the tank.

Thank you for contacting Fixya.com

Posted on Jul 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2001 Hyundai Santa Fe cranks but won't start. Diagnostic tester reads, ' Err ' key not detected.. Key is in the ignition !! PLEASE HELP !!!


Engine cranks but won't start.What should I do. - YouTube

? 9:37
https://www.youtube.com/watch?v=jsQcLya1YLQ
Jan 24, 2014 - Uploaded by jimthecarguy
No Start Cranks Ok No Injection Pulse 2002 Hyundai Accent Easy Step By Step ... Jimmy, i strugle to start my trajet 2.5 v6 after installig new engine. ... type of hyundai accent 2002, the engine cranks, but It won't start, no spark, ...

My engine cranks but won't start what should I do - YouTube

? 9:37
https://www.youtube.com/watch?v=ecLmYPcWipo
Feb 11, 2014 - Uploaded by jimthecarguy
2002 Hyundai Accent No Start ,Cranks Ok Spark OK ,No Injection Pulse My car will not start what should
About 1,770 results (0.59 seconds) Search ResultsHyundai Santa Fe Electrical Problems - Edmunds.comforums.edmunds.com > Hyundai > Hyundai Santa FeMay 8, 2007 - 31 posts - ‎24 authorsLearn more about Hyundai Santa Fe at the Edmunds.com Car Forums! ... and whether it left an error code on the computer when I next take it to the shop. ... My Hundai Sante Fe 2002 has been having strange electrical issues ... It does not have a remote starter but does have an alarm and electonic key."No Start" Due to Drive Authorization's Failure to ... - RepairPalrepairpal.com > Problems > Mercedes-Benz > ML350In many cases, a new module and keys will be needed to correct this ... Chrysler, Dodge, FIAT, Ford, Geo, GMC, Honda, Hummer, Hyundai, Infiniti, Isuzu ... my 2005 mercedes benz ml350 would not start, it telling me star error. ... Says key not detected, I changed batteries. .... Mercedes-Benz Repair in Santa Fe Springs, CA.Missing: 2001 ‎errHow do you start the car with the key in the console slot ...www.hyundai-forums.com/.../149516-how-do-you-start-car-key-console...Oct 5, 2012 - 10 posts - ‎7 authorsI had an incident yesterday where the car did not seem to detect my key. When I pushed the ... The manual says if the battery is weak to insert the smart key into the center console slot to start the car. Well ... 2013 Sonata Limited 2.4L 2011 Santa FeGLS 2.4L 2001 Santa Fe GLS 2.7L .... HTML code is Off.Missing: error ‎errdb:: 4.99::Blue screen Error FE 9p

Jan 24, 2016 | Hyundai Cars & Trucks

1 Answer

2005 hyundai santa fe


This code refers to a misfire on cyl#5. Possible spark plug or ignition coil ( most common ). Could also be an injector or wiring to any of the above

Jul 12, 2015 | 2004 Hyundai Santa Fe

1 Answer

Where is the diagnostic tool connection on 2002 hyundai santa fe?


most connections for the scanning tool. are under dash on drivers side, under steering wheel. good-day !

Nov 06, 2011 | 2002 Hyundai Santa Fe

1 Answer

Had the battery of 2004 santa fe replaced now the malfunction light won't go off.


Whenever the "Check Engine" light comes on, there is always a DTC (Diagnostic Trouble Code) stored in the ECM (Engine Control Module). You'll need an OBDII (On-Board-Diagnostics) scanner to retrieve any codes recorded/set in ECM. Once you do this and let us know what, if any codes are set, then we can go from there.

Jun 26, 2009 | 2004 Hyundai Santa Fe

1 Answer

I have a 04' hyundai santa fe, it has 46k miles, it has been cutting off while driving and starts to **** before it cuts off, i have taken it to a mechainc and they said it was the battery i have switched...


Yeah!.. I have NUMEROUS ideas! Does the Check Engine light come ON when this happens? Whenever the "Check Engine" light comes on, there is always a DTC (Diagnostic Trouble Code) stored in the ECM (Engine Control Module). You'll need an OBDII (On-Board-Diagnostics) scanner to retrieve any codes recorded/set in ECM. Once you do this and let us know what, if any codes are set, then we can go from there.

Jun 16, 2009 | 2004 Hyundai Santa Fe

1 Answer

2004 hyundia santa fe had a clicking noise by the power steering pump then later at a red light stopped running and wont start. all gauges showed no indication of anything wrong


Does the Check Engine light come ON when this happens? Whenever the "Check Engine" light comes on, there is always a DTC (Diagnostic Trouble Code) stored in the ECM (Engine Control Module). You'll need an OBDII (On-Board-Diagnostics) scanner to retrieve any codes recorded/set in ECM. Once you do this and let us know what, if any codes are set, then we can go from there.

Jun 14, 2009 | 2004 Hyundai Santa Fe

1 Answer

Cheak engine


Don't understand your question. Do you mean CHECK ENGINE LIGHT? If so, then there's one or more DTC's (Diagnostic Trouble Code) stored in the ECU (Engine Contro Unit). You'll need an OBDII (OBD = Onboard Diagnostics) scanner to retrieve any trouble codes. Find one (can be purchased at AutoZone, CarQuest, PEP Boys, O'Riley's, etc.) Let me know what codes are stored/set in the ECU. If you don't wish to do this, then take the veh to a Hyundai Service Center and pay their diagnostic fee. They'll give you an estimate of repairs (parts, labor, tax, time-frame, etc.). This way you'll know EXACTLY what the problem is and what's required to fix it.

May 31, 2009 | 2003 Hyundai Santa Fe

1 Answer

What is a 112 and a 444 code on my hyundai santa fe


Code PO 112 is intake air temperature circuit low input and PO 444 is Evaporative Emission control system purge contol valve circuit open. Both codes could be sensor problems or wiring problems.

Mar 11, 2009 | 2001 Hyundai Santa Fe

1 Answer

Problem with sante fe


sounds like you need a transmission, with those incorrect gear ratio codes

Feb 19, 2009 | 2003 Hyundai Santa Fe

Not finding what you are looking for?
2004 Hyundai Santa Fe Logo

Related Topics:

329 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...